K20 Clamshell SOP AG Bulk 620-4737 1) Take the HSG (604-0221). Check the Cosmetic.

2) Take the Camera module (631-1008),check cosmetic.

3) Take the LCD (646-0590), Check cosmetic and clean it

4) Apply four foams (875-4071*2 875-3970*1 875-4090*1) to LCD panel with fixture

5) Take the RCC cable (593-0995). Insert Camera cable into camera board

875-3970

875-4090

6) Apply one Mylar (875-4088) onto Camera Board

7) Fasten one screw (452-1778) to fix RCC cable. Insert Camera module into housing.

8) Fasten two screws (452-1733*2) to fix camera, Routing RCC cable into housing edge

9) Take LVDS cable (593-0949), routing LVDS cable into housing.

10) Insert LVDS cable into LCD connector, Cover one Mylar (946-1669).

11) Place LCD panel into Housing, and insert three protect shim into GAP between LCD and Housing.

Note: these three shims is just protective fixture

12) Remove left/right LCD trim VHB, and fasten two screws (452-1709*2) into Housing

13) Place LCD into Fixture, Remove three shims, fasten two screws (452-1709*2).

15) Assembled left/right END CAP (604-0365/ 604-0366) to LCD

15) Press the left/right END CAP with fixture.

16) Test LCD/Camera/Sensor/RCC cable/LVDS cable function with K20 base and golden AP card.

17) Apply two EMI Gasket (875-4054*2) to LCD

18) Take the Bezel (605-0496), Check the cosmetic.

19) Remove the Bezel 4pcs VHB. Press Bezel into LCD

20) Take Left/right Clutch (604-0216 / 604-0217), Fasten six screws (452-1518*6)

21) Assembled one antenna (631-0890). Fasten four screws (452-1777*4)

22) Test Antenna function with fixture.

23) Fasten two screws (452-1738*2), which is used for fixing AP card.

24) Assemble the right HOLDER (818-0529), fasten one screws (452-1643)

25) Assembled one barrel (604-0352) into clamshell.

818-0529 /452-1643

26) Apply printed LCD SN label and Apple part number (661-5905) onto LCD protective film

Packing the Clamshell 1) Check the finished Clamshell the cosmetic, packing the Camera and LVDS Cable with two Anti-static bags. Packing the clamshell with the Anti-static bag and Anti-static Label

LCD SN APP PN

2) Packing the clamshell into bubble bag

3) Place the packed clamshell into folded box.

Note: the capacity of box is 20 units End of SOP