How to strap_a_snowboard_binding
-
Upload
january11499 -
Category
Documents
-
view
197 -
download
0
description
Transcript of How to strap_a_snowboard_binding
How to Strap a Snowboard Binding
By: Grace Quigley
Introduction
Do you know how to bind a snowboard? Well if not I'm going to show you how. Follow these simple steps and I hope you enjoy them!
To Strap a Snowboard Binding You Need:To strap a snowboarding binding you need the following materials. A snowboard, two bindings, and two boots MADE FOR SNOWB0ARDING. Regular boots will not work.
Leash is not needed unless preferred.
First Step
Strapping a snowboard binding is easier than you think. First, place your boot in the center of the binding. Make sure the back of boot is fully in.
Back of the boot should be fully in.
Attach Upper Strap
Next take the upper strap with the cushion attached and bring together with accordion strap. Then push together and they will slide through each other.
Accordion Strap
Cushion Strap
Using The Metal Clamp
On each binding there is a metal or plastic clip. When you pull the accordion and cushion strap together you will need to tighten more. Take the upper part of the metal or plastic clamp and pull backwards until the binding is comfortably tight around the top of your foot.
Metal/Plastic Clamp
Bottom Strap
Now, take the lower strap and do the same except when placing the cushion and accordion strap wrap around the toe of your boot. Plastic or metal clamp should work the same.
This is the toe of the binding
To undo the Binding
To undo the bindings take the bottom of the metal/ plastic clip and pull forward. Same for the bottom binding. The clip should slide easily.
If you have a leash....
If you have a leash (a leash is a cloth strap that connects to your binding and boot that makessure board does not fall off foot) then follow the next steps.
Attach to binding
First, attach the side of the leash without clip and tie around one of the holes in your binding.
attach the tie to end of binding
Clip to your Boot
Clip the metal part of the leash to the shoelace on your boot.
this is where the leash attaches to the shoelace
Just Un-clip
Finally, just un-clip the metal from the shoelace.
Thank you for watching
Thank you for watching my slides and I hope you enjoy them. I hope you learned how to undo a snowboard binding and have fun snowboarding!