Manual Material Handling

27
1 www.doas.georgia.gov/risk Risk Management Services Manual Material Handling

description

Manual Material Handling. Back Injury Facts 70% of cases – Average weight of object lifted was 40-100# and 30% were over 100# The distance traveled at the time of injury was less than 5 feet 50% of the cases, the object was lifted from the ground level - PowerPoint PPT Presentation

Transcript of Manual Material Handling

Page 1: Manual Material Handling

1www.doas.georgia.gov/risk

Risk Management Services

Manual Material Handling

Page 2: Manual Material Handling

2www.doas.georgia.gov/risk

Risk Management Services

Back Injury Facts

• 70% of cases – Average weight of object lifted was 40-100# and 30% were over 100#

• The distance traveled at the time of injury was less than 5 feet

• 50% of the cases, the object was lifted from the ground level

• 83% of the cases, the back was fully or partially flexed or bent

Page 3: Manual Material Handling

3www.doas.georgia.gov/risk

Risk Management Services

Back Injuries…• They are exceedingly painful, difficult to heal, and have

an affect on everything you do.

• After suffering one back injury, you are much more likely to experience another one later.

• The most costly type of injury for the State of Georgia.

• According to the Bureau of Labor Statistics, more than one million workers suffer back injuries each year; and back injuries account for one of every five workplace injuries.

Page 4: Manual Material Handling

4www.doas.georgia.gov/risk

Risk Management Services

InjuriesSprain• Injury or tear of ligaments.

• Ligaments are tough connective tissue that connect bone to bone.

Strain• Injury to muscles that have been stretched or used too

much.

• Both strains and sprains irritate the muscles around them.

Page 5: Manual Material Handling

5www.doas.georgia.gov/risk

Risk Management Services

Causes of Back Injuries and Back Pain

Repeated Lifting of Materials Lifting Too Much Weight Sudden Movements, Shift of Load Whole Body Vibrations Lifting & Twisting at the same time Bending over for long periods of time

Page 6: Manual Material Handling

6www.doas.georgia.gov/risk

Risk Management Services

Our BacksOur Backs• The spine’s vertebrae are held together by

ligaments.

• Muscles are attached to the vertebrae by bands of tissue called tendons (think of them as rubber bands).

• Between each vertebra is a cushion known as a disc (think of it as a pad or pillow).

• Spinal Column (think of the vertebrae as building blocks).

Page 7: Manual Material Handling

7www.doas.georgia.gov/risk

Risk Management Services

Our BacksOur Backs

• Openings in each vertebra line up to form a long, hollow canal.

• The spinal cord runs through this canal from the base of the brain.

• Nerves from the spinal cord branch out and leave the spine through the spaces between the vertebra.

Page 8: Manual Material Handling

8www.doas.georgia.gov/risk

Risk Management Services

Forces Involved in LiftingForces Involved in Lifting

Think of your back as a lever. With the fulcrum in the center of the lever, how many pounds would it take to lift a 10 pound object?

5 pounds10 pounds15 pounds

Page 9: Manual Material Handling

9www.doas.georgia.gov/risk

Risk Management Services

Forces Involved in Lifting:Forces Involved in Lifting:

You’re right! It takes 10 pounds of pressure to lift a 10 pound object.

Will it take more or less force to lift the same 10 pound object with the fulcrum shifted to one side?

Page 10: Manual Material Handling

10www.doas.georgia.gov/risk

Risk Management Services

Forces Involved in LiftingForces Involved in Lifting

You’re right! With the fulcrum shifted away from the object, it takes more force to lift the object.

The human back operates on a 10:1 ratio, with the waist acting as the fulcrum.

Page 11: Manual Material Handling

11www.doas.georgia.gov/risk

Risk Management Services

Risky Moves!Risky Moves!Anytime you find yourself doing one of these things, you should think:

DANGER! My back is at risk!

Heavy lifting...especially repetitive

lifting over a long period of time.

Twisting at the waist while lifting or

holding a heavy load. (This frequently

happens when using a shovel).

Reaching and lifting...over your head,

across a table or out the back of a truck.

Page 12: Manual Material Handling

12www.doas.georgia.gov/risk

Risk Management Services

Risky Moves! Risky Moves! Common Lifting ErrorsCommon Lifting Errors

• Poor planning• Poor communication• Insufficient strength• Lifting with flexed spine and the legs straight• Using a fast, jerky movement• Bending and twisting at the same time

Page 13: Manual Material Handling

13www.doas.georgia.gov/risk

Risk Management Services

Manual Handling

Seek help:

• When a load is too bulky to properly grasp or lift.

• When you can’t see around or over the load.

• When you can’t safely handle the load.

• Attach handles to loads to reduce the chances of getting fingers smashed.

Page 14: Manual Material Handling

14www.doas.georgia.gov/risk

Risk Management Services

Safe Lifting

•Break load into parts.

•Get help with heavy or bulky items.

•Lift with legs, keep back straight, do not twist.

•Use handling aids such as steps, trestles, shoulder pads, handles, and wheels.

•Avoid lifting above shoulder level.

Page 15: Manual Material Handling

15www.doas.georgia.gov/risk

Risk Management Services

Poor posture…

…is another contributing factor. When your

mother told you to sit and stand up straight,

she was giving you good advice. It is best to

try to maintain the back in its natural "S"

shaped curve. You want to avoid leaning

forward (unsupported) when you sit,

or hunching over while you're standing.

Contributing FactorsContributing Factors

Page 16: Manual Material Handling

16www.doas.georgia.gov/risk

Risk Management Services

Contributing FactorsContributing Factors

Poor Physical Condition

Your stomach muscles provide a lot of the support needed by your back. If you have weak, flabby stomach muscles, your back may not get all the support it needs, especially when you're lifting or carrying heavy objects. Good physical condition, in general, is important for preventing

strains, sprains, and other injuries.

Page 17: Manual Material Handling

17www.doas.georgia.gov/risk

Risk Management Services

Contributing FactorsContributing FactorsExtra weight…

can be a big problem. Remember the fulcrum/lever principle? The more you weigh, the more stress it puts on your back every time you bend over--on a 10:1 ratio. That pot belly is not helping the health of your back.

Page 18: Manual Material Handling

18www.doas.georgia.gov/risk

Risk Management Services

Injury Prevention Injury Prevention Analysis ToolsAnalysis Tools

• The closer to the body the more strength you have.

• Other tools:▪ ACGIH Lifting TLV

▪ NIOSH Lifting Equation

• Most models show approximately 35 pounds to be the maximum load for repeated lifting.

Page 19: Manual Material Handling

19www.doas.georgia.gov/risk

Risk Management Services

Injury PreventionInjury Prevention

Use carts and dollies to move objects, instead of carrying themyourself. (Remember that it is better on your back to push cartsthan it is to pull them). Use cranes, hoists, lift tables, and other lift-assist deviceswhenever you can.

Page 20: Manual Material Handling

20www.doas.georgia.gov/risk

Risk Management Services

Avoid lifting and bending whenever you can.

Place objects off the floor; that way you won’t have to reach down to pick them up again.

Raise/lower shelves.

Injury PreventionInjury Prevention

Page 21: Manual Material Handling

21www.doas.georgia.gov/risk

Risk Management Services

Injury PreventionInjury Prevention -

When lifting a box, think out of the box! • Is there a better way?

Don’t wait for someone to get injured before changing a job.

• Just because we have done it this way in the past, do we have to continue using the same method to handle a loading and unloading task?

Page 22: Manual Material Handling

22www.doas.georgia.gov/risk

Risk Management Services

Injury Prevention Injury Prevention Reducing frequent lifts:Reducing frequent lifts:

• Use mechanical assistance

• Avoid unnecessary lifting

• Use mobile storage shelves

Page 23: Manual Material Handling

23www.doas.georgia.gov/risk

Risk Management Services

Proper LiftingProper Lifting• You can't always avoid lifting, but there are ways to

reduce the amount of pressure placed on the back when you do so.

• By bending the knees, you keep your spine in a better alignment, and you essentially take away the lever principle forces.

• Instead of using your back like a crane, allow your legs to do the work.

Think of your body as more of an elevator than a

crane.

Page 24: Manual Material Handling

24www.doas.georgia.gov/risk

Risk Management Services

Proper LiftingProper Lifting BEFORE YOU LIFT• Plan Your Route: Path clear? Trip hazards removed? Dry?• Assess the Load: Too heavy? Can I use a hand truck or forklift?

Can I slide it? WHEN YOU LIFT • Lift It Right: Position your body close to the object. Keep your

back straight.• Lower It Right: When you put the load down, bend your knees not

your waist. GET HELP IF YOU NEED IT• Work Together: Don't be a hero. Communicate with your partner!

Page 25: Manual Material Handling

25www.doas.georgia.gov/risk

Risk Management Services

Proper Lifting Procedures Lifting Options – Proper Lifting Procedures Lifting Options – Golfers LiftGolfers Lift

Only appropriate for light objects that can be lifted with one hand

Good lift for those with painful knees• Bend at hip with while raising one leg

behind you• Leg lift helps maintain a neutral spine• Place one hand on thigh or fixed object• Push hand off thigh or object while

lowering leg to complete lift

Page 26: Manual Material Handling

26www.doas.georgia.gov/risk

Risk Management Services

Prevent Back InjuriesPrevent Back Injuries

Body Management

Rest your back

Take frequent, short (micro) breaks (seconds not minutes).

Stretch. If you've ever been working in an awkward position for a long time, then stood up and felt stiff and sore, you know you've been in that position too long,

and your body is now protesting.

Taking a one minute stretch break every now and then can help you avoid that.

Page 27: Manual Material Handling

27www.doas.georgia.gov/risk

Risk Management Services

ConclusionPoint Take-A-Way

Basic anatomy of the back Blocks, rubber bands, pillows

Forces involved with lifting 1:10 ratio,Keep load close to body

Risky moves associated with lifting No twisting with loadsNo reaching

Contributing factors to materials handling injuries

Fitness, age, walking surfaces

Injury prevention Reduce your lifts, THINK! Mechanical help

Proper lifting procedures Elevator vs. CraneUse proper lift for load

Body Management Stretch, Exercise, Rest as needed