High School Physics Problems

High School Physics Problems

Physics Questions Problem # 1 Do heavier objects fall more slowly than lighter objects? Physics Questions Problem # 2 Why do objects float in liquids denser than themselves? Physics Questions Problem # 3 A particle is moving around in a circle and its position is given in polar coordinates as x = Rcos, and y = Rsin, where R is the radius of the circle, and is in radians. From these equations derive the equation for centripetal acceleration. Physics Questions Problem # 4 How come in free fall you feel weightless even though gravity is pulling down on you? (ignore air resistance when answering this question). Physics Questions Problem # 5 What is the difference between centripetal acceleration and centrifugal force? Physics Questions Problem # 6 What is the difference between energy and power? Physics Questions Problem # 7 Two identical cars collide head on. Each car is traveling at 100 km/h. The impact force on each car is the same as hitting a solid wall at:

(a) 100 km/h

(b) 200 km/h

(c) 150 km/h

(d) 50 km/h Physics Questions Problem # 8 Why is it possible to drive a nail into a piece of wood with a hammer, but it is not possible to push a nail in by hand? Physics Questions Problem # 9 An archer pulls back 0.75 m on a bow which has a stiffness of 200 N/m. The arrow weighs 50 g. What is the velocity of the arrow immediately after release? Physics Questions Problem # 10 When a moving car encounters a patch of ice the brakes are applied. Why is it desirable to keep the wheels rolling on the ice without locking up?Solutions For High School Physics Problems Solution For Problem # 1

No. If an object is heavier the force of gravity is greater, but since it has greater mass the acceleration is the same, so it moves at the same speed (if we neglect air resistance). If we look at Newton's second law, F = ma. The force of gravity is F = mg, where m is the mass of the object and g is the acceleration due to gravity.

Equating, we have mg = ma. Therefore, a = g. If there was no air resistance, a feather would fall at the same speed as an apple. Solution For Problem # 2

If an object were completely immersed in a liquid denser than it, the resulting buoyant force would exceed the weight of the object. This is because the weight of the liquid displaced by the object is greater than the weight of the object (since the liquid is denser). As a result, the object cannot remain completely submerged and it floats. The scientific name for this phenomenon is Archimedes Principle.

Solution For Problem # 3

Without loss of generality, we only need to look at the equation for the x-position, since we know that centripetal acceleration points towards the center of the circle. Thus, when = 0, the second derivative of x with respect to time must be the centripetal acceleration.

The first derivative of x with respect to time t is:

dx/dt = Rsin(d/dt)

The second derivative of x with respect to time t is:

d2x/dt2 = Rcos(d/dt)2Rsin(d2/dt2)

In both of the above equations the chain rule of Calculus is used and by assumption is a function of time. Therefore, can be differentiated with respect to time.

Now, evaluate the second derivative at = 0.

We have,

d2x/dt2 = R(d/dt)2

The term d/dt is usually called the angular velocity, which is the rate of change of the angle . It has units of radians/second.

For convenience we can set w d/dt.

Therefore,

d2x/dt2 = Rw2

This is the well-known form for the centripetal acceleration equation.

Solution For Problem # 4

The reason you feel weightless is because there is no force pushing against you, since you are not in contact with anything. Gravity is pulling equally on all the particles in your body. This creates a sensation where no forces are acting on you and you feel weightless. It would be the same sensation as if you were floating in space.

Solution For Problem # 5

Centripetal acceleration is the acceleration an object experiences as it travels a certain velocity along an arc. The centripetal acceleration points towards the center of the arc.

Centrifugal force is the imaginary force an unrestrained object experiences as it moves around an arc. This force acts opposite to the direction of centripetal acceleration. For example, if a car makes a sharp right turn the passengers would tend to slide in their seats away from the center of the turn, towards the left (if they are not wearing their seat belts, that is). The passengers would feel as if they are experiencing a force. This is defined as centrifugal force.

Solution For Problem # 6

Power is the rate of energy being generated or consumed. For example, if an engine produces 1000 Watts of power (where Watts is Joules/second), then after an hour the total energy produced by the engine is 1000 Joules/second X 3600 seconds = 3,600,000 Joules.

Solution For Problem # 7

The answer is (a).

Since the collision is head on and each car is identical and traveling at the same speed, the force of impact experienced by each car is equal and opposite. This means that the impact is the same as hitting a solid wall at 100 km/h.

Solution For Problem # 8

When you swing a hammer you increase its kinetic energy, so that by the time it strikes the nail it imparts a large force which drives the nail into the wood.

The hammer is basically an energy reservoir to which you are adding energy during the course of the swing, and which is released all at once upon impact. This results in the impact force greatly exceeding the maximum force you can exert by just pushing on the nail.

Solution For Problem # 9

This can be solved using an energy method.

We can solve this by equating the potential energy of the bow to the kinetic energy of the arrow.

The bow can be treated as a type of spring. The potential energy of a spring is:

(1/2)kx2, where k is the stiffness and x is the amount the spring is stretched, or compressed.

Therefore, the potential energy PE of the bow is:

PE = (1/2)(200)(0.75)2 = 56.25 J

The kinetic energy of a particle is:

(1/2)mv2, where m is the mass and v is the velocity.

The arrow can be treated as a particle since it is not rotating upon release.

Therefore, the kinetic energy KE of the arrow is:

KE = (1/2)(0.05)v2

If we assume energy is conserved, then

PE = KE

Solving for the velocity of the arrow v we get

v = 47.4 m/s

Solution For Problem # 10

Static friction is greater than kinetic friction.

Static friction exists if the wheels keep rolling on the ice without locking up, resulting in maximum braking force. However, if the wheels lock up then kinetic friction takes over since there is relative slipping between wheel and ice. This reduces the braking force and the car takes longer to stop.

Anti-lock braking systems (ABS) on a vehicle prevent the wheels from locking up when the brakes are applied, thus minimizing the amount of time it takes for the vehicle to reach a complete stop. Also, by preventing the wheels from locking up you have greater control of the vehicle.

Physics Questions Problem # 1

A crank drive mechanism is illustrated below. A uniform linkage BC of length L connects a flywheel of radius r (rotating about fixed point A) to a piston at C that slides back and forth in a hollow shaft. A variable torque T is applied to the flywheel such that it rotates at a constant angular velocity. Show that for one full rotation of the flywheel, energy is conserved for the entire system; consisting of flywheel, linkage, and piston (assuming no friction).

Note that gravity g is acting downwards, as shown.

Even though energy is conserved for the system, why is it a good idea to make the components of the drive mechanism as light as possible (with the exception of the flywheel)?

INCLUDEPICTURE "http://www.real-world-physics-problems.com/images/physics_questions_1.png" \* MERGEFORMATINET

Physics Questions Problem # 2

An engine uses compression springs to open and close valves, using cams. Given a spring stiffness of 30,000 N/m, and a spring mass of 0.08 kg, what is the maximum engine speed to avoid floating the valves?

During the engine cycle the spring is compressed between 0.5 cm (valve fully closed) and 1.5 cm (valve fully open). Assume the camshaft rotates at the same speed as the engine.

Floating the valves occurs when the engine speed is high enough so that the spring begins to lose contact with the cam when the valve closes. In other words, the spring doesnt extend quickly enough to maintain contact with the cam, when the valve closes.

For simplicity, you may assume that Hookes Law applies to the spring, where the force acting on the spring is proportional to its amount of compression (regardless of dynamic effects).

You may ignore gravity in the calculations.

Physics Questions Problem # 3

An object is traveling in a straight line. Its acceleration is given by

where C is a constant, n is a real number, and t is time.

Find the general equations for the position and velocity of the object as a function of time.

Physics Questions Problem # 4

In archery, when an arrow is released it can oscillate during flight. If we know the location of the center of mass of the arrow (G) and the shape of the arrow at an instant as it oscillates (shown below), we can determine the location of the nodes. The nodes are the stationary points on the arrow as it oscillates.

Using a geometric argument (no equations), determine the location of the nodes.

Assume that the arrow oscillates in the horizontal plane, so that no external forces act on the arrow in the plane of oscillation.