5/21/2018 H834P146

1/2

Techno Linear Motion Catalog 146

This series of Stepper Motor Drivers is to be used with our C Series of Machine Controllers.

Each driver is designed to be used with a particular C Series Machine Controller.

FEATURES

Bipolar and mosfet-based chopper stepper drives

Selectable motor current allows drive to bematched to a wide range of motors.

Full- and half-stepping modes

Built in circuit protection guards against shorts toground or between phases, thermal excess and over

voltage.

C-Se r i e s Step pe r M o to r D r i ve r sEu r o ca r d D IN Com ponen t s

C116

3.624 44V

40.6 mm

HL1100M308020

8 kHz (full step), 10 kHz (half step)

4, 6 or 8 lead (5 lead not suitable)

+5V DC

0C to 35C

70C

C10

2A36V

50.8 mm

110V AC

For Use With Controller

Nominal Output CurrentMotor Supply Voltage

Front Panel Width

Recommended Power Supply

Maximum Stepping Rates

Suitable Motor Types

Input Logic

Operating Temperature Range

Maximum Heat Sink Temperature

Catalog NumberSPECIFICATIONS

HL1100M313202HL1100M313112 HL1100M313302

C142

6A24 70V

71.1 mm

HL1100M308000

http://www.techno-isel.com/search5http://www.techno-isel.com/tech_linearsystem.htm

5/21/2018 H834P146

2/2