kia 20041 Airbag
Transcript of kia 20041 Airbag
-
7/28/2019 kia 20041 Airbag
1/3
RIO(BC) > 2004 > G 1.6 DOHC > Airbag > Airbag Control > 01 ACU Fault
01 ACU Fault > General Information
Component Location
General Description
Operation
The driver airbag module (DAB), located in center of the steering wheel (as in above picture), contains a folded
cushion and inflator unit. The main circuit in the SRS control module senses and judges force of impact and if
necessary, inflates the cushion. If battery voltage drops too low or power is disconnected, due to impact, the
voltage regulator and the back-up power circuit, respectively, will keep voltage at a constant level.
Self-diagnosis System
A self-diagnosis circuit is built into the SRS control module, When the ignition switch is turned ON, the SRSCM
indicator light turns on and turns off, after about six seconds, if the system is operating normally. If the light does
not come If the light does not turn on or does not turn back off after six second, or if it lights while driving, an
abnormality in the system is indicated. The system must be inspected and repaired as soon as possible. For
bettery serviceability, the cause of the malfunction is stored in memory. The data link circuit passes malfunction
information from memory to the data link connector (DLC). This information can then be read with the scantool
connected to the DLC (20P).
DTC Description
When unable to control SRS system due to internal fault in SRS Control module assembly.
DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy Internal fault in SRS control module Unable to control SRS system
due to internal fault.Enable Conditions Ignition "ON"
Threshold ValueMulfunction in Control Module
(Accelerometer/Safing/Asic Fail.)
Diagnostic
Time
Qualification More than 2.5 sec remaining
Page 1 of 3
04/09/2013https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrc...
-
7/28/2019 kia 20041 Airbag
2/3
De-
Qualification
More than sec remaining
Schematic Diagram
01 ACU Fault > Scantool Diagnostics > Monitor DTC Status
Monitor DTC Status
Whenever the ignition switch is ON, or has been turned OFF for at least one minutes, be careful not to bumpthe Airbag unit The airbags could accidentally deploy and cause damage or injuries.
1. Ignition "OFF", connect scantool.
2. Ignition "ON"& Engine "OFF", select "Diagnostic Trouble Codes(DTCs)" mode.
3. Monitor diagnostic trouble code and present of trouble code.
4. Using a scan tool, clear the DTCs.
Page 2 of 3
04/09/2013https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrc...
-
7/28/2019 kia 20041 Airbag
3/3
5. Is DTC present problem ?
YES
1) Internal fault in SRSCM. Replace SRS Control Module assy.
NO
1) Intermittent failure, system is OK at this moment.
2) Intermittent fault is caused by poor contact in the connector/wiring harness or non-cleared SRSCM memoryafter repair. Thoroughly check connectors for looseness, poor connection, bending, corrosion,
contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of
Vehicle Repair" procedure.
01 ACU Fault > Verification of Vehicle Repair
Verification of Vehicle Repair
After a repair, it is essential to verify that the fault has been corrected.
1. Connect scan tool and select "Diagnostic Trouble Codes(DTCs)" mode
2. Using a scan tool, clear the DTCs3. Operate the vehicle within DTC Enable conditions in General information.
4. Are any DTCs present ?
YES
1) Go to the applicable troubleshooting procedure.
NO
1) System is performing to specification at this time.
Page 3 of 3
04/09/2013https://www kiatechinfo com/viewer/toc print asp?vehicletype=Passenger&mfrc