Linking the BECKER B-Tronic with compatible products€¦ · Linken von BECKER B-Tronic mit...
Transcript of Linking the BECKER B-Tronic with compatible products€¦ · Linken von BECKER B-Tronic mit...
-
Linken von BECKER B-Tronic mit HAGER-BERKER Empfängern_GB_2014-09-12.docx
Linking the BECKER B-Tronic with compatible products
Receivers of the type made by Hager (Tebis Quicklink) and Berker (Quicklink)
Press the "cfg" button on the receiver.
The LED on the receiver lights up red.
Press the "fct" button on the receiver for about 20 seconds.
The LED on the receiver flashes alternately red and green. The receiver is now ready to link for about 2 minutes.
Start the linking process (Add receiver) in the CentralControl. Refer to the CentralControl instructions for this.
Wait until the CentralControl reports that the receiver has successfully been programmed.
The LED on the receiver goes out.
The linking process is complete, and the receiver can be operated using the CentralControl.
onoff
cfg fct
cfg fct
L N N
1
2
cfgfct
fct
1
2
1 32 4 5 6 7 8
cfg
fct
Cfg