HYDRAULICS / ELECTRO-HYDRAULICS PACK

Part number Description Quantity

SAI9280 Hydraulic rolling table with double face panel 1

SAI9274 Hose support accessory (x2) 1

SAI9261 Hydraulic pump for two workstations 1

SAI9260 Set of drawers with lock 2

SAI9506 HYD-201: Hydraulics level I kit 2

SAI9507 HYD-202: Hydraulics level II kit 2

SAI9508 HYD-203: Electro-hydraulics kit 2

SAIU120-001 SINGLE USE licence for the eLEARNING-200 courses pack 6

SAI2252 autoSIM-200. 1 educational licence 2

SAI7389 Composition poster (HYD-201 - HYD-202 - HYD-203) 1

Composition of the pack:

• Acquire the fundamentals

• Design and simulate the circuits

• Test and operate the real circuits with more than 30 available activities HYD-201

HYD-202HYD-203

x2

SAI73911 double-side workstations

(up to 6 students)

x2

x1

x2

x6

+

+

+

+

+

+

x1

x1

More info:

www.smctraining.com

Complete laboratoryPart number Description Quantity

SAI7391 Hydraulics / Electro-hydraulics pack 4

SAI2254 autoSIM-200. 16 educational licences 1

SAI7390 Hydraulics symbology posters 1

SAI9553 Theoretical concepts manual (English) 1 SAI7392

x16

x1

x1x4

+ + +

List of activities for HYD-201, HYD-202 and HYD-203:

HYDRAULICS

•  Generation of pressure. Characteristics of the pump. •  Velocity regulation. Regulation at the output.

•  Direct action pressure limiting valve. •  Regulation of velocity in extraction.

•  2/2, 3/2, 4/2 distribution valves. •  Non-return valve with release (pilot-controlled).

•  Double-effect cylinder. •  Counter-pressure. Uniform extension of the piston.

•  Antireturn valve. •  Regulation of the input and output flow rate.

•  Flow rate regulation valve. •  Pressure reducing valve.

•  Flow rate regulation valve with pressure compensation. •  Indirectly controlled pressure limiting valve.

•  Adjustable throttle valve with non-return.•  Consecutive control dependent on the pressure (circuit with sequence valves).

•  Resistance to the passage of fluid (loss of load). •  Rapid feed circuit (two velocities).

•  4/3 distribution valve. •  Hydraulic motor.

•  Differential circuit. •  Accumulator.

•  Pressure regulation. •  Circuit with pressure reduction.

•  Velocity regulation. Regulation at the input.•  Velocity regulation. Differences between a throttle and a pres-sure compnsated flow rate compensator.

ELECTRO-HYDRAULICS

•  Controlled cylinder extension and retraction circuit. •  Circuit with pressure switches.

•  Self-retention in an electrohydraulic circuit. •  Mechanical safety.

•  Limit switches. •  Electrical signalling.

•  Progress of an activation with initial conditions. •  Sequential circuit depending on the pressure and travel.

•  Circuit with safety initial conditions and with the possibility of intermediate stoppages at will.

4 double-side workstations

(up to 24 students)