LED NEON Flex Installation Guide · LED NEON Flex Light unnecessarily.Extra copper wires should be...
Transcript of LED NEON Flex Installation Guide · LED NEON Flex Light unnecessarily.Extra copper wires should be...
Shenzhen Ewin Lighting Technology Co.,LTD
LED NEON Flex Installation Guide
Safety Precautions
Please always read the user manual before installation, and always follow the instructions in the usermanual to reduce unnecessary product damage.
Mounting Accessories
A. Do not run/power up the LED Neon Flex when it is tightly coiled before unpacking from the packing roll. Maintain halfinch spacing between parts.B. Cuttings are only allowed at the cutting length;Do not puncture, cut, shorten, or splice LED Neon Flex outside of thedesignated cutting marks.C. Before connecting with connectors, bending the LED NEON Flex Light back and forth. But do not repeatedly bend theLED NEON Flex Light unnecessarily.Extra copper wires should be cleared with cutters;D. Do not operate/run LED Neon Flex in temperatures exceeding 65℃ or 149F.E. Do not operate LED Neon Flex over the specified voltage.F. Do not use the LED NEON Flex Light with any damaged outer jacket , loose connections, or if the wire is visiblewithout insulation. Inspect LED Neon Flex periodically for damage.G. Be sure to check the product coonections after installation;Please take effective water/moisture/dust safeguardprotection on the cutting/connecting parts.H. Do not submerse the LED NEON Flex Light in liquid;I. Please avoid the installation on rough surfaces and over sharp corners. This will scratch the PVC optic.
1. Alluminum Track 2. Alluminum Mounting Clip 3. T-Connector 4. I-Connector 5. L-Connector 6. End Cap 7. Connecting Pin 8. LED NEON Flex light 9. Controller 10. Power Supply
Cutting markCutting mark
It is imperative to use a very sharp cutting blade to make a straight cut. Sharp blade will help you avoid pullingthe internal wires of the LED Neon Flex while making the cut. Stretching or pulling the wire may result indamaged or inoperable LED Neon Flex.
Connecting the pin and the power cord and the end cap
Take effective water/moisture/dust safeguard protection onthe cutting/connecting parts (using liquid glue & heatshrink tube)
cut at the cutting mark clear the extra connectorconect to power cord & seal by heat
shrink tube and gluecut at the cutting mark clear the extra connector shrink tube and glue
finished
Tips: taking effective water/moisture/dust safeguard protection on thecutting/connecting parts (cutting,front connector, middle connector, end cap etc.) willbetter guarantee the life span of the neon lights.
connect to the end cap sealed by heat shrink tube and glue
Instruction for using different connectors
Cathy Diao Sales Director Shenzhen Ewin Lighting Technology Co.,LTD206 of Tong'an Hengye Building,Tianxin Blvd, Shiyan Town,Bao'an District , Shenzhen, China Tel: 86-755-82780858/36863926Fax: 86-755-83407984Mobile: 86-13632935074 Email:[email protected],[email protected],MSN:[email protected]:cathy diao