Model Editing (Continued)

Copy & PasteCopy & Paste Special (Transformation)Copy & Paste Special (Rotation)Scale ModelFill PatternCurve PatternTable PatternReference Pattern

Copy & Paste

Copy & Paste: Click on the object you want to copy -> Click on Copy -> Click on Paste -> Placement -> Edit -> Select the place (e.g. “Upper Surface”) -> Sketch -> move the curser to the place you want to paste ->Done

Copy & Paste Special(Transformation)

Copy & Paste Special: Click on the object you want to copy -> Click on Copy -> Click on Paste Special -> Check Move/Rotate transformations to copies -> OK -> Click on Transformations -> Select a edge -> Using mouse drag to determine the position of the object or give the dimension for the distance to the original oneTransformation in 2nd direction: Click on Transformations -> select New Move -> select the 2nd edge -> Using mouse drag to determine the position of the object or give the dimension for the distance to the original one

Copy & Paste Special(Rotate)

Copy & Paste Special: Click on the object you want to copy -> Click on Copy -> Click on Paste Special -> Check Move/Rotate transformations to copies -> OK -> Click on Rotate-> Select a rotating axis -> Using mouse drag to determine the position of the object -> give angle between the copy and the original one. the dimension for the distance to the original one

Scale Model

Scale Model: Click on the object you want to scale -> Edit -> Scale Model -> Enter the scale -> Done -> Yes

Fill Pattern

Fill Pattern: Click on the object you want to copy -> Click on Pattern -> Select fill -> Click on reference -> define -> Select the plane to sketch -> sketch -> draw the closed the area ->Done

Curve Pattern

Fill Pattern: Click on the object you want to copy -> Click on Pattern -> Select Curve -> Click on reference -> define -> Select the plane to sketch -> sketch -> draw the curve ->Done

Note: the start point needs to be determined

Table Pattern

Fill Pattern: Click on the object you want to copy -> Click on Pattern -> Select Table -> Select the dimensions about the object -> Create the table -> Save -> Exit (Don’t use Quit)

Reference Pattern

Reference Pattern: Click on the object you want to copy -> Click on Pattern -> Select Reference -> Done