Function Generator Kit

sku: DEV-09002

Replacement: KIT-10015. We now build the kit in-house. This page is for reference only.

Description: This kit from Nuxie includes everything needed to build a function generator capable of producing  sine, triangle and square waves from 25Hz to over 250kHz. An XR2206 IC is used to generate the various waveforms.

Note: This kit requires a ~14V or higher AC or DC 2.1mm center positive wall wart to fully drive the 12V regulator. Any AC or DC wall-wart that outputs 13V or above should work.

Output Waveforms: 5V TTL Square Wave and selectable Sine or Triangle Wave

Output Amplitude: Square Wave: 5Vp-p, Sine/Triangle: 0Vp-p to approximately 6Vp-p.

Output Frequency: 25Hz to over 250kHz using kit components. Can be modified to 0.01Hz to 1MHz.

The amplitude and frequency adjustment pots are mounted on the board for easy adjustment. An ON/OFF switch, Waveform selector switch and Frequency range switch are also mounted on the board.

Kit Includes:

FunGen PCB XR2206 Function Generator IC 74HC04 Hex Inverter IC LM741 Op Amp IC 2.1mm Centre Positive DC Jack 100uF or 10uF Cap 5 - 1uF Cap 2 - 0.1uF Cap 0.22uF Cap 2.2nF Cap 200Ohm Resistor 2 - 1kOhm Resistor 3 - 10kIhm Resistor 1N4001 Diode 3 - Slide Switches 2 - 50kOhm Potentiometer  1 - 250kOhm Potentiometer 7812 Voltage Regulator 78L05 Voltage Regulator 2x Dual Screw Terminal Connectors