How to publish your paper in international journals

How to publish your paper in international

journals

Boonsap Witchayangkoon, PhD Executive Editor @ TuEngr.com

The right scientific journals for quality work::

•American Transactions on Engineering & Applied Sciences (ATEAS)

• International Transaction Journal of Engineering, Management, & Applied Sciences & Technologies (ITJEMAST) Focused as eJournals

Dr.Boonsap Witchayangkoon

Originality • Your work must not have been

previously published • Your work must not have been

submitted to other publisher at the same time

• Sign copyright transfer (with emails of all authors)


Publish or Perish • Effective presentation of your work • Write clearly

– Clean & clear writing • Discuss critical aspects • Helps from colleagues to read/check

– One from the same research field – One from other research field


• All submitted manuscripts will be reviewed independently by three individuals who have an understanding and appreciation of the academic peer review process and the respective standards.

• The majority of reviewers must recommend for publication. A successful peer review note is added to the end of the published article.

Peer Review:


Peer Review • Peer-review process (4-10 Weeks) • Editor cannot guarantee the exact

publication time as the process may take longer time, subject to peer-review approval and adjustment of the submitted articles.


Units •SI system of units is preferable.


Figure and Table • All figure and table must be

mentioned in writing, by referring to each figure/table.

• example: –All coefficients in Table 5 are from

simulation. • Do not use "the above Table" or "the

Figure below."


Figure and Table • Use clear graphic • Modern journals – place Figure /

Table near where it is mentioned.


Length of Manuscript

• Shortest is the most preferable. • So be specific/focus on the topic


• The nomenclature section should be inserted between the abstract and the introduction.

• Symbols is listed in alphabetical order within each of the following groups: English group first, then Greek, subscripts, and superscripts. Numbers and other symbols should be listed last.

• If the nomenclature section exists, no need to give definitions scattered throughout the text.

• Acronyms is defined in the text, not in the nomenclature.

Nomenclature and Symbols


References • New up-to-date information should

be used, authors should cite newest references sources as possible.

• Important All references must be mentioned in the writing, and vice versa.

• Make sure all references are correct. • Only references are used, not

bibliography, not footnote. Dr.Boonsap Witchayangkoon

Plagiarism – Ethical Aspects Whole or partial imitation(s) of previous works as your own original works are considered plagiarism, especially through cut and paste process – to have multiple work(s) published in multiple publications when little / no new information / knowledge is added. Author(s) who reuse(s) substantial parts of their own published work without providing the appropriate references is considered self-plagiarism.


Malpractice statement •Plagiarism (& self-plagiarism) is

checked before a manuscript gets published. If plagiarism is detected, the manuscript will be rejected and the author(s) is(are) put on the blacklist.


Malpractice statement • If plagiarism of a published article is found,

Editor or Editorial Board Member(s) will officially contact the authors' institute(s) and funding agencies, informing such academic misconducts.

• Plagiarism note with online (multiple) link(s) to same elsewhere published article(s) or plagiarized material(s) is explicitly displayed. Either clear plagiarism mark(s) will be added to the published article(s) or plagiarized article(s) is(are) retracted.


Editorial Policy • Papers of research reports and articles

with scientific research merit will be judged for publication under careful consideration from international reviewers. Such research reports and articles include those containing substantial supported theories, innovative works, substantial experimental results and/or containing useful and constructive discussions or reviews standardized to regional or international acceptance.


Editorial Policy

• The editor reserves the right to recommend for revision as a condition for final acceptance.

Open-Access E-Journals • Entirely unrestricted access • UK Wellcome Trust:: “the benefits of

research are derived principally from access to research results”

• Free to read / save / distribute


• Unrestricted reuse – Licensees may copy, distribute,

display and perform the work and make derivative works based on it only if they give the author or licensor the credits in the manner specified by these.

Open-Access E-Journals Attribution (by)


Open-Access E-Journals • Quick publication process • Highly reach to wide audiences • Get higher citation rate • Research grant helps paying small

publication fee

ACCEPTANCE VS REJECTION • Carefully read the review result • Accept: “Lucky you for the great job" • Accept with revision: “Let’s do some

minor improvements." • Revise and resubmit: “Your work still

get some attention!" • Reject and resubmit: “The Editor still

want your paper!" Dr.Boonsap Witchayangkoon

Take a chance to learn • Believe in high quality work • Do not fear • Do not panic • No angry: more rejections, more experiences


PUT IN TEMPLATE & TURN IT IN

TuEngr.com

MIT Libraries, USA

Standford University Library, USA

http://owens.mit.edu/sfx_local/az/mit_all?param_perform_save=searchTitle&param_chinese_checkbox_save=0&param_type_save=textSearch&param_type_value=textSearch&param_jumpToPage_value=&param_services2filter_save=getAbstract&param_services2filter_save=getFullTxt&param_pattern_value=International+Transaction+Journal+of+Engineering,+Management,+&+Applied+Sciences+&+Technologies&param_textSearchType_value=exactMatch

http://sul-sfx.stanford.edu:3410/sfxlcl41/az?param_sid_save=3aa6d73d35419c9cf1d11a75e7d173b7&param_chinese_checkbox_type_save=Pinyin&param_lang_save=eng&param_letter_group_save=&param_perform_save=searchTitle&param_letter_group_script_save=&param_chinese_checkbox_save=0&param_services2filter_save=getFullTxt&param_services2filter_save=getSelectedFullTxt&param_current_view_save=table&param_jumpToPage_save=1&param_type_save=textSearch&param_textSearchType_save=contains&param_type_value=textSearch&param_jumpToPage_value=&param_pattern_value=International+Transaction+Journal+of+Engineering,+Management,+&+Applied+Sciences+&+Technologies&param_textSearchType_value=exactMatch&param_starts_with_browse_value=0&param_ui_control_scripts_value=&param_chinese_checkbox_value=0



THANK YOU TuEngr.com

American Transactions on Engineering & Applied

Sciences International Transaction Journal

of Engineering, Management, & Applied Sciences

& Technologies


How to publish your paper in international journals

Technology

Transcript of How to publish your paper in international journals