INCREASE YOUR POWER TORQUE - Sprintex...

1
DODGE CHALLENGER 3.6L V6 PENTASTAR INCREASE YOUR POWER & TORQUE Power increase 246whp to 338whp Torque increase 225lb/ft. to 308lb/ft. *with standard pulley supplied Features: MSRP: $5,495* + installation * Pricing subject to change without notice and subject to applicable taxes Available for: 2012-2015 3.6L V6 Pentastar engine Challenger S5-335 ultra efficient twin screw compressor providing a denser charge for more power and torque, particularly at low rpm S5-335 producing air flow of up to 740 cu ft/min Three cycle process of intake, compression and discharge providing immediate boost and eliminating lag Twin Screw linear efficiency increasing volume of air forcibly inducted into the engine Compact and high efficiency water to air intercooler system incorporating Laminova® tubes producing greater air mass for improved and more consistent performance Completely bolt on and fully reversible with all components supplied pre-assembled Engineered and tested to OEM specifications Torque and WHP increases > 36% 0 – 60 mph < 5.0 seconds Fully integrated supercharger system (not a self assemble kit). Estimated installation time of 6-8 hours. Manufactured under ISO9001. Sprintex system parts are warranted for 12 months or 12,000 miles / 20,000Kms. P: +61 8 9262 7277 USA: +1 855 591 2778 W: WWW.SPRINTEX.COM.AU W: WWW.SPRINTEXUSA.COM SPRINTEX SUPERCHARGERS

Transcript of INCREASE YOUR POWER TORQUE - Sprintex...

Page 1: INCREASE YOUR POWER TORQUE - Sprintex USAsprintexusa.com/sales_sheets/challenger_3_6_sales_sheet.pdf · DODGE CHALLENGER 3.6L V6 PENTASTAR INCREASE YOUR POWER & TORQUE Power increase

DODGE CHALLENGER3.6L V6 PENTASTAR

INCREASE YOUR POWER & TORQUEPower increase 246whp to 338whp

Torque increase 225lb/ft. to 308lb/ft.

*with standard pulley supplied

Features:

MSRP: $5,495* + installation

* Pricing subject to change without notice and subject to applicable taxes

Available for:2012-2015 3.6L V6 Pentastar engine Challenger

S5-335 ultra efficient twin screw compressor providing a denser charge for more power and torque, particularly at low rpm

S5-335 producing air flow of up to 740 cu ft/min

Three cycle process of intake, compression and discharge providing immediate boost and eliminating lag

Twin Screw linear efficiency increasing volume of air forcibly inducted into the engine

Compact and high efficiency water to air intercooler system incorporating Laminova® tubes producing greater air mass for improved and more consistent performance

Completely bolt on and fully reversible with all components supplied pre-assembled

Engineered and tested to OEM specifications

Torque and WHP increases > 36%

0 – 60 mph < 5.0 seconds

Fully integrated supercharger system (not a self assemble kit).

Estimated installation time of 6-8 hours.

Manufactured under ISO9001.

Sprintex system parts are warranted for 12 months or 12,000 miles / 20,000Kms.

P: +61 8 9262 7277 USA: +1 855 591 2778

W: WWW.SPRINTEX.COM.AU W: WWW.SPRINTEXUSA.COM

SPRINTEX SUPERCHARGERS

*with standard pulley supplied

stallation

notice and

2012-2015 3.6L V6 Pentastar engine Challenger

HIOS Digital Torque Meters HIOS Digital Torque Meter controls Control Function Power switch【POWER】 Button switch. The LED lights when the power is on. *1 The power is automatically

HIOS Digital Torque Meters HIOS Digital Torque Meter controls Control Function Power switch【POWER】 Button switch. The LED lights when the power is on. *1 The power is automatically

MINI CONVERTIBLE....3 -cylinder 1,499 cm3 ENGINE: 4 -cylinder 1,998 cm3 ENGINE: 4 -cylinder 1,998 cm3 POWER: 100 kW POWER: 141 kW POWER: 170 kW TORQUE: 220 Nm TORQUE: 280 Nm TORQUE:

MINI CONVERTIBLE....3 -cylinder 1,499 cm3 ENGINE: 4 -cylinder 1,998 cm3 ENGINE: 4 -cylinder 1,998 cm3 POWER: 100 kW POWER: 141 kW POWER: 170 kW TORQUE: 220 Nm TORQUE: 280 Nm TORQUE:

BF-Series (BF060, BF080 & BF120 models) Operation ... the torque adjustment nut to set the torque limit. Turn clockwise to increase torque and counter clockwise to decrease torque.

BF-Series (BF060, BF080 & BF120 models) Operation ... the torque adjustment nut to set the torque limit. Turn clockwise to increase torque and counter clockwise to decrease torque.

Damping Torque Analysis of Power Systems with DFIGs … · Damping Torque Analysis of Power Systems ... can affect power system small-signal angular stability in ... penetration on

Damping Torque Analysis of Power Systems with DFIGs … · Damping Torque Analysis of Power Systems ... can affect power system small-signal angular stability in ... penetration on

Power Controller for Torque Motors

Power Controller for Torque Motors

Torque Wrench Operating instructions · Conversion table 2. Set the torque wrench to 70 Nm. 2. Set the torque wrench to 93 ft-lb. 3. Increase the torque setting so that it reads an

Torque Wrench Operating instructions · Conversion table 2. Set the torque wrench to 70 Nm. 2. Set the torque wrench to 93 ft-lb. 3. Increase the torque setting so that it reads an

Torque and Power Measurement Second

Torque and Power Measurement Second

ZF TraXon Torque...Transmission: TE-ML 02 1,272 SAE 1 Transmission type Input torque Weight without auxiliaries w/o heat exchanger Oil grade Torque increase converter Length „L“

ZF TraXon Torque...Transmission: TE-ML 02 1,272 SAE 1 Transmission type Input torque Weight without auxiliaries w/o heat exchanger Oil grade Torque increase converter Length „L“

Drive Power and Torque in Paper Machine Dryers

Drive Power and Torque in Paper Machine Dryers

09 15 Power Torque- UD's First 80 Years

09 15 Power Torque- UD's First 80 Years

Increase power and torque by up to 45% TDS-11HD · 2019-03-05 · As the land drilling market demands high torque at high speed, contractors require top drives that meet demands for

Increase power and torque by up to 45% TDS-11HD · 2019-03-05 · As the land drilling market demands high torque at high speed, contractors require top drives that meet demands for

Power, Torque and Robot arms

Power, Torque and Robot arms

POWER AND TORQUE CURVES.doc

POWER AND TORQUE CURVES.doc

Sun SCM Torque/Power SCM RQUE/POWER SCM Torque/Powersunfab.com/media/1447/4003en1510-scm-torque-and-power.pdf · SCM 012Torq0CuePw2/732754268932S26 2TCrew0uu32S•r•M2•u22€8š288320422€8š2€32ƒ0eu2wCM

Sun SCM Torque/Power SCM RQUE/POWER SCM Torque/Powersunfab.com/media/1447/4003en1510-scm-torque-and-power.pdf · SCM 012Torq0CuePw2/732754268932S26 2TCrew0uu32S•r•M2•u22€8š288320422€8š2€32ƒ0eu2wCM

TORQUE VERIFICATION PROCESS OF POWER TOOLS

TORQUE VERIFICATION PROCESS OF POWER TOOLS

Chapter 17 torque converters power point 1

Chapter 17 torque converters power point 1

Exoskeleton Power and Torque Requirements Based on Human Biomechanics · Exoskeleton Power and Torque Requirements ... 6.3 Stair Climbing ... The power requirements for the clear-building

Exoskeleton Power and Torque Requirements Based on Human Biomechanics · Exoskeleton Power and Torque Requirements ... 6.3 Stair Climbing ... The power requirements for the clear-building

Torque Wrench Using the torque wrench - Clas Ohlson · Conversion table 2. Set the torque wrench to 13 Nm. 2. Set the torque wrench to 62.0 in-lb. 3. Twist the handle to increase

Torque Wrench Using the torque wrench - Clas Ohlson · Conversion table 2. Set the torque wrench to 13 Nm. 2. Set the torque wrench to 62.0 in-lb. 3. Twist the handle to increase

increase MEMORY POWER

increase MEMORY POWER

TPM dynamic / high torque / power

TPM dynamic / high torque / power