Introduction to Different Parts Used in Mobile Phon1
3
Introduction To Different Parts Used In Mobile Phone Dear Students Here are we going to study about different parts used in mobile phones and there functions in the cell phone systems. To avoid non applicable items in mobile phones we will discuss only key components which are responsible for the faults. Fuse: Fuse is a component which is used to protect phone from connected to heavy charging Volts. This component can easily be located in charging section. It is built with a simple wire inside which is so thin that when heavy volts are passed or connected to the phone this wire melts with in an instance and disconnects the charger from phone so may the charging circuit inside the phone be protected. The fuse resmables much to resistance but it is marked upon as “k” or “000” or something else like this so the component you see like this will be fuse. Symbol Used For Resistance In Schematics Original Shape in general electronics
description
Different Parts Used in Mobile Phon
Transcript of Introduction to Different Parts Used in Mobile Phon1
Introduction To Different Parts Used In Mobile Phone
Dear Students Here are we going to study about different parts used in mobile phones and there functions in the cell phone systems. To avoid non applicable items in mobile phones we will discuss only key components which are responsible for the faults. Fuse:
Fuse is a component which is used to protect phone from connected to heavy charging Volts. This component can easily be located in charging section. It is built with a simple wire inside which is so thin that when heavy volts are passed or connected to the phone this wire melts with in an instance and disconnects the charger from phone so may the charging circuit inside the phone be protected. The fuse resmables much to resistance but it is marked upon as “k” or “000” or something else like this so the component you see like this will be fuse.
Symbol Used For Resistance In Schematics
Original Shape in general electronics
Shape used In Mobile Phones
Battery terminal:
Battery terminals are used to connect batteries to phone in all cell phone sets.some phone sets have three terminal battery connector and some have four terminal.connection detail of both type of battery terminals are given below.
1. 1. “ + “ sign is used to show Positive connector 2. 2. “ –“ sign is used to show Negative connector3. 3. “BSI” means Battery State Indicator.(this pin tells the phone about
batter charging state.4. 4. “B-Temp” means Battery temprature.(this pin Tells the phone about
battery temprature state. Symbole Used in Schematics Non-Polar
Shape Used in Mobile Phones
SIM Connector :
A coil is a piece of metel wire( normally it is of copper) this is used to filter low frequency signals because it performs low resistance for low frequency signals but very high resistance for high frequency signals. A coil resambles to resistance by its characteristics but there is a little difference between coil and resistance that coil resists only AC type of current DC is passed Directly whereas resistance resists DC as well as AC. Shape used in Schematics
Shape used in mobile phones
