Installing the Star TSP100 ·...
Transcript of Installing the Star TSP100 ·...
Installing the Star TSP100 Receipt Printer
After downloading the driver folder, open it and navigate to windows then Installer.
Next select and open the installer that suits your operating system.
A security window will appear which you need to click yes to.
After a few seconds of preparing an installer window will appear.
Enter your Username and Organisation and click next.
Select Typical and click next.
Once you have clicked install this window will appear. It may take a few minutes for it to complete this step.
Once it is finished navigate to Start, All Programs, StarMicronics, Star TSP100, Configuration Utility.
After a few seconds a window like the one below will appear. It is important that you select ESC/POS Mode before you click ok.
A window similar to the one below will open. Click on Print Job Routing and check the box to Enable ESC/POS Routing then click Apply Changes.
Optional/Advanced Features
Adding a Logo to the receipt
Select Image List. Click Add New.
Navigate to the image that you want to print on your receipt. The image must be formated as a bmp, jpeg or gif. Select the image and click open.
A window similar to the one below will appear. Change the 64 to 48 and click Use Image.
After that click Apply Changes.
Lastly click on the logos and cropping tab ,click “Add” beside “Top Image List” and select the image you just added. Click Apply Changes to finish.