Ages 3+

A. 1 Baby Doll B. 2 Piece Out�tC. 1 Bottle

1

SKUs: 917431, 917448, 917455ADULT SUPERVISION REQUIRED

INTERACTIVE BABY DOLLCONTENTS

D. 1 Plate & SpoonE. 1 Food PacketF. 1 Paci�erG. 1 Diaper

H. 1 Birth Certi�cateI. 1 Potty SeatJ. 1 Slice of Cake with Sensor Light

D.C. G.

I.

F.

E. H.A.

B.

J.

Illustrations are for reference only. Styles may vary from actual contents.

QUICK START

1. Remove the bottle covering and drinking nozzle (Fig. 1).2. Fill the included bottle with fresh, cold water and screw the drinking nozzle on tightly. 3. Tilt the doll back at a slight angle so that the bottle nozzle faces downward. Insert the nozzle deep into her mouth and push

down until you feel resistance (Fig. 2).4. Squeeze the sides of the bottle to feed the doll. NOTE: The doll can drink about 1/3 of the bottle. TIP: If water runs out of her mouth, reposition the nozzle in an upright position and squeeze the sides of the bottle.

Feeding Water:

Fig. 1 Fig. 2

Fig. 3 Fig. 4

Using the Diaper:1. Lay the doll down with her legs extended, and put on the included diaper (Fig. 3). 2. After feeding her with water, press and hold her belly button to make her go potty (Fig. 4)!3. Remove her diaper and let it air dry before using again.

Important Information:• Do not leave the doll in direct sunlight for an extended period of time.• Never put the food packet mixture into the bottle, as it may pour into a tank inside the doll that is not intended for food.• The doll food is made up of a sugar-starch mixture and poses no health hazard if inadvertently consumed. • Do not use after the “best before” date on the food packet.• To prevent the tubes and tanks from blockage, only use the included food packet. • Only use water for bottle feeding. All other liquids may block the tubes and tanks inside the doll.• Do not keep the doll in bath water, salt water or chlorinated pool water for long periods of time as discoloration or bleaching to her skin and/or accessories may occur.• When bathing, use only cold or lukewarm water and mild soap products such as those used for children.• Thoroughly rinse and air dry the doll in a well-ventilated area before storing. • Do not use any cosmetics or skin care products on the doll.

4

© Zapf Creation AG Baby born® is an internationally registered trademark of Zapf Creation AG. Manufactured and distributed under license by MGA Entertainment, Inc.

0320-0-E/INTPrinted In China

MGA Entertainment, Inc.9220 Winnetka Ave. Chatsworth, CA 91311 U.S.A.(800) 222-4685MGA Entertainment UK Ltd.50 Presley Way, Crownhill, Milton Keynes, MK8 0ES, Bucks, UK+ 0800 521 558

MGA Entertainment (Netherlands) B.V.Klipperaak 201, 2411 ND Bodegraven, NL Tel.: +31 (0) 172-758 038E-mail: klantenservice@mgae.comImported by MGA Entertainment Australia Pty LtdSuite 2.02, 32 Delhi RoadMacquarie Park NSW 21131300 059 676

Please keep this manual as it contains important information.

TMMC

‘Let’s care for the environment!’ The wheelie bin symbol indicates that the product must not be disposed of with other household waste. Please use designated collection points or recycling facilities when disposing of the item. Do not treat old batteries as household waste. Take them to a designated recycling facility.

This product contains a Button or Coin Cell Battery. A swallowed Button or Coin Cell Battery can cause internal chemical burns in as little as two hours and lead to death. Dispose of used batteries immediately. Keep new and used batteries away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

WARNING:

IMPORTANT NOTES ABOUT BUTTON BATTERIES- WARNING - KEEP BATTERIES OUT OF REACH OF CHILDREN - Swallowing may lead to serious injury in as little as 2 hours or death, due to

chemical burns and potential perforation of the esophagus. - If you suspect your child has swallowed or inserted a button battery

immediately call the 24-hour Poisons Information Centre on 13 1126 (Australia)/ your local emergency services for fast, expert

advice.- Examine devices and make sure the battery compartment is correctly

secured, e.g. that the screw or other mechanical fastener is tightened. Do not use if compartment is not secure.

- Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous.

- Adults shall tell potential users about the risk of button batteries and keep their children away from button cell. Adult

supervision is required.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.CAUTION: Changes or modi�cations not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communi-cations. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o� and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.- Increase the separation between the equipment

and receiver.- Connect the equipment into an outlet on a circuit

di�erent from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

CAN ICES-3(B) / NMB-3 (B)

SAFE BATTERY USAGE

FCC

• Use alkaline batteries for best performance and longer life.• Use only the battery type recommended for the unit.• Batteries should be replaced only by an adult.• Insert batteries with the correct polarity ( + and – ).• Do not mix old and new batteries.• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.• Do not short-circuit batteries.• When not used for an extended time, remove batteries to prevent possible

leakage and damage to the unit.• Do not mix rechargeable and non-rechargeable batteries.• Rechargeable batteries are to be removed from the toy before charging.• Rechargeable batteries are to be recharged only under adult supervision.• Do not recharge non-rechargeable batteries.• Exhausted batteries are to be removed from the toy.• Do not dispose of batteries in �re as they may leak or explode.

1. Fill the plate up to the mark (12 ml) with water (Fig. 5). 2. Mix in the food packet until all lumps are stirred in and the water has been fully absorbed. The mixture will have a thin consistency. 3. Sit her upright, but tilt her back at an angle. Support her with your arm, and feed her with your other hand using the included spoon (Fig. 6). NOTE: If porridge comes out of the doll’s mouth when feeding, empty the doll by pressing the belly button. Then, try feeding the doll again.

Feeding Porridge:

FILL LINE

Fig. 5 Fig. 6

Fig. 7 Fig. 8

1. Undress the doll, bend her legs, and place her on the potty in the sitting position (Fig. 7). 2. Grip and hold the doll’s belly button with both hands, press down hard, and hold the pressure to make the doll go potty. Keep

the belly button pressed until the doll is completely empty (Fig. 8).

Using the Potty:

1. After feeding with water, grasp the doll with both hands under her arms and press the middle of her chest several times using your fingers or thumbs. She will cry (Figs. 9-10)!

NOTE: If there aren’t enough tears, feed her more water.

Crying:

Fig. 9 Fig. 10

2

1. Move the switch under the cake from OFF to ON (Fig. 11). 2. Press the button to turn on the light. Blow into the small opening on the cake to extinguish the light (Fig. 12).

Cake:

Fig. 11 Fig. 12

OFF ON

BATTERY REPLACEMENT:An adult must install fresh alkaline batteries in your cake should the batteries need replacing. Here’s how:1. Using a Phillips screwdriver (not included), remove the screw and battery compartment cover located under the cake. 2. Install three (3) fresh 1.5V AG13 (LR44) alkaline batteries (not included) making sure the (+) and (-) ends face the proper direction as indicated inside the battery compartment. 3. Replace the compartment cover and tighten the screw.

3 x 1.5VAG13 (LR44) Batteries

3

Cleaning:

1. If the doll gets dirty, wipe with a damp cloth and mild dish soap.External:

Internal:1. After feeding and bathing, �ll the bottle with warm water and mild dish soap.2. Insert the tip of the bottle halfway into the baby’s mouth pointing downward and squeeze the bottle.

NOTE: Inserting the bottle too far will clean the wrong internal tubing. 3. Once the bottle is empty, shake the baby to loosen the remnants inside.4. Place the doll on the potty in sitting position and press and hold the belly button to fully empty out the doll.5. Repeat as necessary. Then, rinse out the doll twice with clear water only. 6. Leave the doll on the potty for at least 15 minutes to ensure she is completely empty.

Your doll can have a bath in the bathtub or be taken to the swimming pool, but do not fully immerse in water (Fig 13).• For bathing, only use cold or lukewarm water and only use

common bath additives suitable for children. • The doll should not be left in the bath, chlorine water or salt

water for more than 1 hour as color deterioration or bleaching may occur. After bathing, clean the doll with fresh water. bathtub sold separately

Fig. 13

Drying:1. Place the doll on her back and move her arms to a vertical position above her head.2. Press her arms several times to remove any water from her arms. Repeat as needed (Fig 14). 3. Position the doll upright. If there is water in the body, it will leak out of the two holes in the doll’s body (Fig. 15). If there is water

in her legs, it will leak out of the two holes in the doll’s feet (Fig. 16).4. Shake the doll to hear any remaining water in the doll’s body, and repeat these steps until all water is removed from the doll.5. Dry the doll and all the joints with a towel. Let the doll air dry in a well-ventilated area until completely dry.

Fig. 14 Fig. 15 Fig. 16

An ADULT must clean the doll.

IMPORTANT: After cleaning with soapy water, repeat the process with a vinegar and water solution.Mix a small amount of regular vinegar with warm water. Then, repeat the cleaning process above. Finally, repeat the cleaning process with clear water at least twice.

Bathing:

WARNING: Constant, competent adult supervision is REQUIRED when children are playing around water.

WARNING: THIS DOLL IS NOT TO BE USED AS A FLOTATION DEVICE.• DO NOT allow children to play in water that is near an electrical source or apparatus.• DO NOT leave the doll near an electrical source or apparatus when wet.• NEVER use any of the included accessories with a real baby!• NEVER shake a real baby!• Please follow all instructions in this manual when playing with the doll in water.• Be sure to clean the doll after going in the water.• DO NOT place the doll in extremely hot or extremely cold water.

SAFETY INSTRUCTIONS

It is absolutely necessary to clean the internal tube system immediately after emptying. See CLEANING.