Fuel Filter Base - Remove and Install.pdf
-
Upload
victordjchiquecastillo -
Category
Documents
-
view
7 -
download
3
description
Transcript of Fuel Filter Base - Remove and Install.pdf
-
Desarmado y ArmadoC6.4 Engine for Caterpillar Built Machines
Fuel Filter Base - Remove and InstallSMCS - 1262-010
Removal Procedure
Note: Put identification marks on all hoses, on all hose assemblies, and on all harness assemblies forinstallation purposes. Plug all hose assemblies. This helps to prevent fluid loss, and this helps to keep
Cerrar SIS
Pantalla anterior
Producto: EXCAVATORModelo: 320D EXCAVATOR FALConfiguracin: 320D & 320D L Excavators FAL00001-UP (MACHINE)POWERED BY C6.4 Engine
Nmero de medio -KENR8106-05 Fecha de publicacin -01/01/2010 Fecha de actualizacin -06/01/2010
i02742627
Table 1
Required Tools
Tool Part Number Part Description Qty 1 185-3630 Strap Wrench As 1
NOTICEKeep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened component life.
NOTICECare must be taken to ensure that fluids are contained duringperformance of inspection, maintenance, testing, adjusting and repairof the product. Be prepared to collect the fluid with suitable containersbefore opening any compartment or disassembling any componentcontaining fluids.
Refer to Special Publication, NENG2500, "Caterpillar Dealer ServiceTool Catalog" for tools and supplies suitable to collect and containfluids on Caterpillar products.
Dispose of all fluids according to local regulations and mandates.
-
contaminants from entering the system.
1. Disconnect harness assemblies (1) and (2) .
2. Remove bolts (6) and disconnect hose assemblies (7) .
3. Use Tooling (A) in order to remove fuel filter (5). Refer to Operation and Maintenance Manual,"Fuel System Secondary Filter - Replace".
4. Remove bolts (4) and remove fuel filter base (3) .
Installation ProcedureNote: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid.Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on theparts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts forreplacement. Dirt and other contaminants can damage the precision component. Perform assemblyprocedures on a clean work surface. Keep components covered and protected at all times.
Illustration 1 g01374537
-
1. Position fuel filter base (3) and install bolts (4) .
2. Install fuel filter (5). Refer to Operation and Maintenance Manual, "Fuel System Secondary Filter- Replace".
3. Connect hose assemblies (7) and install bolts (6). Tighten bolts (6) to a torque of 30 4 Nm (22 3 lb ft).
4. Connect harness assemblies (2) and (1) .
Illustration 2 g01374537
Copyright 1993 - 2011 Caterpillar Inc.Todos los derechos reservados.Red privada para licenciados del SIS.
Mon Nov 28 21:39:33 EST 2011