WALL MOUNT BRACKET

Wal l Mount Bracket

F e a t u r e s

Accepts all LogTag products including UTRED30/UTREL30 Loggers. Excludes TIC20/TICT/iS0°Tag.

Easy removal of the LogTag logger for download etc.

Molded in polycarbonate plastic to allow use in a large range of environments.

The LogTag ® Wal l Mount Bracket prov ides an easy and t idy so lut ion to mount ing a LogTag ® on a wal l ,door or ver t ica l sur face whi le s t i l l a l lowing easy removal of the LogTag ® for download etc .

F ix ing can be by the suppl ied double coated foam tape which of fers very h igh bond strength on smooth uni f ied sur faces or by opt ional ly f ix ing wi th screws.

Manufactured to meet the European RoHS Directive.

A p p l i c a t i o n s

Cool Stores

Fre ight

Refr igerators

Freezers

Shipping Conta iners

Warehouse

F i x i n g w i t h s u p p l i e d f o a m t a p e i n s t r u c t i o n s :

Revis ion E (120721) © Copyr ight 2021, LogTag North Amer ica Inc. A l l r ights reserved.LogTag® is a reg is tered t rademark of LogTag North Amer ica Inc.

LogTag North Amer ica Inc. reserves the r ight to change th is spec i f icat ion wi thout not ice .

The supplied foam tape (3M #4032) is sized to fit into the central channel at the back of the wall mount bracket

1. To obtain optimum adhesion, the bonding surfaces (i.e the back of the bracket and the mounting surface) must be clean, dry and well unified. Typical surface cleaning solvents are isopropyl alcohol* and water (rubbing alcohol) or heptane. Ideal tape application temperature range is 21°C to 38°C (70°F to 100°F). Initial tape application to surfaces at temperatures below 10°C (50°F) is not recommended because the adhesive becomes too firm to adhere readily. However, once properly applied, low temperature holding is generally satisfactory.

2. Remove the backing tape of one side of the foam tape and press fit exposed adhesive side of tape into back channel of bracket.

3. Remove other backing tape and press-fit bracket carefully to position desired. Be careful to place in correct position as once affixed it is very difficult to remove.

*Note: Be sure to follow the manufacturer’s precautions and directions for use when using solvents.

S p e c i f i c a t i o n s

Product Model Wall Mount Bracket

LogTag® part code 200-000010 WMB-01 (for all conventional loggers) WMB-02 (for UTRED30 and UTREL30 Loggers)

LogTag® models supported All LogTag products including UTRED30/UTREL30 Loggers. Excludes TIC20/TICT/iS0°Tag

Case material Polycarbonate plastic