MILK PASTEURIZER

MILK PASTEURIZER

One milk pasteuriser with a capacity of 300 -400 litres of milk for hours, HTST type with an operate range from 75° to 95°C, including milk receiving tank of 100 litres with level control. The pasteuriser is complete with flow meter on the milk to be pasteurised . The flow milk indicates both the flow rate and the pumped volume on a remote digital display. Milk pump centrifugal pump of 2 Hp , in line stainless steel filter and flow gauge , precise flow control valve and out let temperature control valve, three cell heat exchanger for regeneration , heating and cooling. Air actuated 20 second holding tube , plus additional tubes allowing an holding time up to two minutes. Hot water system with centrifugal water pumpElectronic controller with thermostat for milk and water temperature , control panel with electronics thermostat control and illuminated control switches temperature recorder of milk pasteurisation and cooling temperature. The unit is mounted on a stainless steel platform equipped with wheels and necessary milk hoses of 5 meters each length.Power consumption 20 Kw – 30-40 Amps 400 V three phasesAir compressed consumed 30 nl/min at 5 bar.The pasteurisation unit has a capacity of 300- 400 able to perform the following thermal cycle Fresh milk 4-50-75 ( 95) -4°C – holding time 20- 120 seccomposed by:* 100 litres buffer tank for milk storage Made in AISI 304 stainless steel, with the following characteristics:- AISI 304 stainless steel tank, with glazed and pickled inside and outside surface- Pickled, flattened, grounded and spotted welding- Conical bottom with total discharge- Plate cover with CIP (cleaning in place) devices.- Total discharging piping, manufactured in stainless steel- three legs supporting structure manufactured in stainless steel- level probeCentrifugal pump with sanitary close impeller manufactured in stainless steel aisi 304 , connection DN 25. Capacity 400 lt/h complete with valve to adjust the capacityInstalled power: 1,5 KwMilk strainer- line filter manufactured in stainless steel aisi 304 with connection with centrifugal pump. The filter will be placed on a frame in stainless steel, it is easy to clean and to open for maintenance. The cartridge is manufactured in stainless steel with hole of 0, 5 mm or different on request. DIN connection* Plate pasteuriserPlate pasteuriser designed for the treatment milk see above the cycles:The machine is composed of:3 sections plate pasteuriser with a capacity of 300 Lt/h of productheating section from 4°C to 50°C using product in counterflow pasteurisation section from 50 to 75 or 95 or with hot water - pre cooling product section from 75 or 95 to 29 or 49 °C with product in counterflow (heating recovery system)Cooling section from 49 or 29 to 4°C with chilled water at +2°C.

The exchanger is composed of:Plates in stainless steel AISI 316 and nitrile alimentary rubber joints- Intermediate plates in stainless steel AISI 304- Frame covered in stainless steel AISI 304 with closing lateral tie rod- Pipe connections for various fluids in stainless steel- Thermal holding system for 20 or 120 seconds with multiple pipes. The pipes are connected in serial with detachable turns and mounted on a supporting frame in stainless steel.- Hot water at 97°C or different temperature adjustable group formed by a pneumatic valve, pipes, and manual valve, tank with 20 Kw electrical resistances, hot water pump, safety valve.Chilled water at +2°C adjustable group formed by a pneumatic valve, pipes, and manual valve.- Instruments to record the pasteurising and the exit temperature - System to adjust the thermal fluid temperatures- 3 ways valve to divert the product in case of low temperature- Necessary electro pneumatical transducers- PT 100 probes for temperature measurements- Air reducing equipment for compressed air- Electrical control board with temperature indication, control and record on paperConsumption’s:Electrical Power: 22 kWWater: 1,0 m3/h equal to 18.000 Kcal.Compressed air: 40 NLP / minute at 5 bar

TECMON S.R.L. P.IVA 00791710965VIA LEONARDO DA VINCI, 11/B COD.FISC. 0482120015320060 CASSINA DE’ PECCHI (MI)TEL. +39 0295299106 CAP. SOC. € 83.000,00 INT. VERS.FAX +39 0295299315 ISCR. TRIB. DI MONZA REG. SOC. 17929E-MAIL : tecmon@tin.it C.C.I.A.A. MONZA E BRIANZA 1041916E-MAIL : info@tecmon.ithttp:// www.tecmon.it