MODU- - Blu Dot · MODU-HARDWARE LICIOUS ASSEMBLY INSTRUCTIONS Queen / Full Bed modular and...
Transcript of MODU- - Blu Dot · MODU-HARDWARE LICIOUS ASSEMBLY INSTRUCTIONS Queen / Full Bed modular and...
WWW.BLUDOT.COM MODULICIOUS QUEEN-FULL BED rev02 - PAGE 1 OF 5
HARDWAREMODU-LICIOUSASSEMBLY INSTRUCTIONS
Queen / Full Bedmodular and sty
lish,
who knew?
CARE
PARTS LIST
A - End DrawerRib
F - Slat Support Rail H - DrawerI - Drawer
Slide J - Bed SlatsG - Footboard
B - Inner DrawerRib C - Back Panel D - Side Rail E - Headboard
x185002
x161611
x201608
x105013
x125001 x8
5010
x21612
x64010
x241023
x25016
x61211
x44005
Clean powder-coatedunits with a soft cloth or
sponge using a mild detergent, such as dish soap, and warm water. Wipe completely dry
with a soft cloth.
Clean with a slightly damp, soft cloth. To remove dirt and fingerprints, use a
quality cleaner formulated for wood furniture. Wipe completely dry with a soft
cloth in the direction of the wood grain.
x4
x1x2
x4x1
x6
x2x2
x12
x1
WWW.BLUDOT.COM MODULICIOUS QUEEN-FULL BED rev02 - PAGE 2 OF 5
32 541
Turn cam clockwise ½ turn
HOW TO USE CAM LOCK HARDWARE
Note direction of arrow on cam
Note direction of arrow on cam
WWW.BLUDOT.COM MODULICIOUS QUEEN-FULL BED rev02 - PAGE 3 OF 5
2
3 4
ASSEMBLE ONCARPET OR
PROTECTIVE MAT
1
x241023
First screw goes here
A A
x4
x2x2
front
both sides
back
Part A will have 2 panels with drawer
slides insalled on the front side only (left) and 2 panels with drawer slides
installed on the back side only (right).
Part B will have drawer slides insalled on both
the front and back sides.
Part A is thinner than
Part B
*
x85002
x45010
x45001
A
A
B
B
B
B
B
A
D
C
A
x81611
x34010
Repeat Steps 2 & 3 for opposite side drawer box
assembly.
*
5001
5010
5010
5001
top
topbottom
bottom
x44005
WWW.BLUDOT.COM MODULICIOUS QUEEN-FULL BED rev02 - PAGE 4 OF 5
5 6
7 8
x21612
Long bolts (#1612) are to be
used in conjunction with brass fasteners
(#5016).
x81608
x65013
x25002
x25001
x25016
x25013
x25002
x81608
x25001
x25013
x41608
WWW.BLUDOT.COM MODULICIOUS QUEEN-FULL BED rev02 - PAGE 5 OF 5
9
10
x61211
NOTES
To remove drawers pull lever up on the right side and push
down on the left side of the ball bearing
drawer slide.
Loosen the acornnuts, shift the drawer front into place and
ask a friend to hold the drawer front in place
while you re-tighten the nuts (but don’t over tighten)
Drawer fronts can be adjusted if drawer gaps
are inconsistent.