Glass Tube Laser Support Center - Glass Tube Laser Support Center Engraver’s “Your Engraving...

1-949-355-4000 1-949-355-4000 1-949-355-4000 INSTALLATION IS EVERYTHING! Full Spectrum Checkmate CAMFive Rabbit BrightStar Jamieson Jamieson Jamieson Thunder Bodor Glass Tube Laser Support Center Engraver’s Engraver’s “Your Engraving Machine Experts” “Your Engraving Machine Experts” “Your Engraving Machine Experts” Full Spectrum Full Spectrum Laser Laser Support Support Center Center Full Spectrum Laser Support Center 1. INSTALLATIONS: 1. INSTALLATIONS: ONSITE & PC-2-PC ONSITE & PC-2-PC 2. SOFTWARE TRAINING 2. SOFTWARE TRAINING a) CorelDRAW a) CorelDRAW b) EngraveLab b) EngraveLab c) XGW c) XGW 3. Tune-ups & Repairs 3. Tune-ups & Repairs 4. Interface Training 4. Interface Training a) LaserCut a) LaserCut b) XM8Draw b) XM8Draw c) LaserWorks c) LaserWorks 5. Leetro & RD Controllers 5. Leetro & RD Controllers 1. INSTALLATIONS: ONSITE & PC-2-PC 2. SOFTWARE TRAINING a) CorelDRAW b) EngraveLab c) XGW 3. Tune-ups & Repairs 4. Interface Training a) LaserCut b) XM8Draw c) LaserWorks 5. Leetro & RD Controllers [email protected]

Upload
others
Category

Documents
view
1
download
0

Embed Size (px):

Transcript of Glass Tube Laser Support Center - Glass Tube Laser Support Center Engraver’s “Your Engraving...

Page 1: Glass Tube Laser Support Center - Glass Tube Laser Support Center Engraver’s “Your Engraving Machine Experts” Full Spectrum Laser Support Center 1. INSTALLATIONS: ONSITE & PC-2-PC

1-949-355-40001-949-355-40001-949-355-4000

INSTALLATION IS EVERYTHING!

Full Spectrum

Checkmate

CAMFive

Rabbit

BrightStar

JamiesonJamiesonJamieson

Thunder Bodor

Glass Tube Laser Support Center

Engraver’sEngraver’s“Your Engraving Machine Experts”“Your Engraving Machine Experts”“Your Engraving Machine Experts”

Full SpectrumFull SpectrumLaser Laser

Support Support CenterCenter

Full SpectrumLaser

Support Center

1. INSTALLATIONS:1. INSTALLATIONS: ONSITE & PC-2-PC ONSITE & PC-2-PC2. SOFTWARE TRAINING2. SOFTWARE TRAINING a) CorelDRAW a) CorelDRAW b) EngraveLab b) EngraveLab c) XGW c) XGW3. Tune-ups & Repairs3. Tune-ups & Repairs4. Interface Training4. Interface Training a) LaserCut a) LaserCut b) XM8Draw b) XM8Draw c) LaserWorks c) LaserWorks5. Leetro & RD Controllers5. Leetro & RD Controllers

1. INSTALLATIONS: ONSITE & PC-2-PC2. SOFTWARE TRAINING a) CorelDRAW b) EngraveLab c) XGW3. Tune-ups & Repairs4. Interface Training a) LaserCut b) XM8Draw c) LaserWorks5. Leetro & RD Controllers

[email protected]