Floral Shoppe – Four Card Set w/ Die Cut Paper Flowers sheets... · “Earth laughs in Flowers”...

www.g45papers.com | [email protected] pg 1 of 6

Floral Shoppe – Four Card Set w/ Die Cut Paper Flowers

G45 Project Featuring : Floral Shoppe

Designed by ~ Maggi Harding Graphic 45® Supplies:1 sheet Midnight Medley (4501689) 1 sheet Sunlit Medley (4501690) 1 sheet Burgundy Blossoms (4501691) 2 sheets Verdant Blossoms (4501692) 1 sheet Pink Lilies (4501693) 1 sheet Indigo Lilies (4501694) 1 sheet Golden Serenity (4501696) 1 pack Floral Shoppe Tags & Pockets (4501699) 5 each Staples ATC Tags – Ivory (4500846) 1 each* Large Tag, ATC Tag & Flower Dies (4501687)

Additional Supplies: 30” Ivory 5 ⁄8” seam binding ribbon (600-58-09) 10” Ivory ¼” satin ribbon w/ center band (337-14-09) 6” Navy/gold 1 ⁄8” solid colored edge ribbon (340-03) 4” Natural 5 ⁄8” faux canvas ribbon (444-58-02)

Tools, Adhesives & Ink: Paper trimmer, scissors, ruler, bone folder, scoring tool, wet or dry adhesive, strong adhesive to glue flowers, dimensional foam adhesive, ¼” Scor-tape

Floral Shoppe – Four Card Set

Directions: 1. From Indigo Lilies cut pieces as follows:

4¼” x 11”, 4¼” x 5½”, 3¼” x 4¼” -B-side.•Card 1•

Notes: • Plain flowers are designated as large, medium, small, and tiny. • Embossed flowers are designated as small embossed flower and large embossed flower. • Leaves are designated as leafy branch, stemmed leaves, small leaf and large leaf. • A Bonus Envelope tutorial is available on the last page. See final note when printing the PDF template.

2. Score the 4¼” x 11” card base piece at 2¾” and at 5½” and fold as

shown in the photo. Be sure the words read from top to bottom.

3. Glue the top B-side of the card base flap created with the 2¾” score line to the B-side of the 4¼” x 5½” piece as shown. The part that is standing up in the

photo is the front of the card that creates the easel.

4. Cut a 3¾” x 5” piece from Sunlit Medley B-side, center and adhere to the front of the card. Next center and glue the 3¼” x 4¼” piece of Indigo Lilies.

5. Locate the pocket shown in the photo in the Tags & Pockets, assemble and adhere to the front of the card about 2” from the top and centering from side to side.

6. Die cut a tiny, small and medium flower from Verdant Blossoms B-side and from Indigo Lilies B-side. Give the

flowers a slight twist with tweezers or pinch the petals to give the flowers a little dimension. Stack and glue the flowers on top of each other and glue to the front of the card along with 3 die cut leaves from Midnight Medley B-side, as shown in step 5.

7. Die cut an ATC tag from Verdant Blossoms B-side

and adhere to an ivory ATC tag. Thread a 4” piece of

grosgrain ribbon through the tag, then tie a bow

around the grosgrain ribbon as shown with a 6” piece of narrow navy ribbon. Insert the tag in the pocket on the

front of the card.

8. Cut a ¾” x 4¼” piece from Indigo Lilies and adhere inside the card, about 1” from the bottom. Locate the “Take Time to Smell the Flowers” tag and pop up with foam tape, centering on the band as shown.

You're all finished with the first card!




•Card 2•

1. From Verdant Blossoms cut the five

following pieces: A-side : 8½” x 5½” & two 3¾” x 5” (set one aside for step 7). B-side : 3¼” x 4½” & 4” x 5¼”. Score the 8½” x 5½” piece at 4¼”. Fold at the score

line with the pink B-side to the inside. Align the

card so that it opens from right to left. Adhere the 4” x 5¼” pink B-side piece

to the front of the card centering, then adhere the 3¾” x 5” A-side piece, centering on the card front.

2. Adhere foam tape to three sides of the 3¼” x 4½” piece and adhere so the open side is on the right side of the card forming a pocket.

3. Die cut an ATC tag from Verdant Blossoms and

adhere to an ivory ATC tag. Cut a 6” and 24” piece of

ivory seam binding. Form a 3 loop bow with the long piece

and use the 6” piece to tiethe loops to the top of the tag.

4. Remove the “Beautiful Dreamer” tag from the Tags &

Pockets and adhere to the front of the card

about ¾” from the bottom and left side.

5. Die cut from Golden Serenity 1 large, medium, small, and tiny flower and 1 large embossed flower. Die cut from Verdant Blossoms 2 large embossed flowers, 1 each medium, small and tiny flowers. Pinch the petals on each blossom or twist with tweezers to give each bloom body and

dimension. Stack and adhere all the Golden Serenity flowers on top of each other beginning with the largest bloom on the bottom. Top with the tiny bloom from Verdant Blossoms. Stack the flowers from Verdant Blossoms, alternating A and B-side beginning with the pink B-side on the bottom. Top with the tiny flower from Golden Serenity. Die cut 2 leafy branches from Midnight Medley B-side and adhere the branches and flowers as shown in the photo.

6. Take the 3¾” x 5” piece of Verdant Blossoms from




step one and adhere inside the card, on the left side. Cut a ½” x 4¼” strip from Verdant Blossoms and adhere on the right side about ¾” from the bottom. Die cut a small flower from Golden Serenity. Die cut from Verdant Blossoms a medium embossed flower (B-side) and a large flower. Stack the flowers and adhere inside the card as shown in the previous image.

7. Insert the ATC

tag into the side pocket

formed in step 2 and you are all

finished with the second

card!

•Card 3•

1. Cut the following

pieces from the B-side of

Pink Lilies: 5½” x 8½”,

5¼” x 4”, 3¾” x 2½”, and ⅝”

x 4¼”. Cut a piece 5” x 3¾”

from Sunlit Medley. Score the 5½” x 8½” card base at 4¼” and fold in half. Orient the card so that it opens from bottom to top and adhere the 5” x 3¾” piece from Sunlit Medley

to the front, centering.

2. Adhere the 3¾” x 2½” Pink Lilies B-side over the Sunlit Medley piece, about ½” from the top and the left side.

3. Apply ¾” of adhesive to either side of the Pink Lilies ⅝” x 4¼” strip as shown.

4. Adhere the strip

from step 3 to the card front about

1½” from the left side as

shown in the photo. Locate

and remove the “Bloom

& Grow” tag from

the Tags and Pockets. Adhere to the pink strip about 1⅜” from the bottom being careful not to adhere to

anything but the vertical strip. We’ll be slipping a tag underneath the strip.

5. Die cut an ATC tag from Verdant Blossoms and adhere to an Ivory ATC Tag. Die cut from the Verdant Blossoms a large flower, a medium flower, a tiny flower,and a small embossed flower. Die cut two stemmed leaves from Midnight Medley. Pinch the blossom petals to add a little body. Adhere to each other, stacking from the bottom largest bloom

to the smallest, alternating the patterns. Adhere the flower and the leaves over the tag grommet as shown.




6. Adhere the 5¼” x 4” Pink Lilies B-side piece to the inside bottom of the card centering from side to side. Die cut a small flower, a small embossed flower, and 2 tiny flowers from Verdant Blossoms and adhere in the left upper corner. Die cut 2 small leaves from Midnight Medley and tuck under the flowers. Card 3 is now finished!

•Card 4•

1. Cut a 5½” x 8½” piece from Midnight Medley for the card base. Score at 4¼” and fold in half on the score line. The card will open from bottom with the B-side on outside.

2. Cut a piece from Sunlit Medley

5¼” x 4”. Center and adhere to the front of the card. Cut a piece from

Midnight Medley 5” x 3½”. Tear the

paper in half along

the diagonal as shown in the photo. Adhere to bottom torn piece to the bottom right corner.

3. Punch out the “Love” tag from the Tags & Pockets and adhere to the right side as shown using dimensional foam tape or squares. Die cut 2 small flowers and 1 small embossed flower from Indigo Lilies B-side and 3 tiny flowers from the A-side. Die cut 2 stemmed leaves from Midnight Medley B-side. Layer one tiny flower over each of the larger flower. Tuck and adhere the largest flower slightly underneath the tag and adhere the stemmed leaves and other two flowers so that they slightly overlap the tag as shown.

4. Die cut two ATC tags from Indigo Lilies, one from the A-side and the other from the B-side. Adhere each to an Ivory ATC Tag. For the A-side tag, mat the “Let Love Grow” tag from the Tags & Pockets with a 1⅜” x 1⅞” piece cut from Midnight Medley B-side and adhere to the center of the ATC tag. For the yellow tag, mat the “Earth laughs in Flowers” tag from the Tags & Pockets with a 2” x 1⅜”piece cut from Midnight Medley B-side and adhere to the center of the ATC tag. Cut two 5” pieces of ivory ribbon and tie one to each tag with a square knot.




5. Cut a piece 5¼” x 4” from Indigo Lilies. Adhere to the inside bottom of the card with the B-side up. Cut a ¾” x 12” piece from Burgundy Blossoms B-side and a ½” x 12” piece from Sunlit Medley B-side. Adhere the two pieces together and then cut two pieces, each 5½” in length. Adhere to the inside top and inside bottom,

about ⅝” from the paper’s edge as shown in the photo. Punch out the “Friends” tag from the Tags & Pockets and adhere about ⅜” from the bottom left side as shown.

6. Cut a

5¼”x 4 piece from Sunlit Medley and

adhere to the back of

the card. All Finished!

Bonus: Coordinating Envelopes Supplies & Directions:1 sheet for each envelope Floral Shoppe 12” x 12”

1. Select a piece of Graphic 45 Floral Shoppe paper that is at least 8½” x 8½” and that coordinates with your card. Trace the template onto your paper and cut out. Score where indicated by the black lines on the template.

2. Ink the edges of the envelope if desired. Fold

the envelope up following the score lines and apply ¼” Scor-tape as shown in

the photo.

3. Fold the flaps onto the Scor-tape and burnish to ensure a good seal. Place your card in the envelope and seal. And that’s it!

*Note: When printing off the envelope template PDF be sure to print it at actual size and use borderless printing. The cut out envelope should measure 8½” x 8½”, if otherwise, the cards will not fit the envelope.




Floral Shoppe – Four Card Set w/ Die Cut Paper Flowers sheets... · “Earth laughs in Flowers”...

Documents

Transcript of Floral Shoppe – Four Card Set w/ Die Cut Paper Flowers sheets... · “Earth laughs in Flowers”...