Machine Drawing 1st series question paper
-
Upload
kailas-sree-chandran -
Category
Documents
-
view
68 -
download
2
description
Transcript of Machine Drawing 1st series question paper
Page 1 of 4
ST.THOMAS INSTITUTE FOR SCIENCE AND TECHNOLOGY THIRUVANANTHAPURAM
Class No: ……………………………..
Name : ……………………………..
CONTINUOUS ASSESSMENT EXAMINATION – I, AUGUST 2013
THIRD SEMESTER MECHANICAL
08.306 ENGINEERING DRAWING (MPU)
PART A : Machine Drawing
PART B : Civil Engg Drawing & Estimation
(Part A and Part B are to be answered in separate answer books)
Instructions:
1. Use first angle projection method.
2. Missing dimensions may be suitably assumed and note down in the answer book.
Time: 3 hours
PART A
MACHINE DRAWING
Max. Marks: 50
PART I
(Answer any TWO questions)
Sketch with standard dimensions.
1. Whitworth Thread and Acme Thread
2. Lewis foundation bolt for bolt shank dia of 30mm.
3. Hexagonal Headed bolt with Nut and Washer, Size: M24. (Elevation only)
(2 x 10 marks= 20 marks)
PART II
4. From the accompanying figure (on page 2), draw the following views of the Bushed Pin
Flexible Coupling.
a. Bottom Half Sectional Elevation
b. Side View from Left
Maximum 5 marks will be awarded for maintaining neatness and for following the standards
of machine drawing.
(30 marks)
Page 2 of 4
FL
EX
IBL
E C
OU
PL
ING
(B
US
H O
R P
IN T
YP
E)