Introduction DJ310
-
Upload
luis-zambrano -
Category
Documents
-
view
213 -
download
0
Transcript of Introduction DJ310
-
7/28/2019 Introduction DJ310
1/15
1
IllustrationofDJ310controlunit
z Connectors FrontSide
1. (SEN_M) : Master photo sensor - Main photo sensor connectorPin 1 DC 12V
Pin 2 GND
Pin 3 Signal
2. (SEN_R) : Auxiliary photo sensor - Using this sensor can has the Functions of Auto-directionand Come and Go print. (P.3)
-
7/28/2019 Introduction DJ310
2/15
-
7/28/2019 Introduction DJ310
3/15
3
6. (AIR) : Air blowing - ReservedPin 1 DC 12V
Pin 3 Signal
7. (PHD) : Print head data line8. (PUG) : Purge Button9. (INK_I) : Ink outlet _ to print head10. (INK_S) : Ink outlet _ Draining to waste11. (INK_O) : Ink inlet_ Ink sucking back from the print head.
-
7/28/2019 Introduction DJ310
4/15
4
-
7/28/2019 Introduction DJ310
5/15
5
-
7/28/2019 Introduction DJ310
6/15
6
-
7/28/2019 Introduction DJ310
7/15
7
RearSide
1.Power switch2.DC power input3.Ink cartridge
4.RS232 connector (Reserved)5.USB connector
-
7/28/2019 Introduction DJ310
8/15
8
l
-
7/28/2019 Introduction DJ310
9/15
-
7/28/2019 Introduction DJ310
10/15
10
Connector No. Description
J23 Purge button
J16 Print head data line
J6 Security chip
J20 Reservoir ink level switch
J17 Ink purging pump
J18 Ink sucking pump
J19 Ink feeding pump
J22 External alarmExternal air blowing
J30 External photosensorEncoder
J4 LCM display module
J3 Keypad
J26 Power switch
J10 Power input
-
7/28/2019 Introduction DJ310
11/15
11
-
7/28/2019 Introduction DJ310
12/15
12
1.InkFeedingPump:
1-1. While the reservoir inner ink low to a certain level, the floater will touchs thelow point switch to triggers the ink feeding pump sucks ink out from the cartridge
and fill up the reservoir, the pump will stop working until the flater touchs the high
point switch.
-
7/28/2019 Introduction DJ310
13/15
13
2.Inkpurgingpump
2-1. The ink purging pump is functional for pushing ink out to the print head
nozzle.
-
7/28/2019 Introduction DJ310
14/15
-
7/28/2019 Introduction DJ310
15/15
15
1. DJ310 is available to equips multi-head, XJ128/80, XJ128/40 and Electron. Forreplacement, just remove the ink tube and unplug the print engine from the little board.