Front Drive Halfshafts - Intermediate Shaft
description
Transcript of Front Drive Halfshafts - Intermediate Shaft
Front Drive Halfshafts - Intermediate Shaft Fusion 2002.75 (06/2002-)
Print Report An Error
Removal and Installation
Materials
Specification
WSD-M2C200-C
Removal
WARNING:Refer to the Material Safety Data Sheets for the Automatic Transmission Fluid E-AW. Failure to follow this instruction may result in personal injury. Certain Transmission and Power Steering fluids supplied to Ford contain additives which may cause skin irritation or other skin
reactions after contact. For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).See - Transmission Fluids.
Installation
All vehicles
Vehicles with manual transaxle
Vehicles with automatic transaxle
Name
Manual transmission fluid
1. Remove the right-hand halfshaft. For additional information, refer to: Front Halfshaft RH (205-04 Front Drive Halfshafts, Removal and Installation).
2. Remove the intermediate shaft center bearing cap.1. Remove and discard the locknuts.2. Detach the heatshield from the bearing cap.3. Remove and discard the center bearing cap.
3. CAUTION:Do not damage the halfshaft oil seal.NOTE:Plug the transaxle to prevent oil loss or dirt ingress.
For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).See - Transmission Fluids. Remove the intermediate shaft.
� Allow the oil to drain into a suitable container. For additional information, refer to: Health and Safety Precautions (100-00 General Information,
Description and Operation).See - Transmission Fluids.
� Slide the heatshield off the intermediate shaft.
1. CAUTION:Do not damage the halfshaft oil seal.Install the intermediate shaft.
� Slide the heatshield onto the intermediate shaft.
2. NOTE:Install a new intermediate shaft center bearing cap and locknuts.Install the intermediate shaft center bearing cap.
1. Install the center bearing cap.
2. Attach the heatshield to the bearing cap.3. Install the locknuts.
3. Install the right-hand halfshaft. For additional information, refer to: Front Halfshaft RH (205-04 Front Drive Halfshafts, Removal and Installation).
4. With the vehicle on the level surface, fill the transaxle with transmission fluid until the oil level is just below the bottom of the filler hole.
5. Check the transmission fluid level and top up with clean automatic transmission oil.
For additional information, refer to: Transmission Fluid Drain and Refill (307-01 Automatic Transmission/Transaxle - Vehicles With: 4-Speed Automatic Transmission (AW81-40), General Procedures).
Page 1 of 1
14.06.2011http://127.0.0.1:8888/wsm/js/procedure.do?variantId=614&proc-uid=G152541&guid...