7/27/2019 Manual-BioZapper v1 0

1/3

Bio Zapper v1.0

http://www.ekovortex.com/

1. Instructions

Start/Stop button

Arrow left

Arrow right

Arrow down

Arrow up

Step 1.This is staring screenPress arrow down

Step 2.Use left and right arrows to set frequencyAfter that press arrow down

Step 3.Use left and right arrows to set timeAfter that press arrow down

Step 4.This screen shows adjusted frequency and time

Step 5.

If you want to save adjusted frequency time pressstart/stopElse pres down now you will go to step 8

Step 6.With left and right arrow set program number whereyou want to saveThen pres down arrow

Step 7.With left and right arrow set step number where youwant to saveThen pres start stop, you will now be on step 2

Bio Zapper v1.0

Set Freq [Hz]

xxxxxx

Set Time [Hz]

xxx

Freq: xxxxxx Hz

Time: xxx min

Save To Program

Program:x

Step:x

7/27/2019 Manual-BioZapper v1 0

2/3

Step 8.If you want to run sawed programs press start/stopElse press down arrow now you will go to step 14

Step 9.With left and right arrow chose program number whichyou want to runThen pres start stop

Step 10.Press start/stop to start zappingOr down arrow if you want to change settings ( thenyou will go on step 2

Step 11.Here you can see following informations

P Program nr. / S Step nr.F Frequency / t TimeYou can stop zapping if you press start/stop (Step 12)Step 12.With start/stop you can start zapping again, or if youpress down arrow you will go on step 2

Step 13.Zapping is finishedWith start/stop you can start zapping again, or if you

press down arrow you will go on step 2

Step 14.Press start/stop to start zappingOr down arrow if you want to change settings ( thenyou will go on step 2

Step 15.Zapping is runningHere you can see following informationsF Frequency / t TimeYou can stop zapping if you press start/stopStep 16.Zapping is finishedWith start/stop you can start zapping again, or if youpress down arrow you will go on step 2

Run Program

Run Program: x

Bio Zapper v1.0

Ready To Start

Running P:x S:x

f:xxxxxx t:x

Stopped By User

Stopped By Timer

Bio Zapper v1.0

Ready To Start

Running

F:xxxxxx t:x

Stopped By Timer

7/27/2019 Manual-BioZapper v1 0

3/3

2. Specifications

Frequency adjustment from 1 Hz to 100 kHz (Resolution 1 Hz)

Time adjustment from 1 to 240 minutes (Resolution 1 min)

Memory last used settings (No need every time adjusts frequency and time)

Can memory 10 programs Program can have up to 5 different frequency's and running times

Generates a rectangular signal amplitude 12.5 V with a positive offset of 0.25V

Duty cycle 50%

Frequency Stability +/- 0.001% (Frequency is generated by a microprocessorthat runs on crystal oscillator with 16Mhz)

Protection against short-circuit (Max 5 minute)

External power supply 12 VDC