Formula 1

34

description

 

Transcript of Formula 1

Page 1: Formula 1
Page 2: Formula 1

Content:---

• Introduction

• Types of Racing

• Engines

• Transmission

• Aerodynamics

• Construction

• Steering Wheel

Page 3: Formula 1

• Fuel

• Tyres & Brakes

• Performance

• Acceleration

• Mechanics

• Formula-1 in INDIA

Page 4: Formula 1

IntroductioIntroductionn

Formula-1 is the one of the best race in the world.Formula-1 is the one of the best race in the world.The cars are burning the roads, to give perfect The cars are burning the roads, to give perfect Performance. It is very popular in European nations.Performance. It is very popular in European nations.All American so an motor companies are gathering together All American so an motor companies are gathering together To give people an enjoy of V-engine sound and DrivingTo give people an enjoy of V-engine sound and DrivingTechniques.Techniques.It is so thrilling, surprising and costly.It is so thrilling, surprising and costly.

Page 5: Formula 1

Types of Racing

Formula-1 WRC

A1GP Trans-Orientale

Formula-2 Muscle Car Racing

Formula-DRIFT GO-Carting

D1GP

NASCAR Racing

HUMMER Rally

DRAG Racing

Page 6: Formula 1

Cortesía de Volvo Bil Polanco

`Massa Räikkönen

Page 7: Formula 1

Cortesía de Volvo Bil Polanco

Fisichela Kovalainen

Page 8: Formula 1

Cortesía de Volvo Bil Polanco

Rosberg Wurz

Page 9: Formula 1

Cortesía de Volvo Bil Polanco

R.Schumacher Trulli

Page 10: Formula 1

Cortesía de Volvo Bil Polanco

Button Barrichelo

Page 11: Formula 1

Cortesía de Volvo Bil Polanco

Sato Davidson

Page 12: Formula 1

Cortesía de Volvo Bil Polanco

Alonso Hamiltonn

Page 13: Formula 1

Cortesía de Volvo Bil Polanco

Engines• For a decade F1 cars had run with 3.0 litre normally-aspirated V10

engines, but in an attempt to slow the cars down, the FIA mandated that as of the 2006 season the cars must be powered by 2.4 litre naturally-aspirated engines in the V8 configuration that have no more than four valves per cylinder.

• As of the start of the 2006 season most engines on the grid rev up to 19,000 rpm. The new 2.4L V8 engines are reported to develop between 720 hp and 750 hp.

Page 14: Formula 1

Cortesía de Volvo Bil Polanco

• The engines produce over 100,000 BTU per minute of heat that must be dumped, usually to the atmosphere via radiators and the exhaust, which can reach temperatures over 1,000 degrees Celsius. They consume around 650 litres of air per second. Race fuel consumption rate is normally around 75 litres per 100 kilometres travelled.

• As of the 2006 Chinese Grand Prix all development of engines will be frozen until 2009, meaning that the teams will use engines of the same spec for the next two seasons. The end of the engine freeze has been suggested to be the beginning of bio-fuel.

Page 15: Formula 1

Cortesía de Volvo Bil Polanco

Transmission• Formula One cars use semi-automatic sequential gearboxes with six or

seven forward gears and one reverse gear. The driver initiates gear changes using paddles mounted on the back of the steering wheel and electro-hydraulics perform the actual change as well as throttle control.

• The new seamless shift gearbox, eliminate the split-second loss of drive during a gear change. The ultimate advantage of this is said to be from five to ten seconds over a complete race distance, which is a significant gain when races are sometimes only won by three or less seconds.

Page 16: Formula 1

Cortesía de Volvo Bil Polanco

Aerodynamics• The cars' aerodynamics are designed to provide maximum downforce

with a minimum of drag; every part of the bodywork is designed with this aim in mind.

• F1 car produces much more downforce than any other open-wheel formula; for example the Indycars produce downforce equal to their weight at 190 km/h, while an F1 car achieves the same downforce at 130 km/h.

Page 17: Formula 1

Cortesía de Volvo Bil Polanco

ConstructionThe cars are constructed from composites of carbon fibre and similar ultra-lightweight (and incredibly expensive to manufacture) materials.The minimum weight permissible is 605 kg including the driver, fluids and on-board cameras. However, all F1 cars weigh some as little as 440 kg., so teams add ballast to the cars to bring them up to the minimum legal weight. The advantage of using ballast is that it can be placed anywhere in the car to provide ideal weight

distribution

Page 18: Formula 1

Cortesía de Volvo Bil Polanco

Steering wheel• The wheel can be used to alter traction control settings, change gears, apply rev

limiter, adjust fuel air mix, change brake pressure and call the radio. Data such as rpm, laptimes, speed and gear is displayed on an LCD screen.

• The wheel alone can cost about $40,000, and with carbon fibre construction, weighs in at 1.3 kilograms.

Page 19: Formula 1

Cortesía de Volvo Bil Polanco

Fuel• Formula One fuel cannot contain compounds that are not found in

commercial gasoline. Blends are tuned for maximum performance in given weather conditions or different circuits.

• To make sure that the teams and fuel suppliers aren't violating the fuel regulations, the FIA requires Elf, Shell, Mobil, and the other fuel teams to submit a sample of the fuel they are providing for a race. At any time, FIA inspectors can request a sample from the fueling rig to compare the "fingerprint" of what is in the car during the race with what was submitted.

Page 20: Formula 1

Cortesía de Volvo Bil Polanco

Tyres & Brakes• By regulation, the tyres feature a minimum of four grooves in them, with the intention of

slowing the cars down. They can be no wider than 355 mm and 380 mm at the front and rear respectively. A tyre is built to last just one race distance, a little over 300 km.

• These brakes are designed and manufactured to work in extreme temperatures, up to 1,000 degrees Celsius. The driver can control brake force distribution fore and aft to compensate for changes in track conditions.

• An average F1 car can decelerate from 100-0 km/h in about 17 metres. Usual braking forces for an F1 car are 4.5 g to 5.5 g when braking from 300 km/h.

Page 21: Formula 1

Cortesía de Volvo Bil Polanco

Performance• Every F1 car on the grid is capable of going from nought to 160 km/h and back to nought in

less than five seconds. Grand Prix cars can negotiate corners at significantly higher speeds than other racing cars because of the intense levels of grip and downforce.

• Cornering speed is so high that Formula One drivers have strength training routines just for the neck muscles. The combination of light weight (605 kg), power (950 bhp), aerodynamics, and ultra-high performance tyres is what gives the F1 car its performance figures.

• The principal consideration for F1 designers is acceleration, and not simply top speed.

Page 22: Formula 1

Cortesía de Volvo Bil Polanco

Forward acceleration

• 0 to 100 km/h: 1.9 seconds

• 0 to 200 km/h: 3.9 seconds

• 0 to 300 km/h: 8.4 seconds

The acceleration figure is usually

1.4 g up to 200 km/h, which

means the driver is pushed back

in the seat with 1.4 times his

bodyweight.

Page 23: Formula 1

Cortesía de Volvo Bil Polanco

Deceleration• The carbon brakes in combination with the aerodynamics produces

truly remarkable braking forces.

• The deceleration force under braking is usually 4 g, and can be as high as 5-6 g. The drivers also utilise 'engine braking' by downshifting rapidly.

• As a result of these high braking forces, an F1 car can come to a complete stop from 300 km/h in less than 3.5 seconds.

Page 24: Formula 1

Cortesía de Volvo Bil Polanco

Turning acceleration• An F1 car is designed principally for high-speed cornering, thus the

aerodynamic elements can produce as much as three times the car's weight in downforce, an F1 car to corner at amazing speeds, seeming to defy the laws of physics.

• As an example of the extreme cornering speeds, the Blanchimont and Eau Rouge corners at Spa-Francorchamps are taken flat-out at above 300 km/h.

Page 25: Formula 1

Cortesía de Volvo Bil Polanco

Top Speeds

• Top speeds are in practice limited by the longest straight at the track and by the need to balance the car's aerodynamic configuration between high straight line speed (low downforce) and high cornering speed (high downforce) to achieve the fastest lap time.

• The top recorded speed on track was 372 km/h at Monza in 2005.

Page 26: Formula 1

Cortesía de Volvo Bil Polanco

COMPORTAMIENTO DEL CARRO

Page 27: Formula 1

                                            

Full name Force India Formula One

Base Silverstone, Northamptonshire, United Kingdom

Team principal/s Colin Kolles (Germany)

Chief Technical Officer

Mike Gascoyne (U.K.)

Technical director

James Key (U.K.)

Race drivers Adrian Sutil (Germany)Giancarlo Fisichella (France)

Test drivers .Vitantonio Liuzzi (France)

Chassis Force India VJM-01

Engine Ferrari

Tyres Bridgestone

Page 28: Formula 1

Force India will use the VJM-01 chassis, an updated version of the previous year's Spyker car for the first part of the 2008 season. The team will be using customer Ferrari engines in 2008 with the team's existing deal with Ferrari running to 2010. The team will also be using the Indian flag in its team logo from 2008.

Page 29: Formula 1

FORCE INDIA

Page 30: Formula 1
Page 31: Formula 1
Page 32: Formula 1
Page 33: Formula 1
Page 34: Formula 1