How to Read a Map: Notes on Map Analysis Entry #12.
-
Upload
samuel-evan-preston -
Category
Documents
-
view
224 -
download
3
Transcript of How to Read a Map: Notes on Map Analysis Entry #12.
How to Read a Map: Notes on Map Analysis Entry #12
Geologic features on Earth can be identified with the use of aerial photography (from the air), satellite imagery, and topographic maps.
MountainsRiversDeltasLakesFarmlandCoastal Areas
Geologic Features:
High-flying aircraft & satellites high above Earth use sensors & cameras to gather information about Earth’s landforms.
How are maps made?
Computers create images from the data and scientists identify features by shapes and colors on the image.
How are features found?
* Maps using symbols to show elevation of
land.* A view from directly above the land.* Scale, symbols, and contour lines are important terms for understanding these maps.
Topographic Maps
A map is a representation of the Earth, or part of it.
The shape of the Earth's surface is shown by contour lines, imaginary lines that show elevation.
Contour lines make it possible to measure the height of mountains, depths of the ocean bottom, and steepness of slopes.
Topographic Maps
Symbols
Contour lines-
Lines that run parallel on a topo map and show the elevation of the area in the map.
Contour intervals-
How far apart the contour lines are.
To figure this out you must do the following…
Highest #
– Lowest #
the difference between the points
Now do this…..
Difference =
The number of spaces between A&B
What is the contour interval of this map?
•Use various colors of light to snap an aerial photo of Earth.
Usually taken during winter to see many landforms and areas.
Infrared Maps
Red= pine trees, evergreens, winter rye
Bluish-gray=dormant vegetation (oak, hickory, gum, etc)
Light blue = cities or water with much sediment
Dark blue= water with some sediment
Black=water with little sediment, if any
White=sand, exposed rock areas
Infrared Color Key