IRELANDS IMPACT BARS ARE MADE FROM UNIQUE ABRASIONAND IMPACT RESISTANT 60 SHORE NATURAL RUBBER WITH A10MM POLYETHYLENE TOP. THE RUBBER COMPOUND PROVIDES EXCELLENT CUSHIONING AND IMPACT ABSORPTION.

THE 6MM OR 12MM THICK, LOW FRICTION UHMWPE TOPLAYER, PROVIDES A PROTECTIVE SURFACE PREVENTING WEARAND DAMAGE.

EASILY INSTALLED USING THE M16 BOLTS SUPPLIED, THE METALCHANNEL RUNNING THE LENGTH OF EACH IMPACT BAR ENABLES EASY FIXING AND REMOVAL. LONG BOLTS AVAILABLEON REQUEST.

ADVANTAGES

IRELANDSIMPACT BARS

These complete impact cradles not only minimise maintenance by outlasting conventional rollers but they hold the belt in position thereforesignificantly reducing transfer point spillage.

• Bars available ex stock

• Fast delivery to site

• Low price guarantee

• Can supply impact cradles complete or a variety of belt widths.• Spillage significantly reduced therefore less downtime in cleaning

out from under conveyors.

• Unique abrasion and impact resistant qualities of natural rubber

• Cost effective, easy to fit and radiused top edges prevent damage tobelts.

• The belt is supported on a continuous flat surface which not onlyguides it but protects it from gouging by sharp material.

• Equal stress distribution reduces wear and tear on the belt.

STANDARD SIZES

www.irelandsconveyors.com30 CHURCH RD, BALLYNURE, BALLYCLARE, CO. ANTRIM BT39 9UF

Tel: 028 9335 2844 Fax: 028 9334 2382

Width Thickness Length Capping Thickness

100mm 55mm 1240mm 6mm

100mm 75mm 1240mm 6mm

100mm 55mm 1240mm 12mm

100mm 75mm 1240mm 12mm

Data Sheet

White Capping Green Capping

UHMWPE Property Typical Value Typical Value

Grade 1000 Reclaimed 1000

Colour White Green

Specific Gravity 0.94 0.96

Tensile Break (MPa) 22 22

Breaking Strength (MPa) 44 43

Elongation at Break (%) >350 >350

Hardness (Type D) 61 61

Service temperature (C) -60 to 120C -60 to 120C

Volume Resistivity (Ohm cm) >1015 >1015

Surface Resistivity (Ohm) >1013 >1013

Torsional Stiffness (MPa) 250 300

Melting Point (C) 137 139

Thermal coefficient of linear expansion 23-80C (C-1 1/K)

1.7 – 2.5 x 10-4/K 1.7 – 2.5 x 10-4/K

Thermal Conductivity at 23C (W/C x m) 0.42 0.42

Dimensional stability under heat (C) 80 80

Abrasion (Sand-Slurry test) % 80 - 100 110 - 120

IBC Rubber cushion compound

Tensile Strength (MPa) 15.4

Elongation (%) 600

Modulus 300% (MPa) 4.0

Specific Gravity 1.13

Hardness (IRHD) 61

Tear Strength (N/mm) 56

Impact Bars – Green and White Capping

www.irelandsconveyors.com30 CHURCH RD, BALLYNURE, BALLYCLARE, CO. ANTRIM BT39 9UF

Tel: 028 9335 2844 Fax: 028 9334 2382

Additional Requirements: None

IRELANDSAdvanced Conveyor Components