Impulse sealer trouble shooting
-
Upload
preppersresources -
Category
Self Improvement
-
view
999 -
download
0
description
Transcript of Impulse sealer trouble shooting
Burnt Teflon cloth
Broken heating
wireWrinkled
sealImperfect
sealBroken
seal
Seal not sealed
through bag
Bag sticking to
sealer
Sealernot
sealing
IMPULSE SEALER TROUBLESHOOTING
Typical sealer issues
Is the power lamp on?
Yes No
Note: not all sealers have a power lamp.
Return to start
Sealer not sealing
Is sealing lamp on when jaw or handle is pressed down?
Yes No
Return to start
Sealer not sealing
Possible cause(s):
Possible solution(s):1. Replace element wire2. Tighten spring hook connections3. Clean the terminals of elements.
1. Heating element wire is broken.2. Loose mounting spring.
Return to start
Sealer not sealing
Possible cause(s):
1. Plug back into electrical outlet2. Replace plug3. Repair cord4. Replace transformer
1. Disconnected plug2. Disconnected power cord3. Bad transformer
Possible solution(s):
Return to start
Sealer not sealing
Possible cause(s):
1. Adjust micro-switch lever2. Reposition micro-switch3. Replace micro-switch
1. Micro-switch de-activated2. Defective microswitch
Possible solution(s):
Return to start
Sealer not sealing
Return to start
Possible cause(s):
1. Replace timer and / or relay2. Replace relay and / or timer3. Decrease amount of heating time
1. Timer malfunction2. Extended heating time by user
Possible solution(s):
Burnt Te!on cloth
Possible cause:
Return to start
1. Replace Te!on strip2. Decrease timer setting
Worn Te!on strip
Possible solution(s):
Broken heating wire
Possible cause(s):
Return to start
1. Lower timer setting2. Increase cooling time (Manual Mode - continue to press upper lever for 1 - 2 seconds after the light goes off)
1. Heating timer set too high.2. Cooling setting too short.
Possible solution(s):
Wrinkled seal
Possible cause(s):
Return to start
1. Replace Te!on strip2. Replace silicone rubber
1. Worn Te!on cover.2. Worn silicone rubber.
Possible solution(s):
Imperfect seal
Possible cause:
Return to start
Decrease timer setting
Sealing time is too long
Possible solution(s):
Broken seal
Possible cause:
Return to start
Increase timer setting
Sealing time is too short
Possible solution:
Seal is not complete
Possible cause:
Return to start
Clean the Te!on cover and silicone rubber
Dirty te!on cloth and dirty sealing bar
Possible solution:
Bag is sticking to sealer