MATLAB Power System & Power Electronics

SMART PRO TECHNOLOGIE

S

#2/494, 2ND Floor,AL Ghouse Plaza, Nagarajupet,

Kadapa

IEEE MATLAB SIMULATION & CODING

2012

1. A Novel STATCOM control scheme for grid connected wind driven

Induction Generator for Power Quality Improvement

2. Design and Analysis of Interleaved Boost Converter for Renewable Energy

Source

3. High-Power Bidirectional DC–DC Converter for Aerospace Applications

4. A Research on Cascade Five-level Aeronautical Active Power Filter

5. A Voltage-Controlled PFC Cuk Converter-Based PMBLDCM Drive for Air-

Conditioners

6. The study of H-bridge Cascaded Single-Phase Active Power Filter Based on

Instantaneous Reactive Power Theory

7. A Switched-Capacitor DC–DC Converter With High Voltage Gain and

Reduced Component Rating and Count

8. A New Multilevel Converter Topology With Reduced Number of Power

Electronic Components

9. A Novel Single Z-Source Based Multi Level Inverter for Renewable Source

10. Single-Stage Boost Inverter With Coupled Inductor

11. Novel High Step-Up DC–DC Converter With Coupled-Inductor and

Switched-Capacitor Techniques

12. Three-Phase to Seven-Phase Power Converting Transformer

13. A Low Cost Fly back CCM Inverter for AC Module Application

14. Three-Phase Hybrid Multilevel Inverter Based on Half-Bridge Modules

Ph: 08562 222 333, 98856 52333Email: [email protected]


S


Kadapa

15. A Control Strategy of Hybrid Active Filter to Compensate Unbalanced

Load in Three-Phase Three-Wire Power System

16. Multilevel Current Waveform Generation Using Inductor Cells and H-

Bridge Current-Source Inverter

17. Modified Staircase Modulation for Extending Unbalanced Loads Range of

Cascaded H-bridge

18. Consideration of CSI drive for SRM compared with VSI drive

19. A New Multilevel Converter Topology With Reduced Number of Power

Electronic Components

20. Design Considerations for DSP-Controlled 400 Hz Shunt Active Power

Filter in an Aircraft Power System

21. Design and Implementation of a New Multilevel Inverter Topology

22. Simulation and study on cascaded nineteen-level dynamic voltage restorer

23. Three-Phase Inverter Fed BLDC Motor Drive

24. An Improved Pulse Width Modulation Method for Chopper-Cell-Based

Modular Multilevel Converters

25. Analysis of a Bidirectional DC-DC Converter with Wide Voltage

Conversion Range

26. A Novel Single-Phase Five-Level Inverter With Coupled Inductors

27. A Unity Power Factor Control Method of PWM Rectifier

28. Design and Development of DC-DC Buck Converter for Photovoltaic

Application

29. High-Step-Up and High-Efficiency Fuel-Cell Power-Generation System

With Active-Clamp



S


Kadapa

30. Three-phase Three-level One-Cycle Controlled Bidirectional AC-to-DC

NPC Converter.

31. A New Control Method of Wind Energy in Power System.

32. Grid-Connected Three-Input PV/FC/Battery Power System with Active

Power Filter Capability.

33. Improvement of Power-Conversion Efficiency of a DC–DC Boost Converter Using a

Passive Snubber Circuit.

34. Analysis and Design of the Integrated Double Buck–Boost Converter as a High-Power-

Factor Driver for Power-LED Lamps.

35. Rotating-Sliding-Line-Based Sliding-Mode Control for Single-Phase UPS Inverters.

36. Analysis and Implementation of a Novel Bidirectional DC–DC Converter.

37. Flatness-Based Control of Three-Phase Inverter with Output LC Filter.

38. DC Link Active Power Filter for Three-Phase Diode Rectifier.

39. Analysis and Design of the L m C Resonant Converter for Low Output Current Ripple.

40. Design and Implementation of a ZCS-PWM Half-Bridge Boost Rectifier With Output

Voltage Balance Control.

41. New Efficient Bridgeless Cuk Rectifiers for PFC Applications.

42. PI and Sliding Mode Control of a Cuk Converter.

43. A ZVS Grid-Connected Three-Phase Inverter.

44. Battery Energy Storage for Enabling Integration of Distributed Solar Power Generation.

45. A Novel Integrated Magnetic Structure Based DC/DC Converter for Hybrid Battery/Ultra

capacitor Energy Storage Systems.

46. Analysis of Novel DC-DC Boost Converter topology using Transfer Function Approach.

47. PWM Based Sliding – mode Voltage Controllers for DC – DC Converter Applications.



S


Kadapa

2011

1. Control and Performance of a Cascaded Shunt Active Power Filter for

Aircraft Electric Power System

2. Three-Phase Dual-Buck Inverter With Unified Pulse width Modulation

3. A Five-level Inverter topology for Four Pole Induction Motor Drive with

single DC Link

4. A Switched-Capacitor Inverter Using Series/Parallel Conversion With

Inductive Load

5. Semi-Bridgeless Boost PFC Rectifier for Wide Voltage Input Range Based

on Voltage Feed-Forward Control

6. A Novel DC Voltage Control Method for STATCOM Based on Hybrid

Multilevel H-bridge Converter

7. Switching Pattern Selection scheme Based Cascaded Multilevel Inverter Fed

Induction Motor Drive

8. A New Schematic for Hybrid Active Power Filter controller

9. An Advanced Modulation Technique for the Cascaded Multilevel Inverter

Used As A Shunt Active Power Filter

10. A Novel High Step-Up DC–DC Converter for a Micro grid System

converter

11. A Three-Phase Unity Power Factor Single-Stage AC–DC Converter Based

on an Interleaved Fly back Topology

12. Three-Phase Soft-Switching Inverter With Minimum components

13. A New Nine-Level Active NPC (ANPC) Converter for Grid Connection of

Large Wind Turbines for Distributed generation



S


Kadapa

14. Non isolated Bidirectional Zero-Voltage-Switching DC–DC Converter

based Simulation of Custom Power Electronic Device D-STATCOM –A

Case Study

15. Design And Application Of A Novel Current Mode Controller On A

Multilevel STATCOM

16. Analysis and Design of a Cost Effective Converter for Switched Reluctance

Motor Drives Using Component Sharing

17. Voltage Sag Compensation of Point of Common Coupling (PCC) Using

Fault Current Limiter

18. Load Compensation for diesel generator based isolated generation a system

employing DSTATCOM

19. A Novel Power Converter of High Voltage Switched Reluctance Drive

20. Modeling, Analysis and Control of Various Types of Transformer less Grid

Connected PV Inverters

21. Cascaded multilevel inverter based active filter for power line conditioners

using Instantaneous Real Power Theory

22. Power Quality based Performance Analysis of a Dual Buck Converter Fed

Four-Quadrant DC Drive

23. Three-Phase Three-Level PWM DC–DC Converter

24.A Novel Three-Phase to Five-Phase Transformation.

25.A FACTS Device Distributed Power-Flow Controller (DPFC)

26.A Dynamic Voltage Restorer Equipped With a High-Frequency Isolated DC–

DC Converter.

27. A Novel Power Quality Compensator for Negativesequence and Harmonic

Currents in High-speed Electric Railway.

28. Nine level Cascaded H-bridge Multilevel DC-Link Inverter.



S


Kadapa

CODING BASED PROJECTS

1. Optimal Allocation of Distributed Generation in Distribution System for Loss Reduction.

2. Poisson Noise Removal From Images Using the Fast Discrete Curvelet Transform.

3. A Novel Approach for Image Retrieval Based on ROI and Multifeatures Using Genetic

Algorithm.

4. Simulation of transmission line configuration to determine corona losses.

5. Optimal Size and Location of Distributed Generations for Minimizing Power Losses in a

Primary Distribution Network.

6. Distributed Generator Placement and Sizing in Unbalanced Radial Distribution System.


MATLAB Power System & Power Electronics

Documents

Transcript of MATLAB Power System & Power Electronics