fourth1st
-
Upload
richurachel -
Category
Documents
-
view
215 -
download
0
Transcript of fourth1st
-
7/29/2019 fourth1st
1/12
U N D E R G U I D A N C E O F P R E S E N T E D B Y
M R . M A R I M U T H U C R I C H U R A C H E L G E O R G E
P R 1 0 E I 2 0 0 8
1
GPRS BASED HEART RATE
MONITORING SYSTEM
-
7/29/2019 fourth1st
2/12
OBJECTIVE2
Real time monitoring of heart rate and display thesignal on an LCD
Alert the doctor if there is any abnormality is
present, using GPRS module
-
7/29/2019 fourth1st
3/12
BLOCK DIAGRAM3
ECGELECTRODES
ECGAMPLIFIER
& FILTER LPC2378
LCD(128*64)
GPRS
ADC
-
7/29/2019 fourth1st
4/12
Fan Aihua, Bian Chunhua, Ning Xinbao, He Aijun, Zhuang Jianjun
Portable electrocardiogram monitor based on ARMInformation Technology and Applications in Biomedicine, 2008.ITAB 2008. International Conference on , pp:481 - 483 ,30-31
May 20084
Uses an AT91SAM7S64 arm7 processor to monitorreal time ECG ,record data, displays the wave andsends out alarm when exception is detected usingRF module.
Arm7 has real-time timer is used for updating thecurrent date and time and timer (TC0) is used for
timing trigger The data analysis is according to three variables:
the RR interval, the QRS wave width and averagevalueRR of 8 RR Intervals
-
7/29/2019 fourth1st
5/12
Cont..5
Block diagram
Software section consist of acquisition fromadc,display the ecg wave,data transfer tophone,data storage on sd card,data analysis and
alarm,updating current time
-
7/29/2019 fourth1st
6/12
Lihuang She1, Jinshuan Zhao1, Shi Zhang1, Guohua Wang1, Gang Wang1
A Novel Portable One Lead ECG Monitor with Low-Cost and
Long-Time Recording Based on NUC501, 2010 Chinese Control and Decision Conference,pp:276-279
a portable low-cost long- time one lead Electrocardiogram (ECG)
Monitor is present, which is powered by one dry battery and
based on NUC501.
Software has two important parts: front data processing and fast
algorithm for R wave
In front end processing digital filter is chosen to remove
interference noise.
To detect r wave we use differential threshold method, which is
based on detecting ECG signal amplitude and slope.
-
7/29/2019 fourth1st
7/12
V Thulasi Bai1 and S K Srivatsa,Design and implementation of mobile tele cardiac system,Journal of scientific & industrial research,vol. 67 ,pp:1059-1063 , october 2008
7
ECG is continuously monitored and details arewirelessly loaded into external memory of armprocessor using Bluetooth technology.
RR interval of QRS wave is used to find heart rate in
bpm For normal person this interval is 600-1000.
If bpm is found less than 60 then it is bradycardia, ifit is above 100 then it is tachycardia
If exception is found then it declares panic conditionand sends a 1 min sample of ECG using GSM/GPRSmodule.
-
7/29/2019 fourth1st
8/12
Work done8
Ecg waveform acquired
F=1.041 Hz
Vpp=1.44V
-
7/29/2019 fourth1st
9/12
WORK DONE9
Done adc in lpc2378
Plot adc output on 128*64 pixel graphic Lcd
Interfaced sim900 module with lpc2378
-
7/29/2019 fourth1st
10/12
Graphic lcd10
Flow chart for initilization and display of lcd
-
7/29/2019 fourth1st
11/12
Work to be done11
Find number of heart beats from ECG usingmicrocontroller
Send data using GPRS module if abnormality occurs
-
7/29/2019 fourth1st
12/12
Thank you
12