How to-make-egyptian-coil-bracelet

8
Page 1 of 8 How to make Egyptian Coil This design is adapted from the famous Egyptian coils. Based on the tutorial by Marie Cristine which can be found here. I made it and adapted it to come up with other variations. It is a fun and satisfying project! Here. All you need are just some copper wires to make it. Materials Needed: · 21 gauge (0.7mm) of copper wires · 28 gauge (0.3mm) of copper wires Tools Needed · Wire Cutter · Round nose pliers · Chain-Nose pliers . Measurement tape/ ruler

Transcript of How to-make-egyptian-coil-bracelet

Page 1: How to-make-egyptian-coil-bracelet

Page 1 of 8

How to make Egyptian Coil

This design is adapted from the famous Egyptian coils. Based on the tutorial by Marie Cristine which can be found here. I made it and adapted it to come up with other variations. It is a fun and satisfying project! Here. All you need are just some copper wires to make it. Materials Needed:

· 21 gauge (0.7mm) of copper wires · 28 gauge (0.3mm) of copper wires Tools Needed · Wire Cutter · Round nose pliers · Chain-Nose pliers . Measurement tape/ ruler

Page 2: How to-make-egyptian-coil-bracelet

Page 2 of 8

Cut approximately 15cm of 21ga wires. Make a loop at each end of the wire

Use your pliers to slowly coil the wire at both ends

Page 3: How to-make-egyptian-coil-bracelet

Page 3 of 8

When you are done you should have a piece like this at each end.

The length between the first and second spirals should be around 5.5cm.

Page 4: How to-make-egyptian-coil-bracelet

Page 4 of 8

Then bend it in half by holding your pliers at the middle of the wires between the two spirals.

You should end up with this phallic looking link.

Page 5: How to-make-egyptian-coil-bracelet

Page 5 of 8

Hold your flat nose pliers at the middle of the link and bend it towards the back of the spirals.

This is one single link! Continue to make approximately 24 pieces of this.

Page 6: How to-make-egyptian-coil-bracelet

Page 6 of 8

Now let’s join the single links together. You may open up wires at the back of the link (let’s call it hook) slightly. Place the hook from the second link into the first link.

Then continue to link up the rest until you get your desired length.

Page 7: How to-make-egyptian-coil-bracelet

Page 7 of 8

I will show you how to make beaded clasp for the bracelet tomorrow. So stay tune! Click here to view How to make beaded clasp

Page 8: How to-make-egyptian-coil-bracelet

Page 8 of 8

.

Feel free to distribute the content of the post. Just give us the credit by providing a link back to http://www.handmade-jewelry-club.com/ Find the website useful? You can easily link us using the codes below by just copy and paste them into your blog or website. You can