Fy09 Gi Most Freq Cited Manufacturing
Transcript of Fy09 Gi Most Freq Cited Manufacturing
Most Frequently Cited SeriousManufacturing
FY2009
OSHA Federal DataOSHA Federal Data
January 2010January 2010
#1 1910.212 (a)(1)
• Press Brakes• CPL 02-01-025 - CPL
2-1.25 - Guidelines for Point of Operation Guarding of Power Press Brakes
Light Curtains are one method of guarding.
#1 1910.212 (a)(1)
• Lathes• Need a chip guard for
many operations• When jaws extend
past chuck, a guard would be needed.
#1 1910.212 (a)(1)
• Printing presses• They must be
guarded at the in running nip points of the rollers.
#1 1910.212 (a)(1)
• Injection Molding Machine
• Most have interlocked gate as a guarding means.
#1 1910.212 (a)(1)
• Tube Benders• Pressure mats can be
used to avoid the tubes that are being bent.
#1 1910.212 (a)(1)
• Conveyors rotating parts
• The in running nip of the roller fabric and the driver roller can guarded.
#2 1910.1200(e)(1)
• No written hazard communication program
• Must contain a list of hazardous chemicals
#3 1910.1200(h)
• No training employees in the hazards of chemicals
• Signs and symptoms of exposure
• Emergency response• Health hazards
#4 1910.23(c)(1)
• Open sided floors were not guarded.
• Catwalks, mezzaines, and docks could be cited for this.
#5 1910.147(c)(4)(i)
• This is a common item found in many inspection.
• Boilers, conveyors, cutting machines are common items most commonly left out.
#6 1910.151(c)
• No Eye wash
#7 1910.212(a)(3)(ii)
• Cited for unguarded point of operations
• Point of operation is the area on a machine where work is actually performed upon the material being processed.
#7 1910.212(a)(3)(ii)
• Hydraulic Press• Cited under this
standard vs. the 1910.217 which is for MECHANICAL Presses.
• Similar guarding is required.
#7 1910.212(a)(3)(ii)
• Metal Cutting Saws
Unused portion of the blade must be guarded as shown.
#7 1910.212(a)(3)(ii)
• Vertical Bandsaw• Adjustable guard to
height of product• Many injuries by
guiding product into POO
• Handling cold slippery products will increase chances of slipping into POO
#7 1910.212(a)(3)(ii)
• Radial Arm Saws cutting metal
• Lower blade awareness device
• Retracts to original position
• Does not extend past plane of table
• Anti-kick back device
#7 1910.212(a)(3)(ii)
• Shears• Guards must prevent
entry to cutting blade. • This shear have had
its “finger” guards are bent back in violation.
• The slide fails to say that the guard must also prevent access to the hold-downs,
#8 1910.178(L)(1)
• No forklift training
#9 1910.134(e)(1) (NEW)
• No medical evaluation for employees using respirators.
#10 1910.147(c)(1)
• No Written lockout program
Resources
• www.osha.gov• Compliance Assistance Specialists in OSHA
offices• On-site Consultation• Quick Takes
http://www.osha.gov/as/opa/quicktakes• OSHA Quick Cards• Comments or Corrections go to John Newquist• [email protected] 312-353-5977
Paint.lnk