IN-HULL TRANSDUCER
Transcript of IN-HULL TRANSDUCER
CPT-S IN-HULL TRANSDUCER
NEW
The CPT-S In-hull transducer provides a simple-to-install depth only transducer solution for non-cored fiberglass hulls. Ideal for sailing, cruising, and small powerboat applications, the CPTS-S In-hull transducer supports CHIRP operation centered on 200kHz. The CPT-S in-hull directly connects to Element S and connects to Axiom RV, Axiom Pro, and Element HV using the A80490 or A80559 adapters, respectively. An innovative transducer tube housing design allows the CPT-S In-Hull to mount in hulls ranging from 0 to 25 degrees deadrise.
www.raymarine.com
SIMPLE TO INSTALLThe CPT-S In-hull is designed for glue-in installation on vessels with non-cored
fiberglass hulls. A cut-to-fit transducer housing allows the transducer to readily
adapt to hulls with deadrise angles between 0° and 25°.
SONAR SOLUTION FOR CRUISERS The CPT-S In-Hull transmits in the High CHIRP band for reliable depth recording,
fish targeting, and bottom density. Pair the CPT-S In-hull with a Raymarine MFD for
general navigation and scouting anchoring locations.
ACCURATE PERFORMANCEIn-hull transducers offer reliable depth performance at cruising-speeds. The CPT-S
In-hull accommodates RIBS, trailer boats, and applications where drilling through
the hull or mounting to the transom is not practical.
The technical and graphical information contained in this brochure, to the best of our knowledge, was correct as it went to press. However, the Raymarine policy of continuous improvement and updating may change product specifications without prior notice. Therefore, unavoidable differences between the product and this brochure may occur from time to time, for which liability cannot be accepted by Raymarine.
Some images in this brochure have been used for illustration purposes only.
CPT-S SPECIFICATIONS
GENERAL FEATURES
Sonar Type CHIRP
Frequency High CHIRP 170 – 230 kHz
Hull compatibility Solid, non-cored fiberglass hull
Deadrise Adjustments 0°, 12° or 20°
Depth Range Up to 600 feet
Cone Angle 25°
MFD COMPATIBILITY
Element Direct connection to Element S. Compatible with Element HV using the A80559 adaptor
Axiom, Axiom+ Direct connection to Axiom 7 DV. Use the A80490 adaptor for connection to Axiom RV and Axiom+ RV
Axiom Pro Use the A80490 adaptor for connection to Axiom Pro S, Axiom Pro RVX and the RVX1000
Other/legacy Direct connection to DownVision variants of aSeries, eS Series, and CP100 Sonar modules
RAYMARINEMARINE HOUSE, CARTWRIGHT DRIVE, SEGENSWORTH, FAREHAM, HAMPSHIRE PO15 5RJ, UNITED KINGDOMT: (+44) (0)1329 246700
6 m (19.69 ft) Cable length
76 mm (2.99 in) Ø
58 m
m (2
.28
in) 0
°
80 m
m (3
.15 in
) 12°
99 m
m (3
.90
in) 2
0°
In-Hull Transducer Tube In-Hull Transducer R-Clip
DIMENSIONS
WHAT’S IN THE BOX
20-1450-MAR / NOVEMBER 2020