GCC StellarJet 250UV Demonstration Eric Huang March 14, 2006.
-
Upload
sierra-poole -
Category
Documents
-
view
219 -
download
0
Transcript of GCC StellarJet 250UV Demonstration Eric Huang March 14, 2006.
GCC StellarJet 250UVDemonstration
Eric Huang
March 14, 2006
Introduction Flow
• Outlook
• Hardware
• Controller
• RIP
• Printing
Service StationService Station Printing AreaPrinting Area Work StationWork Station
Vacuuming Conveyer System
Extension Roller Table
Media Feed and Take-up Roller
** Work with X motor assembly for media movement
• Media Bar (Front & Rear)• Alignment Bar
• Foot Pedal (Front & Rear)
Rail System
** Work with Y motor assembly for print carriage movement
Print Carriage
• Print Head Module* CMYKLcLm: Xaar XJ500, 360dpi* W: Xaar XJ500, 180 dpi
• Sub Tank
• Head Board and Relay Board
Print Carriage• Auto Media Calibration (AMC™)
– Work with Z motor
UV Lamp Box and Power Supply
• UV Lamp Controller
(Power supply & counter)
Service Station
+/- Pressure System vs. Ink Supply
Positive Pressure Pump
Negative Pressure Pump
Compressor• Control media bar / alignment bar / service station
cover and wiper / cap and cover / media roller / UV Lamp Shutter
Board• Control I/O Board• X/Y-axis card,120 DIO card & PCI card (on IPC)• Carriage Board• Print Engine Board• Valve I/O Board
IPC
LCD Monitor (Firmware Controller)
RIP - ColorPRINT Server Pro (with ICC Profile)