Page 1 of 2Version: 1

For Styrene Graphics - HRGY1. Snap the male and female spacer through all the holes on the graphic.2. Lay out the rail sections, matching segment #’s (1 with 1, 2 with 2, etc.), then screw together connection points,

making sure to leave one side open to allow insertion of graphic. (Quantity of sections varies per model #).3. Installing the graphic in the rail requires at least (2) people. The first person feeds the graphic, easing the

plastic spacers into the extrusion cleanly. The second person should gently pull the graphic along the rail, as the first person continues to feed it.

4. Repeat step 3 for the top rail, and be careful not to tear the graphic.5. Place end caps on to the completed structure.

Halo Straight Rail™ Kit - HRG Series

1. 2.

3. 4.

5.

First person FEEDS graphic

Second person PULLS

First person FEEDS graphic

First person FEEDS

Second person PULLS

First person FEEDS graphic

Plastic male/female spacer

Styrene graphic

Eye hook

1

1

Page 2 of 2Version: 1

For Fabric Graphics - HRGF1. Insert the plastic dowels into the pockets of the graphic, top and bottom2. Lay out the rail sections, matching segment #’s (1 with 1, 2 with 2, etc.), then screw together connection points,

making sure to leave one side open to allow insertion of graphic. (Quantity of sections varies per model #).3. Insert the graphic with dowels into the channel of the bottom rail, and then the top rail.4. Place end caps onto the completed structure.

Halo Straight Rail™ Kit - HRG Series

1. 2.

3.

Plastic dowel

Fabric graphic

Eye hook

1

1

4.