lavadora dw3610

1NAME OF PARTS

7

%

$

#

@

! *

1

(

)

2

34

5

8

6

^

&

! Wash Timer@ Select Switch# Water Inlet Port$ Washer Lid% Washer Tub

Accessories7 Spin Mat

^Strainer& Pulsator* Valve Selector( Spin Dryer Timer) Spin Dryer Lid

8 Drain Hose Assembly

1 Inner Lid2 Overflow Filter3 Spin Dryer Drum4 Base Under5 Power Cord6 Leg (4EA)

Downloaded from www.Manualslib.com manuals search engine

2INSTALLATIONElectrical Connection This unit is designed to operate from an adequate supply mentioned at the

rating label sticked to the rear of it. In case of 3-core cord: The power cord plug must be connected to an earthed

3-pin power point within reach of the power cord. In case of 2 conductor power cord: Connect the grounding wire to a water fau-

cet etc. Make sure that the power cord is unplugged during ground work. Do not connect the grounding wire end to a gas tube. If the power cord is damaged, it should be replaced by a repair shop appointed

by the manufacturer, because special purpose tools are required.

Connection of Hose Attach the water intake hose to the

Water inlet located at the left-hand side of the con-trol panel. Press fit the other end of the hose to either a hot or cold water tap as required. (Fig. 1).

Attach the drain hose to the drain out-let at the rear of the base and securewith the clamp provided.

The drain hose should be laid flat on the ground. Water flow will be restrictedif any portion of the drain hose is raised 20 cm (8 in) from the ground.

The opening must not be obstructed by carpeting when the washing machineis installed on a carpeted floor.

WATER INTAKE HOSE

WATER INLET

Figura 1.

Caution: This unit is made of polypropylene, use water below 50C.


HOW TO OPERATE1. Wash

Insert the power plug into a wallsocket.

Set the selector at WASH ANDRINSE, and fill up the washer withenough water for the washing load.

Put in the proper amount of detergent.Pre-washing takes about 2 minutes and is immediately followed by the mainwashing process.Delicate fabric such as silk, wool do not need prewashing.Divide colored and white clothing into seperate batches.

Depress one of the select switchesfor SOFT or NORMAL washing.

Turn the washer timer to clockwise until you reach the desired wash timeposition. This will activate the pulsator and washing will begin.Do not attempt to turn the dial from OFF to the left, nor past the 15 mark.

3

WASH RINSE

DRAIN

WASH ANDRINSE

NORMALBOTH-WAY

SOFTBOTH-WAY

SELECTORSWITCH

SocketPlug

Power cord

After using the machine, unplug thepower cord from the socket.


4Reference

WaterWashing Fabric Washing Selector level & DetergentCapacity Time Switch Volume(Inner clothing)Silk, Wool, Rayon, Nylon About SoftNatural/Synthetic fiber 2-4minblends (Outer garments)Cotton, Linen (light fabric) About Normal Low 40-50 gUnderwear Pajamas, Shirts 5-7 min 31 LHeavily solied work About Normalclothes, Cotton, Linens 8-10 min(heavy fabric)Silk, Wool, Nylon, Natural/ AboutSynthetic fiber blends 2-4 min Normal(heavy fabric)Cotton, Linens About Normal6-8 minHeavily Solied About

High 55-65 gWork Clothes 10 min Normal

43 L

Cotton, Linens

Below1.5 kg

Above1.5 kg

Item Fabric Unit weightSheet Cotton About 400gUnder wear Crape About 130gShirts Synthetic fiber About 200gSweater Wool About 300gWhite shirt Broad About 200gWhite shirt Nylon About 160gWork clothes Cotton About 600g


52. DrainBy setting the selector DRAIN, the waterwill drain out of the washer. To spin dryand drain at the same time, first beginthe spin drying process and after oneminute or so start to drain out the water.3. Spin Dry 1(1) Spread out the clothes and place

them one at time into the spin basket.

(2) Close the spin dryer inner cover andouter cover.Remember that the machine will notspin if the cover is opened.

(3) By turning the spin dryer timer to thedesired time, rotation will begin.

(4) If there is any abnormal vibratingduring spin drying, turn off the spinbasket and rearrange the clothesuniformly inside the dry.

WASH RINSE

VALVE SELECTOR

DRAIN DRAIN

open outer lid open inner lid

5

4

3

2

1

SPIN TIMER

0

stops

NOTE: It is advisable to wiring out by hand any remaining suds in the cloth-ing before placing them in the spin basket.If the spin dry outer lid is opened during spin drying rotation will automatically stop.


6CAUTIONMake sure that the spin basket has stopped rotating before opening the inner cover. Never reach into spin basket while it is still in motion.Be especially careful when children are present.

4. Rinse Return the clothing to the washer tub and set the selector to WASH AND

RINSE. Open the faucet and supply water to the washer tub.

Too mush water supplying during rinsing results in overflow and waste. Notenough water requires an excessive amount of time for through rinsing.Supply the proper amount of rinse water.

Adjust the washer timer in accordance withthe clothes to be rinsed.Once the water becomes clean during the rinsing process, shut off the faucet and turnthe washer time back to 0.

5. Spin Dry 2 After rinsing, spin dry the clothes again. Supply water to the dryer to make sure that is completely free of any remain-

ing detergent before putting in the clothes.Then follow the same process as in SPIN DRY.After the dryer comes to a complete stop remove the clothing.

15

12

9

6

3

WASH TIMER

0

NOTE: It is better to put small articles of clothing first such as socks and underwearinto the spin basket, then put bulky and heavy clothing on top.

Clothing Spin dryer timeClothing that wrinkless easilyLight fabrics such as synthetics fibers, delicate About 1 minutematerial.Clothing that does not wrinkless easily Workclothes, 3-5 minutesSheets, Underwear, thick fabric


7USEFUL INFORMATION FOR YOUWASHING MACHINETo ensure longer service from your washer, be sure to observe the following instructions.

Never operate the washer until the water has risen to a pre-set level. Never pour boiling water directly into the washer tub. The color of the plastic portions of the machine is liable to fade and may even

be deformed through exposure to direct sunlight. The drain hose should be laid flat on

the ground. Water flow will be res-tricted if any portion of the drainhose is raised more than 20cm (8 in)from the ground.

Do not use the washer in a damp place such as a bathroom. Keep the spin tub cover closed during operation. If the cover is opened the

spin basket will stop rotating. Do not splash water on the control

panel.

For good air ventilation, install the washer at least 5 cm from the wall. Be sure to use the proper electrical outlet. The overflow filter will need occasional cleaning.

Grasp it at the upper and pull out to remove it. Then, after cleaning out threadand other matter, replace the filter inserting, its bottom section and then pushingthe upper part firmly into place.

Below

20 cm


8Dirt may also collect underneath the pulsator.

Clean out occasionally by: Remove the screw located in the center of the pulsator. Hook the pulsator and pull upwards. Wiping clean the bottom of the

washer tub.(When replacing the pulsator, makesure that screw is firmly tightened)

When opening and closing the inner lid, make sure to pull it toward you.

CAUTION: For your safety, do not put your hands into spin basket until it has stopped spinning completely.

IN CASE OF TROUBLEPlease check the following. Unplug the power cord from the socketbefore checking.1. If the washer will not start: Check whether the house circuit breaker is tripped or a fuse is blown.

Check whether the power cord is connected to the socket properly.Check whether something is preventing the pulsator from rotation.Check whether the belt is attached properly.(Check by removing rear cover0

2. If there is excessive noise: Check whether something is touching the pulsator as rotates.

Check whether the machine is placed level on the floor.Check whether there is an excessively unbalanced load in the spin basket whilespinning.


9CAUTION: After installing, DO NOT REMOVE LEGS.

HOW TO FIX LEG TO BASE-HOLE FORINSTALLATION When you install this unit, be sure to

assemble LEGS(4EA) to baseunder(Fig.4).

Place this unit on its rear side on a carton to prevent damage to the body.

Insert the leg(4EA) into the baseunder hole as it was. By first insertingits two hooks.

Turn right and screw on leg. Make the allows of leg and base

under face with each other at eachcorner.

HOOK (2EA)1. Inserting2. Turn right3. Screw on.Figure 4.


WASHER-SPINDRYERINSTRUCTION MANUAL

Model No.: DW-3610

Thank you for selecting this washer-spindryer. Before operating this unit, please read these instructions completely.

=


lavadora dw3610

Documents

Transcript of lavadora dw3610