FT400 SEAMETRICS
Transcript of FT400 SEAMETRICS
-
8/10/2019 FT400 SEAMETRICS
1/4
GENERAL INFORMATION
The FT400-Series ow computers are microcontroller-based
indicator/transmitters that display ow rate and total and
provide output signals. The FT415 is battery-powered and
provides a scalable pulse output. The FT420 is powered by
external DC voltage and has both pulse and 4-20 mA analog
outputs. When the FT420 is being used in the 4-20 mA mode,
it is a two-wire or loop-powered device, meaning that the
4-20 mA output signal doubles as its power supply.
The addition of a dual-relay output board (FT420 only) allows
for certain applications requiring contact output isolation (e.g.,
certain metering pumps and water treatment controls). Dual
solid state relays provide exactly the same pulse output as the
standard unit, and each can signal one external device. A non-
resettable total is also available. The FT420 can be ordered in
a plastic enclosure with a 115 Vac power supply for use with
mechanical meters, or with a built-in 115 Vac/12-24 Vdc dual
power supply for magmeters.
Both the FT415 and the FT420 can be factory-mounted on the
meter or remotely wall mounted with the brackets provided. The
FT420 is also available as a panel mount with an open back fo
easy installation in the users own electrical enclosure. Most
FT400s can be converted from wall-to-meter or meter-to-wal
mount congurations after installation if needed.
Housings for the wall and meter-mounted models are rugged
cast aluminum, potted and gasketed for maximum environ
mental protection. A membrane keypad allows settings to be
changed without removing the cover. (Password protection, a
standard feature on the FT420, can be used to prevent settings
from being changed.)
FEATURES
Simple SetupBattery (FT415) or Loop Powered (FT420)
Remote or Flow Sensor Mounted Indicator
Rugged Metallic Housing
Non-volatile Memory
APPLICATIONS
Water Treatment
Water Utility
Industrial Chemical Handling
FT400-SERIES
Rate/Total Indicator
FT420
FT415
I I
9 0 0 1 : 2 0 0 8CERTIFIED COMPANYISO
-
8/10/2019 FT400 SEAMETRICS
2/4
Lower Housing
Setup Keys**
Cover Screws
Electronics Module
Wall-Mount Brackets
Strain Relief
Display
FEATURES
FT400-SERIES
Rate/Total Indicator
SPECIFICATIONS*
Lithium "C", 3.6 Vdc, replaceable. Estimated life is3-5 years depending on usage.
6-digit autorange, 1/2" character height
8-digit, 5/16" character height
Scaled Pulse output (0.1 sec duration 6.1 Hz max) (or High Alarm output or Low Alarm output)
Sensor pass-through Pulse output (unscaled)
None
0.1 - 9999999.9 units/pulse
Micropower GMR Sensor (square wave)
1.0 - 150 pulses/second
.001 - 99999.999
.01 - 999999.99
-30 to 65 C (-22 to 148 F)
NEMA 4X, IP66
Power
Display Rate
Total
Outputs Current Sinking Pulse
Analog
Pulse Output Range
Input
Input Range
K-Factor Range
Flow Alarm Output Range
Operating Temperature
Environmental
FT415 FT420
*Specications subject to change Please consult our website for current data (www.seametrics.com).
12-30 Vdc, 4mA (4-20 mA when loop-powered)
6-digit autorange, 1/2" character height
8-digit, 5/16" character height
4-20 mA loop; 24-30 Vdc
0.1 - 9999999.9 units/pulse
5V pulse or contact closure
1.0 - 1,500 pulses/second
.001 - 99999.999
.01 - 999999.99
-30 to 65 C (-22 to 148 F)
NEMA 4X, IP66
**The FT420 includes password protection for tamper preventionwhen needed
FT420 with -27 or -65 Option
-
8/10/2019 FT400 SEAMETRICS
3/4
SET
Electronic
Metering Pump
12-32 VdcLoop Power Supply4-20 mA Device
Analog Output
Scaled Pulse Output
Pulse Pass-Through
Remote Display
or PLC
1 2 3 4
Flow Sensor
Flow Sensor Input
4-20 mA Output
SE
Panel Cutout
R .38 Max, Typ.
3.85 Typ
3.620
+.03/-.00Typ
.70 x .18 Clamp
Area, Typ2.97"
SET
3.93"
4.60"
3.93"
2.06"2341678.9
10.5
FT415/FT420with Wall Mount Brackets
DIMENSIONS
FT400-SERIES
Rate/Total Indicator
FT415/FT420Sensor Mount
FT420PanelMount
POSSIBLE APPLICATIONS
3.00"
.20 Max.
Panel Thickness
1.50
.36
FT420 ONLY
-
8/10/2019 FT400 SEAMETRICS
4/4
Seametrics Incorporated 19026 72nd Avenue South Kent, Washington 98032 USA
(P) 253.872.0284 (F) 253.872.0285 1.800.975.8153 www.seametrics.comLT-65650010-080514
8/5/2014
HOW TO ORDER
MODEL MOUNTING OPTIONS
Wall mount = W
Panel mount = P
Meter mount = See appropriate
meter specifcation to order meter
mounted units.
ACCESSORIES
Built-in 115 Vac/12-24 Vdc dual power supply(FT420W only, use with magmeters) = -27
Tamper-evident = -32
Non-resettable total = -64
Built-in 115 Vac power supply(FT420W only, use with mechanical meters) = -65
Dual relay output (FT420 only) = -98
Battery-powered indicator = FT415
Loop-powered indicator/transmitter = FT420
Data logger (wall mount) = DL76W
Power converter, plug-in, 115 Vac, 24 Vdc = PC3
Dual power supply, plug-in, 115 Vac, 12/24 Vdc = PC42
Protective cover, hinged = 101949
Mounting kit, wall-to-meter conversion = 102632
Mounting kit, meter-to-wall conversion = 102633
LMI pump power cable = 100013
LMI pulse out cable = 100039
FT400-SERIES
Rate/Total Indicator
CONTACT YOUR SUPPLIER