Manual RK1
-
Upload
carlos-bonatto -
Category
Documents
-
view
220 -
download
0
Transcript of Manual RK1
-
8/3/2019 Manual RK1
1/24
IR-PRO
Professio
nalInfraredC
odeCaptureS
ystem
RK1
In-WallUniversal
Controller
RK1Operation & Installation Guidev1.0
-
8/3/2019 Manual RK1
2/24
FEDERAL COMMUNICATIONS COMMISS
This equipment has been tested and founlimits for a Class B digital device, pursuantRules. These limits are designed to provideagainst harmful interference in a residential
This equipment generates, uses, and can ra
energy and, if not installed and used ininstructions, may cause harmful intcommunications. However, there is no guarwill not occur in a particular installation.
If this equipment does cause harmful inttelevision reception, which can be determequipment off and on, the user is encourageinterference by one or more of the following
Reorient or relocate the receiving antenn
Increase the separation between the receiver.
Connect the equipment into an outlet from that to which the receiver is connec
Consult the dealer or an experienced rahelp.
This device complies with Part 15 of the FCsubject to the following two conditions: (1
-
8/3/2019 Manual RK1
3/24
RK1 Universal System Controller
SAFETY SUGGESTIONS
Read Instructions. Read all safety and opebefore operating the unit.
Heat. Keep the unit away from heat sourcesheat registers, stoves, etc., including amplifiers
Power Sources. Connect the unit only to an Rsupply.
Power Cord Protection. Route power supply are not likely to be walked on or pinched by
against them, paying particular attention to treceptacles and at the point at which they exit f
Nonuse Periods. Unplug the power supply frothe unit is to be left unused for a long period.
Water and Moisture. Do not use the uniexample, near a sink, in a wet basement, nearnear an open window, etc.
Object and Liquid Entry. Do not allow objectsbe spilled into the enclosure through openings.
Cleaning. The unit should be cleaned only as reoperating guide.
Servicing. Do not attempt any service beyonh d f ll h
-
8/3/2019 Manual RK1
4/24
LIMITED WARRANTY
Remote Technologies Incorporated warranperiod of one (1) year from the date of pTechnologies Incorporated or an authorizedIncorporated distributor.
This warranty may be enforced by the o
subsequent owners during the warranty poriginal dated sales receipt or other proof opresented when warranty service is required
Except as specified below, this warranty
material and workmanship in this product. covered by the warranty:
Damage resulting from:
1. Accident, misuse, abuse, or neglect.2. Failure to follow instructions contain3. Repair or attempted repair by anyo
Technologies Incorporated.4. Causes other than product defects, i
competence or experience of user.5. Shipment of this product (claims mu6. Being altered or which the serial num
modified or removed.
Remote Technologies Incorporated is not lid b i d f i f il f i
-
8/3/2019 Manual RK1
5/24
RK1 Universal System Controller
If your RK1 needs service, please contact Re
Incorporated by telephone, fax or e-mail for ret
Please do not return products to Rauthorization.
DISCLAIMER
All rights are reserved. No part of this dphotocopied, reproduced, or translated withounotice of Remote Technologies Incorporated.
The information contained in this document iwithout notice. Remote Technologies Incorpoliable for errors or omissions contained herein odamages in connection with the furnishing, perthis guide.
Microsoft and Windows are registered trademCorporation. Other brands and their productsregistered trademarks of their respective holder
RK1, Its Under Control, TheaterTouch, and
trademarks of Remote Technologies Incorporat
-
8/3/2019 Manual RK1
6/24
Contents
Federal Communications Commission No
Safety Suggestions -----------------------------
Limited Warranty ------------------------------
Disclaimer-----------------------------------------Contents---------------------------------------------
Chapter 1. Welcome------------------------------
Compatibility Note-----------------------------
Unpacking and Inspection -------------------
Product Contents-------------------------------
Software Requirements -----------------------
Chapter 2. Introduction -------------------------
Features--------------------------------------------
Important Notes --------------------------------
Cleaning ------------------------------------------
Getting Started ----------------------------------
Keypad Reference ------------------------------
Chapter 3. Operation-----------------------------
-
8/3/2019 Manual RK1
7/24
RK1 Universal System Controller
Chapter 6. Service and Support-------------------
Updates and New Products----------------------
Contacting Remote Technologies Incorporate
RTI Technical Support ----------------------------
Specifications------------------------------------------
-
8/3/2019 Manual RK1
8/24
Chapter 1. Welcome
Thank you for purchasing the RK1 in-walThe RK1 is a customizable keypad desiginstallations in walls or cabinets. It provcontrol system for controlling audio/video other electronic systems in the home. Siz
electrical box, the RK1 incorporates fully-pwhich can be custom labeled with text and scustom labels, the backlight for each buttondisplay almost any desired color.
The RK1 can directly control almost any aulighting system, etc. up to 1000 feet away usport. Programming is easy and conveWindows based TheaterTouch Designer
Because RTIs remote control products a
professional installers/programmers, andconsumers, it is our philosophy to not incocapability directly into our products. Insteadproviding our dealers with the hardware aallow them to create re-usable program
templates in the most efficient and reliable wThe RK1 can be used as a stand-alone deexpandable central control system. When uRTI accessory devices, the RK1 is capable of
-
8/3/2019 Manual RK1
9/24
RK1 Universal System Controller
UNPACKING AND INSPECTION
After unpacking your new RK1 universal systall of the packing materials in case you ever hav
Thoroughly inspect the RK1 and packing madamage. Report any damage to the carrier im
any equipment malfunctions to RemIncorporated or an authorized Remote Technodistributor.
PRODUCT CONTENTSContents within the box include the following i
One (1) RK1 universal system controller
One (1) Set of button labels
One (1) Operation & Installation guide
SOFTWARE REQUIREMENTS
The recommended minimum system requirem
the TheaterTouch Designersoftware are as follow Windows 98SE, Windows ME, Window
XP or later version.
A f USB t
-
8/3/2019 Manual RK1
10/24
Chapter 2. Introduction
FEATURES
The RK1 provides superior quality and reliaspecific features:
Use any standard Decora type face
Fits in single gang outlet box.
Three different cover plate colors ava
Two, four or eight assignable/programodels available.
User-definable backlight color.
Open architecture allows control of v
Easy to use Windows based softwa
and customization.*
Adjustable backlight brightness.
Light sensor for automatic backlight
IR output port drives up to 1000 feet
Completely customizable, programmupgradeable.
-
8/3/2019 Manual RK1
11/24
RK1 Universal System Controller
IMPORTANT NOTES
Please read these important notes about the RK
The RK1 should be placed in an area w
normal room temperature (between 60F
Avoid installing the RK1 in a location wcontact with direct sunlight.
Do not install the RK1 directly adjacent togenerated by the RK1 may affect tempera
Do not use sharp objects on the buttonoperate with a touch of your finger.
Do not let the RK1 get wet. It should no
wet hands or placed in an area where it co
Do not subject the RK1 to smoke, dust,display may be damaged from excessive s
Only use the power supply that is speUsing the wrong type of power suppdamage.
Do not disassemble the unit Service of
-
8/3/2019 Manual RK1
12/24
CLEANING
Occasional cleaning may be required, depen
To clean your RK1, lightly dampen a lint-fcleaner or mild detergent, and wipe the bezel, and faceplate.
GETTING STARTED
The RK1 is turned-on by simply applyiprovides two power supply solutions which
Single Unit Power Supply
16VDC, 1.6Amp
Provides power for up to six RK
Part Number: 40-210285-22
CB-4 Connecting Block
Includes 16VDC, 4.3Amp powe
Provides power for up to sixtee Provides a convenient connecti
Part Number: 10-210052-11
-
8/3/2019 Manual RK1
13/24
RK1 Universal System Controller
KEYPAD REFERENCE
FunctionButtons
Ambient LightSensor
Front View
Cover PlateThreaded Holes
-
8/3/2019 Manual RK1
14/24
Chapter 3. Operation
THE INTERFACE
The RK1 is a flexible, programmable interfconfiguration, the RK1 buttons can each single function or scene. If more functiobuttons can execute complex macros, jump change backlight colors to provide status fcustomization allows almost any typefunctionality to be created.
BUTTON LABELS
The RK1 includes a set of labels for attachibutton. The label sheets include a wide varithat are appropriate for most common sce
for attaching these labels is as follows:
-
8/3/2019 Manual RK1
15/24
RK1 Universal System Controller
1. Remove t
2. Place therubber po
3. Replace t
Repeat the steps above for each button, and thecover.
-
8/3/2019 Manual RK1
16/24
Control Port Pin-Out
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6Pin 7
Pin 8
INFRARED
INFRARED
+16VDC
+16VDC
RK1 Basic Wiring Connect
Stand-Alone OpControl-System Operation
Cat-5 Cable
(Future Use)
(Future Use)
GROUND
GROUND
RS-485 +
RS-485 -
Chapter 4. Installation & Pro
The RK1 is designed for flush-mount inscabinets. It requires an available mountin(50mm) from the front surface of the wall. mounted in a standard single-gang electrica
-
8/3/2019 Manual RK1
17/24
RK1 Universal System Controller
CONTROL PORT
RK1 IN-WALL UNIVERSAL CONTROLLER
WWW.RTICORP.COM
RK1/01
MASTER/SLAVE PORT
R
SLAVE
Cat-5 Cable
MASTER/SLAVE OPERATION
Two RK1 units can be connected together ucable between the Master/Slave ports on eactwo keypads to sync with each other so thelarger keypad. Any combination of two, four, o
units can be connected together.When configured in this way, only the masconnected via the Control port (for power, IR, will derive power and communications from th
-
8/3/2019 Manual RK1
18/24
Chapter 5. Troubleshooting
If you are having problems with your Rtroubleshooting tips before contacting techn
If you continue to have problems, see information on contacting RTI technical sup
UNIT DOES NOT POWER ON
Make sure the external power supply is proRK1, and it is functioning properly.
Make sure the RJ-45 plug is attached proper
Make sure power is applied to the correct cothe unit (the Control Port, NOT the Master/
USB COMMUNICATION PROBLEMS
Verify that your PC is running Windows 98
Verify that the RK1 is present in the Humsection of the Device Manager within th
Panel.
Make sure you are using the programmsupplied by RTI and that both ends are conn
-
8/3/2019 Manual RK1
19/24
RK1 Universal System Controller
If you are still having problems, try adju
Minimum Repeats value in the Theaprogramming software.
If the IR code is executed inside a macro that ccodes, try inserting a small time delay before ththere already is a delay, try increasing it.
-
8/3/2019 Manual RK1
20/24
Chapter 6. Service and Supp
UPDATES AND NEW PRODUCTS
For news about the latest updates, new proaccessories, please visit our web site at:
www.rticorp.com
CONTACTING REMOTE TECHNOLOGIES
For general info, you can contact RTI at:
Remote Technologies Incorporated
Tel. (952) 253-3100
Fax (952) 253-3131
www.rticorp.com
RTI TECHNICAL SUPPORT
At RTI, customer service and satisfaction isyou are encountering any problems or haveRTI product, please contact RTI Technical Su
RTI provides technical support by telephone
-
8/3/2019 Manual RK1
21/24
RK1 Universal System Controller
If you are having a problem with hardwar
equipment in your system, a description of thetroubleshooting you have already tried.
If you are having a problem with software,version you have installed, the operating sysdescription of the problem, and any troublealready tried.
If you are calling about a software or programproblem, please be at you computer when yThis will considerably speed up the troublesho
For Technical Support or assistance with contact RTI at:
(952) 253-3137
[email protected]/support
For questions regarding Service or Repair of
contact RTI at:(952) 253-3136
-
8/3/2019 Manual RK1
22/24
Specifications
Power 9 - 1
Power Management Adjbrigtim
Buttons FixeUse
Backlight RG
Use
Infrared Output Port 200Dri(300
Operating Temperature +32
(0 Operating Humidity 5%
con
Total System Memory 64K(no
Device Capability Totis limem
-
8/3/2019 Manual RK1
23/24
RK1 Universal System Controller
Front Cover High-i
ABS p
Front Plate Purcha(Decor
Mounting Mount
single Dimensions (H x W x D) 4.1 in (
(46mm
Total Depth in Wall 1.7 in (
Weight 4 oz (1
Warranty One Y
All specifications are subject to change w
-
8/3/2019 Manual RK1
24/24
IR-P
RO
ProfessionalInfraredCodeCapture
System
R e m o t e T e c h n o l o g i e s I n c o r p o r a t e dR e m o t e T e c h n o l o g i e s I n c o r p o r a t e dR e m o t e T e c h n o l o g i e s I n c o r p o r a t e dR e m o t e T e c h n o l o g i e s I n c o r p o r a t e d7651 Anagram Drive
Eden Prairie, MN 55344
Tel: 952-253-3100
Fax: 952-253-3131
www.rticorp.com
2007 Remote Technologies Inc. All rights reserved. Printed in Taiwan.
Its Under Control