Metamorphism – changes in mineralogy and texture brought about by perturbations in heat and...
-
Upload
zoie-smoak -
Category
Documents
-
view
218 -
download
2
Transcript of Metamorphism – changes in mineralogy and texture brought about by perturbations in heat and...
Metamorphism – changes in mineralogy and texturebrought about by perturbations in heat and pressure
Compositional changes are generally restricted to thoserelated to devolatilization
Metamorphism involves the recrystallization of a rock
Metasomatism involves mass transfer, not just devolatilization ; commonly, introduced fluids carry elemental constituents that react with minerals to formnew minerals. These fluid may be of various origins, butoften they are derived from magmas (which crystallize asigneous plutonic rocks) which are also supplying heat.
Types of metamorphism
• Contact – high T, low P• Hydrothermal – involving a fluid; often referred to as
hydrothermal alteration
• Regional – high T, can be high P• Burial – a continuation of diagenesis; related to burial in
a sedimentary basin without active tectonism or plutonism
T – P ranges are 100-800 OC and 1 bar(105Pa) to 10 kb (109 Pa)
Figure 22-1. Examples of foliated metamorphic rocks. a. Slate. b. Phyllite. Note the difference in reflectance on the foliation surfaces between a and b: phyllite is characterized by a satiny sheen. Winter (2001) An Introduction to Igneous and Metamorphic Petrology. Prentice Hall.
aa
bb
Slate: compact, very fine-grained, metamorphic rock with a well-developed cleavage. Freshly cleaved surfaces are dull
Phyllite: a rock with a schistosity in which very fine phyllosilicates (sericite/phengite and/or chlorite), although rarely coarse enough to see unaided, impart a silky sheen to the foliation surface. Phyllites with both a foliation and lineation are very common.
Chapter 22: FoliatedMetamorphic Rocks
Figure 22-1c. Garnet muscovite schist. Muscovite crystals are visible and silvery, garnets occur as large dark porphyroblasts. Winter (2001) An Introduction to Igneous and Metamorphic Petrology. Prentice Hall.
Schist: a metamorphic rock exhibiting a schistosity. By this definition schist is a broad term, and slates and phyllites are also types of schists. In common usage, schists are restricted to those metamorphic rocks in which the foliated minerals are coarse enough to see easily in hand specimen.
Chapter 22: FoliatedMetamorphic Rocks
Additional Modifying Terms:
Porphyroblastic means that a metamorphic rock has one or more metamorphic minerals that grew much larger than the others. Each individual crystal is a porphyroblast
Some porphyroblasts, particularly in low-grade contact metamorphism, occur as ovoid “spots”
If such spots occur in a hornfels or a phyllite (typically as a contact metamorphic overprint over a regionally developed phyllite), the terms spotted hornfels, or spotted phyllite would be appropriate.
Chapter 22: A Classification of Metamorphic Rocks
Figure 23-14b. Spotted Phyllite. Winter (2001) An Introduction to Igneous and Metamorphic Petrology. Prentice Hall.
Chapter 22: A Classification of Metamorphic Rocks
Figure 22-1d. Quartzo-feldspathic gneiss with obvious layering. Winter (2001) An Introduction to Igneous and Metamorphic Petrology. Prentice Hall.
Gneiss: a metamorphic rock displaying gneissose structure. Gneisses are typically layered (also called banded), generally with alternating felsic and darker mineral layers. Gneisses may also be lineated, but must also show segregations of felsic-mineral-rich and dark-mineral-rich concentrations.
Chapter 22: FoliatedMetamorphic Rocks
Marble: a metamorphic rock composed predominantly of calcite or dolomite. The protolith is typically limestone or dolostone.
Quartzite: a metamorphic rock composed predominantly of quartz. The protolith is typically sandstone. Some confusion may result from the use of this term in sedimentary petrology for a pure quartz sandstone.
Chapter 22: SpecificMetamorphic Rock Types
Simpler than for foliated rocks
Again, this discussion and classification applies only to rocks that are not produced by high-strain metamorphism
Granofels: a comprehensive term for any isotropic rock (a rock with no preferred orientation)
Hornfels is a type of granofels that is typically very fine-grained and compact, and occurs in contact aureoles. Hornfelses are tough, and tend to splinter when broken.
Chapter 22: Non-FoliatedMetamorphic Rocks
Skarn: a contact metamorphosed and silica metasomatized carbonate rock containing calc-silicate minerals, such as grossular, epidote, tremolite, vesuvianite, etc. Tactite is a synonym.
Granulite: a high grade rock of pelitic, mafic, or quartzo-feldspathic parentage that is predominantly composed of OH-free minerals. Muscovite is absent and plagioclase and orthopyroxene are common.
Chapter 22: SpecificMetamorphic Rock Types
Greenschist/Greenstone: a low-grade metamorphic rock that typically contains chlorite, actinolite, epidote, and albite. Note that the first three minerals are green, which imparts the color to the rock. Such a rock is called greenschist if foliated, and greenstone if not. The protolith is either a mafic igneous rock or graywacke.
Amphibolite: a metamorphic rock dominated by hornblende + plagioclase. Amphibolites may be foliated or non-foliated. The protolith is either a mafic igneous rock or graywacke.
Chapter 22: SpecificMetamorphic Rock Types
Serpentinite: an ultramafic rock metamorphosed at low grade, so that it contains mostly serpentine.
Blueschist: a blue amphibole-bearing metamorphosed mafic igneous rock or mafic graywacke. This term is so commonly applied to such rocks that it is even applied to non-schistose rocks.
Eclogite: a green and red metamorphic rock that contains clinopyroxene and garnet (omphacite + pyrope). The protolith is typically basaltic.
Chapter 22: SpecificMetamorphic Rock Types
Migmatite: a composite silicate rock that is heterogeneous on the 1-10 cm scale, commonly having a dark gneissic matrix (melanosome) and lighter felsic portions (leucosome). Migmatites may appear layered, or the leucosomes may occur as pods or form a network of cross-cutting veins.
Chapter 22: SpecificMetamorphic Rock Types
The aluminium silicates : kyanite, andalusite and sillimanite Al2SiO5
Al2SiO5 ???? Why this formula for a silicate with isolated tetrahedra?
Could be written Al.AlO(SiO4) because there are two different Al structural sites as well as isolated [SiO4] tetrahedra.
They also have been considered as belonging to a separate silicate subclass – subsaturates, because there are conceptually too few oxygens, a naïve viewpoint.
Kyanite, andalusite and sillimanite are polymorphs, because they have the same chemical composition but can exist with different crystal structures.
The crystal structures of the Al2SiO5 polymorphs
All three structures have straight chains of edge-sharing AlO6 octahedra along the c axis.
These chains contain half of the Al in the structural formula.
In kyanite the remaining Al atoms are in 6-fold coordination (octahedra)
In andalusite the remaining Al atoms are in 5-fold coordination
In sillimanite the remaining Al atoms are in 4-fold coordination (tetrahedra)
Density: kyanite > sillimanite > andalusite
Therefore kyanite is stable at the highest pressures and lowest temperatures, while sillimanite is stable at high temperatures and lower pressures
The crystal structures of the Al2SiO5 polymorphs
All three structures have straight chains of edge-sharing AlO6 octahedra along the c axis
The structure of kyanite
1. The AlO6 octahedral chains 2. Add the other Al polyhedra
3. Add the [SiO4] tetrahedra
The structure of sillimanite
1. The AlO6 octahedral chains 2. Add the other Al polyhedra3. Add the [SiO4] tetrahedra
The stability of the Al2SiO5 polymorphs
aaa
kyanite sillimanite
andalusite
(b)Temperature (oC)
200 400 600 800
2
4
6
8
10P
ress
ure
(kba
r)
The Al2SiO5 polymorphs form in metamorphic rocks
3.55-3.66
3.16-3.20
3.23
The Metamorphic Facies Concept
• If P-T conditions were the same, different mineral assemblages must represent different starting compositions (i.e. different protoliths)
• If the starting compositions are identical, then different mineral assemblages must represent metamorphism under different
physical conditions
Garnet compositions
Solid solutions within each group are typical.
At high T (above 700oC) there is also solid solution between the 2 groups.
Note: Solid solutions are always more extensive at higher Temperatures
Grandite group Grossular Ca3Al2(SiO4)3
Andradite Ca3Fe3+2(SiO4)3
Uvarovite Ca3Cr2(SiO4)3
Pyralspite group Pyrope Mg3Al2(SiO4)3
Almandine Fe2+3Al2(SiO4)3
Spessartine Mn3Al2(SiO4)3
The garnet minerals
Garnets: A large group of cubic minerals with general formula
A32+B2
3+(SiO4)3
A – Ca2+, Mg2+, Fe2+ or Mn2+
B – Al3+,Fe3+ or Cr3+
There are also many other synthetic compositions possible
Metamorphic facies
• High P/T series: subduction zones
• Medium P/T series: regional met.
• Low P/T series: contact met.