Horus h36 Reticle Technical Specs
Click here to load reader
-
Upload
iwcdc-bozo -
Category
Documents
-
view
215 -
download
0
Transcript of Horus h36 Reticle Technical Specs
7/23/2019 Horus h36 Reticle Technical Specs
http://slidepdf.com/reader/full/horus-h36-reticle-technical-specs 1/4
Technical Data SheetH36™ Reticle
Horus Vision, LLC 598 San Mateo Ave., San Bruno, CA 94066 650-588-8862 www.HorusVision.co TM
LOW MAGNIFICATION VIEW
Page 1 of 4
+33
+22
+11
+55
+44
-11
-11
-22
-33
-44
-55
-22
-33
-44
-55
200
155
5
100
-22
-44
-55
-33
-11 0
+55
+44
+33
+22
+11
200
155
100 5
0
-44
-55
-22
-33
-11
+33
+22
+11
+55
+44
+55
+44
+11
+22
+33
0
+55
+44
+11
+22
+33
0
-44
-55
-22
-33
-11 0
7/23/2019 Horus h36 Reticle Technical Specs
http://slidepdf.com/reader/full/horus-h36-reticle-technical-specs 2/4
Technical Data SheetH36™ Reticle
Horus Vision, LLC 598 San Mateo Ave., San Bruno, CA 94066 650-588-8862 www.HorusVision.co TM
Page 2 of 4
HIGH MAGNIFICATION VIEW
-11 -11
-22
-33
-44
-55
-22
-33
-44
-55
155
5
100
-22-44-55 -33 -11 0 +55+44+33+22+110
-44-55 -22-33 -11 +33+22+11 +55+44
+11
+22
+33
0
+11
+22
+33
0
7/23/2019 Horus h36 Reticle Technical Specs
http://slidepdf.com/reader/full/horus-h36-reticle-technical-specs 3/4
Technical Data SheetH36™ Reticle
Horus Vision, LLC 598 San Mateo Ave., San Bruno, CA 94066 650-588-8862 www.HorusVision.co TM
Page 3 of 4
SPECIFICATIONS
Dimensions are in inches @ 100 yards.
7/23/2019 Horus h36 Reticle Technical Specs
http://slidepdf.com/reader/full/horus-h36-reticle-technical-specs 4/4
Technical Data SheetH36™ Reticle
Horus Vision, LLC 598 San Mateo Ave., San Bruno, CA 94066 650-588-8862 www.HorusVision.co TM
Page 4 of 4
KEY FEATURES
Spotting reticle for observational measurement, and to aid the rifleman.
Range finder (inverted “L”) calibrated in Shooters Minute of Angle (SMOA). 1 SMOA will subtend/cover exactly 1 inch a
100 yards.
The square grid of the H36 matches the mil grid pattern of most Horus™ reticles. This allows the shooter and the spott
to view a target with the same common frame of reference.
Secondary horizontal lines allow precise elevation holds. The standard spacing between the secondary horizontal lines
is exactly 1 mil.
To compensate for wind, drift, speed of target, etc.: each secondary horizontal stadia line is calibrated with “large hash
marks” spaced exactly 1 mil apart; between each of the large hash marks, there are smaller evenly spaced hash marksthat are exactly 0.2 mils apart.
The Horus reticle is the only reticle that facilitates the rifleman to make an accurate Second Shot Correction™ should h
fail to dispatch the target with his first round. For details, see our Tactical Manual.
Not currently available with an illuminated reticle.
KEY FACTS
Central targeting grid calibrated in USMC mils (6283 mils/circle) (1 mil = 3.60 inches at 100 yards) (10cm at 100 meters
Precise calibration of measurements to within less than 0.5%.