ME02W-A16 Project Profile
Transcript of ME02W-A16 Project Profile
Project Team
11/12/2016 2
Project Co-Ordinator:
Asim Qamar
(Instructor-Mechanical)
Shahzad Ahmed (Instructor-Mechanical)
Project Team
11/12/2016 3
Project Executors
Students (ME02W-A16)
Muhammad Bilal Faizan Ahmed
Muhammad Imran Syed Fouzul Azeem Ghulam Hussain
Kaka Hafiz Nawab
Orangzaib Hafiz Muhammad
Owais Muhammad
Hammad Ali
Arsalan Rao Muhammad Rashid
Abbasi Muhammad
Siddique Muhammad
Shahroz
Khurram Naseer Adeel Umair Khan
Muhammad Faraz Muhammad
Manower
Project ME02W-A16Portable Bench Bender
11/12/2016 5
Bending Range
26 gauge 24 ga. 22 ga. 20 ga . 18 ga. 16 ga. 14 ga. 13 ga.
018" .024" .030" .036" .048" .060" .075" .090"
0.46mm 0.61mm 0.76mm 0.91mm 1.2mm 1.5mm 1.9mm 2.3mm
IntroductionThis Portable and Compact metal benders is able in standard straight bending or Box &Pan brake style. A sheet metal hand brake normally bends sheet metal by using a hingedclamping bar to hold the metal down against the bed. We used “C” clamp to hold a metal.
Basic Operation
Following are instructions on the primary uses of this Portable and Compact Bender.Additionally, information is included on the many ways to use this Portable andCompact Bender, along with specific examples. Becoming familiar with the Portable andCompact Bender and its many uses will allow you to make a variety of useful items.As the operator, you will have to decide on the way in which you will be using thisPortable and Compact Bender. The following are the basic steps you will need to takewhen working with the Portable and Compact Bender. Use an appropriate measuringdevice to measure and:
• Decide on material and measurements to be used.• Decide on the appropriate marking. Decide on the best placement (side) of the markingfor your particular bend.• Decide on the appropriate attachment, Stop Block or Right Angle Bend. Correctorientation of Stop Block.• Insert stock into the Bender and position it properly. Make the first bend.• Check the angle and direction of the bend.• Make all consequent bends. Adjust the work piece as needed.
Warning: Keep fingers and hands away from moving parts at all times.
Bending Range
Visitors Feed back
11/12/2016 22
Sr.#
Name &Company
Cell No.
Feedback
Sign.
01
02
03
04
05
06
07
08
09
10
11
Visitors Feed back
11/12/2016 23
Sr.#
Name &Company
Cell No.
Feedback
Sign.
12
13
14
15
16
17
18
19
20
21
22