Effect of Ocular Deviation on Pupil size with Implanted Multifocal Intraocular Lens
Mechanical Drawing (MDP 115) - Fayoum Tolerences.pdf · •Nominal Size –general size, usually...
Transcript of Mechanical Drawing (MDP 115) - Fayoum Tolerences.pdf · •Nominal Size –general size, usually...
Mechanical Drawing(MDP 115)
FirstYear,
Mechanical Engineering Dept.,
Faculty of Engineering,
Fayoum University
Dr. Ahmed Salah Abou Taleb
FITS and TOLERANCES
2
Control Measurements ofFinished Parts
3
Indicating the Desired Dimension
4
Indication of the Real Dimension of Parts
Due to the inevitable inaccuracy of manufacturing methods, a partcannot be made precisely to a given dimension.
5
Indication of the Real Dimension of Parts
6
Indication of the Real Dimension of Parts
7
Selection of Waste Parts
8
Selection of Waste Parts
Waste results when the manufacturing process cannot
maintain size within prescribed limits.9
Selection of Acceptable Parts
10
Selection of Acceptable Parts
There is no such thing as an "exact size".11
Important Terms – Single Part
• Nominal Size – general size, usually expressed in
mms
• Actual Size – measured size of the finished part
• Limits – maximum and minimum sizes shown by
tolerances (larger value is the upper limit and the
smaller value is the lower limit)
• Tolerance – total allowable variance in dimensions
(upper limit – lower limit) – object dimension could
be as big as the upper limit or as small as the lower
limit or anywhere in between.
12
Tolerance
• How to decide tolerance?
– Functional requirements of mating parts
– Cost of production
– Available manufacturing process
• Choose as coarse tolerance as possible without compromising functional requirements
• Proper balance between cost and quality of parts
13
Characteristics of Tolerances
14
Characteristics of Tolerances
Connection btw the characteristics:
US = N + UD
LS = N – LD
T = US – LS = + 15
The Possible Positions of the Tolerance Zone
16
The ISO System of Limits and Fits (referred to as the ISO system) is covered in national standards throughout the world, as shown by the following list:
• Global ISO 286
• USA ANSI B4.2
• Japan JIS B0401
• Germany DIN 7160//61
• France NF E 02-100-122
• UK BSI 4500
• Italy UNI 6388
• Australia AS 1654
17
• The tolerance zone is above the zero (base)
line
18
• The tolerance zone is on the zero (base)
line
19
• The tolerance zone is under the zero (base)
line
20
Possible positions of the tolerance zone in case of shafts
Fundamental Deviation: is the deviation closest to the basic size.
ISO standard uses tolerance position letters with lowercase letters for the
shafts.
21
22
Possible positions of the tolerance zone in the case of holes
Fundamental Deviation: is the deviation closest to the basic size.
ISO standard uses tolerance position letters with capital letters for the holes.
23
24
H : lower deviation of
hole is zero
h : upper deviation of
shaft is zero
E.S. – upper deviation
E.I. – lower deviation
Representation of
Tolerance
1) Letter Symbol
The selection of letter freezes
one limit of hole / shaft
(how much away from Basic
size)
45 E8/e7Basic Size
One can have different
possible combinations; eg.
45H6g7, 45H8r6, 45E5p7
25
RANGE IN A GIVEN TOLERANCE GRADE
26
27
28
Representation of Tolerance
Tolerance Grade defines range of
dimensions (dimensional variation)
There are manufacturing
constraints on tolerance grade
chosen
29
2) Number or Grade IT01, IT0, IT1,….IT16
IT: International Tolerance30
• Example: A shaft of nominal diameter 25 mm is going to be manufactured. IT grade is required to be IT7.
• Determine the tolerance on the shaft.
31