MODEL N° 1270 OWNER’S MANUAL COPY...INSTRUCTION #1067168 D 10/21/2013 COPY 3 Most injuries are...

Keep this Product ID Number and use when contacting Customer Service:

OWNER’S MANUAL

MODEL N° 1270

COPY

2

Save this owner’s manual for future reference and in the event that the manufacturer has to be contacted.

REGISTER YOUR PRODUCT ONLINE AT WWW.LIFETIME.COM

At Lifetime, we are committed to providing innovative and quality products. While registering, you will

have the opportunity to give us your feedback. Your input is valuable to us.

Lifetime’s Promise to You:

REGISTER today!

**U.S. and Canada customers ONLY**

DO NOT CONTACT THE STORE!CALL OUR CUSTOMER SERVICE DEPARTMENT at

1 (800) 225-3865

Questions or Missing Parts? ID:

INSTRUCTION #1067168 D 10/21/2013

COPY

3

Most injuries are caused by misuse and/or not following instructions. Use caution when using this product.

FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY OR PROPERTY

DAMAGE AND WILL VOID WARRANTY.

SAFETY INSTRUCTIONS

BEFORE BEGINNING ASSEMBLY

4

TOOLS AND PARTS REQUIRED FOR THIS ASSEMBLY

*Two adults required to

complete assembly*

Only adults should set up the product. Do not allow children

in the setup area until assembly is complete.

Adjustable Wrench

Phillips Screwdriver

Funnel

7/16” Wrench

Scrap Wood

Sand

Pliers

Rubber Mallet

1/2” Wrench

Water Hose

3/8” Socket Wrench

3/16” Allen Wrench

5

This area is located at the top,

left-hand corner of the page

and indicates which tools

and hardware are needed to

complete the assembly steps

on a page.

Note:!

Refer to the following areas throughout the instructions

to assist in the assembly process:

This area is usually located in the

bottom, left-hand corner of a step

and indicates that special attention

is needed to perform a particular

part of a step.

These areas are usually located in

the bottom, right-hand corner of a

step and indicate that damage to

the product or serious injury may

occur if the caution or warning is

not heeded. WARNING

ASSEMBLY GUIDES

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE

CAUTION

6

PARTS LISTID Item Description Qty

HARDWARE LISTID Item Description Qty

BCO Pole Assembly Hardware

BCQ Pole to Base Assembly Hardware

BCR Backboard to Pole Assembly Hardware

7

Parts shown at 10% of Actual Size

ALH

ALF

ALE

PARTS IDENTIFIER

AJJ

AJK

AJC

15 ”3/4 7”AJE

*Warning Sticker applied to side not shown

ALI

*Do not remove Top Pole from Middle Pole until instructed

ALX

AKZ

8


PARTS IDENTIFIER

AJI AJM

AYU

AMU

AEF

Part shown at 25% of Actual Size

CIH

Parts shown at Actual Size

AOX

9

HARDWARE IDENTIFIERPOLE ASSEMBLY HARDWARE [BCO]Hardware shown at Actual Size

ADSAAN

AYT

AOL ABD

ABN

BACKBOARD TO POLE ASSEMBLY HARDWARE [BCR]Hardware shown at Actual Size

POLE TO BASE ASSEMBLY HARDWARE [BCQ]Hardware shown at Actual Size

AAE

AAOBTS

ABD

CII

APG ABD

CCL

10

HARDWARE IDENTIFIER

BACKBOARD TO POLE ASSEMBLY HARDWARE (CONTINUED)Hardware shown at Actual Size

ADQ

APK

APN

AACABK

11

POLE ASSEMBLY

HARDWARE REQUIRED

PARTS REQUIRED

TOOLS REQUIRED

SEC

1


Phillips Screwdriver

Hardware shown at Actual Size

Scrap Wood

ALH

ALF

ALE

*Warning Sticker applied to side not shown

ADS

AAN AYT

AOL

ABD

AYU

*Do not remove Top Pole from Middle Pole until instructed

1/2" Wrench

CIH

Part shown at 25% of Actual Size Part shown at Actual Size

BCO

12


Top Pole (ALH) Middle Pole (ALF)SEC

1.1

Note: Make sure the crimped side of the Top Pole is on the same

side as the Warning Sticker (AMT) on the Middle Pole.!

ALH

Warning

Sticker

ALF

NO TOOLS OR HARDWARE REQUIRED FOR THIS PAGE

13


Top Pole (ALH) Middle Pole (ALF)SEC

1.2

1/2”

AAN

AOL

ABD

WARNING

ALH

ALF

AOLABD

AAN

14


Middle Pole (ALF) Bottom Pole (ALE)

1/4” x 3/4” Screw (ADS)

Domed Countersink Washer (CIH)

SEC

1.4

ADS

Note: The 1/4” x 3/4” Screw should be fl ush with the Pole, but will spin

freely once installed. Do not jam the Poles together until instructed.!

ALE

ADS

ALE

ALFALF

SEC

1.3

CIH

15


Bottom Pole (ALE)

Middle Pole (ALF)

NO HARDWARE REQUIRED FOR THIS PAGE

Scrap Wood

ATTENTION: THIS STEP CANNOT BE REVERSED!

DO NOT COMPLETE ASSEMBLY.

Note: Do not hit your feet with the Pole sections,

as serious injury could occur.!

WARNINGThe Poles must be seated together! Even if the Poles cover

the slots before seating, they must be struck on a hard

surface fi ve to six times! Failure to seat the Poles correctly

could allow the Poles to separate during use, which could

lead to serious personal injuries or property damage.

ALE

ALF

ALH

SEC

1.4

SEC

1.4

16


SEC

1.55/16” Hex Nut (AYT) 5/16” Hex Knob (AYU)

5/16” x 3 1/4” Carriage Bolt (AOL)

Top Pole (ALH)

Middle Pole (ALF)

AYTAOL

NO TOOLS REQUIRED FOR THIS PAGE

ALH

ALF

AYUAOL

AYU

AYT

17

AJM

ALI

AJC

AMU

15 ”3/4 7”AJE



POLE TO BASE ASSEMBLY

HARDWARE REQUIRED

PARTS REQUIRED

TOOLS REQUIRED

SEC

2



ABN

AAE

AAO

BTS

ABD

1/2" Wrench

CII

CCL-3/16” Allen Wrench

BCQ

CCL (x2)3/16” Allen Wrench

18


ALI

AAE

ABDAJM

ABDAAO

AAE

ABDABN

AAO

NO TOOLS REQUIRED FOR THIS PAGE

Pole Brace (ALI) Base (AJM)SEC

2.1

Note: Repeat this step to install the other Pole Brace to

the other side of the Base.!

1/2” x 15 3/4” Axle (AJC) Wheels (AMU)

Bottom Pole (ALE) 1/2” x 7” Axle (AJE)

1/2” x 1/8” Spacers (ABN)

SEC

2.2

AJCABN

ABN

AMU

AMU

AJC

ALEAJE

19


Top Pole (ALH) 1/2” x 15 3/4” Axle (AJC)

Base (AJM)

1/2” x 7” Axle (AJE)

SEC

2.3

BTS

1/2"

CII

Pole Braces (ALI) Bottom Pole (ALE)SEC

2.4

Note: Tip the system forward so the Pole rests on the ground. Do not stand

the system up until it is fi lled with either sand or water later in the assembly.!

AJC

AJM

AJE AJM

BTS CII

ALE ALIALI

3/16"

20

BACKBOARD TO POLE ASSEMBLYSEC

3


HARDWARE REQUIRED

APG

AAC

ABDADQ

APK

ABK

APN

BCQ

21

BACKBOARD TO POLE ASSEMBLYSEC

3

PARTS REQUIRED

ALX



1/2” Wrench

TOOLS REQUIRED

AJI

AJJ

AJK

3/8” Socket Wrench

AOX


22


3 1/2” U-Bolt (APK) Left and Right Backboard Brackets (AJJ

& AJK)

Left and Right Backboard Brackets (AJJ & AJK) Top Pole (ALH)

SEC

3.1

SEC

3.2

1/2”

APK

AJJ

AJK

APKNotch

APK

APG

APN

AJJ

AJK

APG

APG

APNAPN

AJI

AJK

ALH

23


1/2”

Rim (ALX) Backboard (AJI)

Rim Support Channel (AOX)

3 1/2” U-Bolt

(APK)

5/16” Washers (ABD) 5/16” Nylock Flange Nuts (ABK)

SEC

3.3

5/16” x 3 1/4” Hex Bolts (AAC) 5/16” Washers (ABD)

5/16” Nylock Flange Nuts (ABK).

AAC

ABDABK

AOX

AAC AACABK

ABKABD

ABKABK

APK

AJI

ALX

ABD

24


Left and Right Backboard Brackets (AJJ & AJK)

Backboard (AJI)

SEC

3.4

ADQ

3/8”

ADQ

ADQ

AJI

AJJ AJK

25

FINAL ASSEMBLY

HARDWARE REQUIRED

PARTS REQUIRED

TOOLS REQUIRED

SEC

4


NO HARDWARE REQUIRED FOR THIS SECTION

AKZ

AEF

Funnel

Sand

Water Hose

Part shown at Actual Size

26



SEC

4.1

Two adults are required to complete assembly. To prevent serious injuries, the

Pole should be held down by one adult at all times while the Base is being fi lled.

OPTION A: FILLING WITH SAND

Base Plug (AEF) Base (AJM)

WARNINGFor safety reasons, we recommend that sand be used

instead of water to fi ll the Base. If a leak develops, water

could run out unnoticed, allowing the system to fall over,

resulting in serious personal injuries, or property damage.

If using Water, check the Base carefully for leaks. If a

leak is found, lay the system down on the ground and

call Customer Service. Do not use, stand up, or play on

a leaking system.

AEF

AJM

27


AEF

AJM


SEC

4.1

Two adults are required to complete assembly. To prevent serious injuries, the

Pole should be held down by one adult at all times while the Base is being fi lled.

OPTION B: FILLING WITH WATERBase Plug (AEF) Base (AJM)

28


SEC

4.2

ALX

AKZ

Net (AKZ) Rim (ALX)

Note: If a replacement Net is needed, please call our Customer Service Department.

Our Nets are shorter than average to reduce the risk of entanglement.!

NO TOOLS OR HARDWARE REQUIRED FOR THIS PAGE

29

To Raise or Lower the Hoop:

OPERATION OF HEIGHT ADJUSTMENT SYSTEM

WARNING:

CAUTION:

MOVING THE SYSTEM

30

IF RUST HAS PENETRATED THROUGH THE POLE ANYWHERE, REPLACE IT IMMEDIATELY!

POLE CARE AND SYSTEM MAINTENANCE

31

NOTES

32

NOTES

33

NOTES

34

ENHANCE YOUR LIFETIME® PURCHASE BY ADDING

ACCESSORIES OR OTHER GREAT PRODUCTS:

Or call: 1-800-424-3865

To purchase accessories or other Lifetime Products, visit us at:

www.lifetime.com

35

FAUTE DE NE PAS SUIVRE CES AVERTISSEMENTS, VOUS RISQUEZ DE CAUSER DES BLES-

SURES GRAVES ET/OU DES DOMMAGES À L’ÉQUIPEMENT.

SI NO SE OBEDECEN ESTAS ADVERTENCIAS PUEDEN PRODUCIRSE GRAVES LESIONES Y/O

DAÑOS A LA PROPIEDAD.

FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR

PROPERTY DAMAGE.

#FS16400 10/12/2004 www.lifetime.com

WARNING

ADVERTENCIA AVERTISSEMENT

36

LIFETIME BASKETBALL EQUIPMENT5-YEAR LIMITED FACTORY WARRANTY

THE MANUFACTURER RESERVES THE RIGHT TO MAKE SUBSTITUTIONS TO WARRANTY CLAIMS IF PARTS ARE

UNAVAILABLE OR OBSOLETE.

ALL WARRANTY CLAIMS MUST BE ACCOMPANIED BY A SALES RECEIPT.

REPORT PRODUCT DEFECTS IN WRITING TO:

To register the product, visit our Web site at www.lifetime.com

WARRANTY INFORMATION

www.lifetime.com

MODEL N° 1270 OWNER’S MANUAL COPY...INSTRUCTION #1067168 D 10/21/2013 COPY 3 Most injuries are...

Documents

Transcript of MODEL N° 1270 OWNER’S MANUAL COPY...INSTRUCTION #1067168 D 10/21/2013 COPY 3 Most injuries are...