Modern Chemistry Chapter 15 Acid-Base Titration & pH.
-
Upload
roberta-lee -
Category
Documents
-
view
238 -
download
2
Transcript of Modern Chemistry Chapter 15 Acid-Base Titration & pH.
Modern Chemistry Chapter 15Acid-Base Titration & pH
Section 1
• self-ionization of water occurs when two water molecules produce a hydronium (H3O+) and a hydroxide (OH-) ion
2 H2O H3O+ + OH-
• The ionization constant (Kw) of water is: Kw = [H3O+] [OH-] = 1.0 x 10-14 M
Acidic, Basic, & Neutral
• IF [H3O+] > [OH-] then solution is acidic.
• IF [H3O+] < [OH-] then solution is basic.
• IF [H3O+] = [OH-] then solution is neutral.
Calculating [H3O+] & [OH-]
• Since the product of the hydronium and hydroxide ion concentrations is a constant, we can use the following formula to determine these concentrations.
[H3O+] [OH-] = 1.0 x 10-14 M
Use this formula to answer problems #1-4 on page 502 of the textbook.
The pH Scale
• The pH of a solution is defined as the negative of the common logarithm of the hydronium ion concentration, [H3O+].
pH = -log [H3O+]
• The pOH of a solution is defined as the negative of the common logarithm of the hydroxide ion concentration, [OH-].
pOH = -log [OH-]
pH & pOH
pH + pOH = 14 so14 – pH = pOH and 14 – pOH = pH
See figure 3 on page on page 503.See table 3 on page 504.See table 4 on page 504.
Do problem #1 on page 505.Do problems #1-4 on page 506.Do problems #1-4 on page 508.
Cross-Disciplinary Connection
• Read the Cross-Disciplinary Connection titled “Liming Streams” on page 510.
• Answer both questions at the end of the article.
Section 2Determining pH and Titrations
• acid-base indicators are compounds whose colors are sensitive to pH
• transition interval is the pH range over which an indicator changes color
• a pH meter determines the pH of a solution by measuring the voltage between two electrodes placed in a solution.
Titration
• titration is the controlled addition and measurement of the amount of a solution of a known concentration required to react completely with a measured amount of solution of an unknown concentration
• equivalence point is the point at which the two solutions used in a titration are present in chemically equivalent amounts
• endpoint is the point in a titration at which the indicator changes color
• standard solution is the solution that contains a precisely known concentration of solute
Titration
• see figure 10 on pages 518-519 for the steps of a titration
• A general equation for the solution of titration problems would be
VaMaeqa = VbMbeqb
Va = volume of acid Vb = volume of baseMa = molarity of acid Mb = molarity of baseeqa = #H in formula of acid eqb = #OH in formula of base
Titration
• Do practice problems #1-2 on page 521.
• Do section review problems #1-2 on page 521.
• Do chapter review problems #6, 8, 9, 12, 13, 24, 25, & 26 on pages 523-524.
Modern Chemistry Chapter 15Test Review
• 25 multiple choice– definition of self-ionization– [H3O+] [OH-] = 1 x 10-14
– definition and formula for calculating pH = -log[H3O+]– pH >7 is a base; pH <7 is an acid; pH = 7 is neutral– pH range is normally 0 to 14– calculate pH from [H3O+] – calculate [H3O+] from pH– definitions of indicators, transition interval, titration,
neutralization, endpoint, standard solution– acid-base titration monitors pH– titration problems using VaMaeqa = VbMbeqb