Instructions SK-T26 Tool - Aircraft Spruce
1
Skybolt Aeromotive Corp Copyright 2013 5/2/2013 SK-T26 Tool Combination CLoc® T26 and T98-1 Tool (For all CLoc® and Camloc® Fasteners) T26 - Installation of CLoc® or Camloc® R4G Snap Ring Retainers – Remove cap and taper insert. Slide R4G Retainer onto insert towards the large end. Push R4G Retainer onto grommet (Install grommets-retainers then install studs with 4P3 Pliers). T98-1 - Installation of CLoc® or Camloc® 2000 Series Retainers (2600-LW and 27S5-1). Place retainer onto base of stud (cup); simply press retainer until seated.
Transcript of Instructions SK-T26 Tool - Aircraft Spruce
![Page 1: Instructions SK-T26 Tool - Aircraft Spruce](https://reader036.fdocuments.us/reader036/viewer/2022072512/62dd98871c236d5ee505251a/html5/thumbnails/1.jpg)
Skybolt Aeromotive Corp Copyright 2013 5/2/2013
SK-T26 Tool
Combination CLoc® T26 and T98-1 Tool (For all CLoc® andCamloc® Fasteners)
T26 - Installation of CLoc® or Camloc® R4G SnapRing Retainers – Remove cap and taper insert.
Slide R4G Retainer onto insert towards the large end.
Push R4G Retainer onto grommet (Installgrommets-retainers then installstuds with 4P3 Pliers).
T98-1 - Installation of CLoc® or Camloc® 2000Series Retainers (2600-LW and 27S5-1). Placeretainer onto base of stud (cup); simply press retaineruntil seated.