Minimum weight design by GENOPT/BIGBOSOR4 of an externally pressurized circumferentially corrugated cylindrical shell and verification by STAGS David Bushnell, retired 775 Northampton Drive, Palo Alto, CA January 2015 Summary What is GENOPT? What is BIGBOSOR4? Geometry, decision variables Behaviors that constrain the design during optimization cycles The objective: WEIGHT Optimization via SUPEROPT Smoothing segments Nonlinear axisymmetric pre-buckling behavior Local bifurcation buckling from BIGBOSOR4 and STAGS General bifurcation buckling from BIGBOSOR4 and STAGS Extreme sensitivity of an optimized design to perturbations Conclusions GENOPT is used in combination with BIGBOSOR4. Optimization is performed with GENOPT/BIGBOSOR4/ADS. The optimizer is ADS, a gradient- based optimizer written by Vanderplaats and his colleagues in the 1980s What is BIGBOSOR4? Stress, buckling and vibration of elastic shells of revolution (BIGBOSOR4=BOSOR4 with more shell segments permitted, up to 295 shell segments as of 2011). Nonlinear axisymmetric stress analysis Linear non-axisymmetric stress analysis Axisymmetric or non-axisymmetric bifurcation buckling Linear vibration modes of axisymmetrically loaded shell Multi-segment, branched, ring-stiffened shells of revolution Various wall constructions BIGBOSOR4 cannot handle local shell segment transverse shear deformation (t.s.d.) or local shell wall anisotropy or bifurcation buckling with applied in-plane shear loading. Use a factor of safety to compensate for these effects on local buckling. Last years paper: longitudinally corrugated prismatic panels This years paper: circumferentially corrugated shells Decision variables in last years format Decision variables in this years format The circumferentially corrugated shell of revolution is optimized subject to the following behavioral constraints: Local buckling that is symmetric about the symmetry plane at X = WIDTH/2 General buckling that is symmetric about the symmetry plane at X = WIDTH/2. General buckling that is anti-symmetric about the symmetry plane at X = WIDTH/2. Maximum allowable stress The objective is: Objective= WEIGHT (lb) of the entire panel of WIDTH = X inches Optimization via the GENOPT command SUPEROPT in order to find a global optimum design Difficulties optimizing when nonlinear theory is used in BIGBOSOR4: BIGBOSOR4 quits. Smoothing segments are used to eliminate corners, as was done last year Nonlinear axisymmetric pre-buckling deformation under uniform external lateral normal pressure (no pr/2 axial loading!) Pressure-end-displacement curves for the nonlinear axisymmetric pre-buckling state Nonlinear local buckling from the BIGBOSOR4 model of the nonlinearly optimized mich8 configuration Nonlinear local buckling from the STAGS model of the nonlinearly optimized mich8 configuration Nonlinear general buckling from the BIGBOSOR4 model of the nonlinearly optimized mich8 configuration Nonlinear general buckling from the STAGS model of the nonlinearly optimized mich8 configuration Comparison of predictions from BIGBOSOR4 and STAGS for linearly and nonlinearly optimized mich8 configurations Design sensitivity of linearly optimized mich8 configuration mich8 also buckles under INTERNAL pressure Conclusions Global optimum designs are difficult to find because of extreme design sensitivity and because of certain difficulties with nonlinear bifurcation buckling calculations in connection with optimization. BIGBOSOR4 and STAGS predictions agree very well for linearly optimized configurations. BIGBOSOR4 and STAGS predictions differ somewhat for nonlinearly optimized configurations. Nonlinear effects are significant for optimized designs in the cases treated here.