MADE IN THE USA - Safety Controls
Transcript of MADE IN THE USA - Safety Controls
Division of Material Control, Inc.Croswell, Michigan 48422 • U.S.A.
www.conveyorcomponents.com
CCC RG-100FEBRUARY 2020
MEETS OSHA 1910 Subpart D and ANSI-A1264.1-2017
M A D E I N T H E U S A
SELF-CLOSINGComprehensively tested to over 1,000,000 cycles without spring failure.
CORROSION RESISTANTTwo-part powder-coat finish, zinc rich primer with UV resistant polyester top coat.
ADJUSTABLETwo models cover openings from 16” to 40”.Either model can be mounted to allow for left or right opening.Will mount to round or square guardrail systems or to any reinforced flat mounting surface, by easy bolt-on attachment.
OSHA/ANSI OSHA & ANSI Standards require any surface above 4 feet to be guarded by guardrail systems. Any openings in the guardrail system must be protected by an offset guardrail or self-closing safety gate.
Stainless steel spring resists rust while ensuring gate closes automatically. Tested to over 1,000,000 cycles without spring failure.
2" incremental adjustment.
Adaptable to round or square guardrail.
Friction reducing bushings eliminate metal to metal contact.
Strike Plate adds additional strength to the gate. Noise dampening foam rubber pad reduces loud noise when gate closes.
For use with OSHA COMPLIANT 42”
guardrail systems. READY GATE Adjustable
Self Closing Safety Gates meet OSHA
1910 Subpart D, and ANSI-A1264.1-2017.
READY GATE Advantages• Versatile, can be mounted to round or square guardrail up to 2”, or a
firm reinforced wall surface.• Stainless steel spring closes the gate after each pass thru.• Gate width is available in two adjustable size ranges to fit openings of
16” to 26” or 24” to 40”. Gate width is adjustable in 2” increments.• Available in red powder coated finish for safety, with zinc rich powder
coat primer for corrosion resistance.
130 Seltzer Road • PO Box 167 • Croswell, MI 48422www.conveyorcomponents.com • [email protected]
Phone: 800-233-3233 Fax: 810-679-4510 © Copyright 2020
MODELS AVAILABLE:RGC-26-C6
FITS CLEAR OPENINGS OF 16” to 26”adjustable in 2” increments
RGC-40-C6FITS CLEAR OPENINGS OF 24” to 40”
adjustable in 2” increments
MEETS OR EXCEEDS THE FOLLOWING STANDARDS:OSHA 1910.29 Fall protection systems and falling object protection-criteria and practices. Guardrail systems are capable of withstanding, without failure, a force of at least 200 pounds downward or outward without deflecting to a height of less than 39 inches above the walking-working surface.
ANSI/ASSE A1264.1 – 2017Gates must meet the guardrail requirements of 200 lbs. applied in any direction with a maximum allowable deflection of 3 inches under load.
EASY TOINSTALL!
M A D E I N T H E U S A