korf tutorial.pdf

download korf tutorial.pdf

of 17

Transcript of korf tutorial.pdf

  • 8/10/2019 korf tutorial.pdf

    1/17

    Main window:

  • 8/10/2019 korf tutorial.pdf

    2/17

    From the object pallete click on feed.

  • 8/10/2019 korf tutorial.pdf

    3/17

    Then click on the window.

  • 8/10/2019 korf tutorial.pdf

    4/17

    Now click on product and click on the window to place project here.

  • 8/10/2019 korf tutorial.pdf

    5/17

    Now select a pump from object palette and place it between Feed and product.

  • 8/10/2019 korf tutorial.pdf

    6/17

    Click on pipe from the object pallete and move the mouse to the feed till the mouse pointer changes

    to an upper arrow. left click at the feed outlet to start a pipe .then move the cursor to the pump

    product inlet till the pointer changes to an up arrow. click again.

  • 8/10/2019 korf tutorial.pdf

    7/17

    To enter conditions of feed click on feed , window will appear like this. Give 25psig in the feed .then

    click ok.

  • 8/10/2019 korf tutorial.pdf

    8/17

    To put pipe data click on L1 and then select material as steel, length 100ft .

  • 8/10/2019 korf tutorial.pdf

    9/17

    Now select flow from the same window after pipe.

  • 8/10/2019 korf tutorial.pdf

    10/17

    From the above window click on units. Give the liquid or vapor flow as required, before this select

    unit as per requirement. Then click on sum and transfer.

  • 8/10/2019 korf tutorial.pdf

    11/17

    After sum and transfer window will appear like this.

  • 8/10/2019 korf tutorial.pdf

    12/17

    Click on fluid and select properties and put the data required. Density of liquid 52 and viscosity

    1.63cp. then ok.

  • 8/10/2019 korf tutorial.pdf

    13/17

    Copy data from L1 to L2. Go to Edit on tool bar. Then pipe and then select copy data.

  • 8/10/2019 korf tutorial.pdf

    14/17

    From line select L1 and To Lines Select L2. And check on pipe, properties and conditions as shown

    below. And then ok.

  • 8/10/2019 korf tutorial.pdf

    15/17

  • 8/10/2019 korf tutorial.pdf

    16/17

    Now click on run hydraulicks.

  • 8/10/2019 korf tutorial.pdf

    17/17

    To show results click on R icon and then ok.